The overall noise figure of an AM receiver with an RF amplifier, mixer, and AF amplifier is 60. The noise factor of the mixer is 20 and the power gain is 30, whereas the noise factor and power gain of the AF amplifier are 30 and 50, respectively. What is the RF amplifier's noise factor if the power gain is 50? Select your answer. 59.6 dB 47.75 dBµ 17.75 dB 77.75 dBm

The overall noise figure of an AM receiver with an RF amplifier, mixer, and AF amplifier is 60. The noise factor of the mixer is 20 and the power gain is 30, whereas the noise factor and power gain of the AF amplifier are 30 and 50, respectively. What is the RF amplifier's noise factor if the power gain is 50? Select your answer. 59.6 dB 47.75 dBµ 17.75 dB 77.75 dBm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1) From the plots, what is the frequency of the input signal (in samples as well as radians)? 2) From the plots, what is the frequency of the output signal (in samples and radians)? 3) What does echo do to the magnitude and phase spectra?
None
2-What is the maximum allowed frequency of the input information signal (modulator) in an AM system (DSB-LC) which has a bandwidth of 40kHz and a carrier frequency of 500kHz
Q.2:- a) Explain what a band-pass filter is, and how it differs from either a low-pass or a high-pass filter circuit. Also, explain what a hand-stop filter is, and draw Bode plots representative of both band-pass and band-stop filter types. b) What is the purpose (ll) of the parity bit during data transmission?
What is the bandwidth of a PCM signal encoded using 8 bits if the bandwidth of the analog signal =8K Hz
A receiver is invented by US engineer Edwin Armstrong, which it converts high frequency to low frequency, all processing takes place at lower frequencies. It offers superior sensitivity, frequency stability and selectivity. With neat block diagram and explain each blocks.
produce a simulink model of FM demodulator.
1. What is the advantage of angle modulation for (noise and interference), the bandwidth of transmission and the average power of the transmission? comparison with the amplitude modulation
An amplifier has a spectrally pure sine-wave input of 50 mV. It has a voltage gain of 60. A spectrum analyzer shows harmonics of 0.035 V, 0.027 V, 0.019 V, 0.011 V, and 0.005 V. Calculate the total harmonic distortion (THD) and the relative harmonic distortion.
4. A receiver has 2 uncoupled tuned circuit before the mixer, each with a Q of 75. The signal frequency is 100.1 MHz. The IF is 10.7 MHz. The local oscillator uses high-side injection. Calculate the image rejection ratio in dB.
1) How can I calculate cutoff frequency, resonance frequency, bandwidth in a filter? 2) What is their formulas?
b. What is the channel capacity for signal power of 250 W, noise power of 50 W, and bandwidth of 3 MHz? c. What is the channel capacity when the S/N ratio is doubled but the bandwidth is reduced by a factor of 5?