the output of a shunt generator is 25 kw at the terminal voltage of 200V. the armature resistance is 0.05 omhs and the shunt field resistance is 50 omhs. if the SPL is equal to 20% of cupper losses at this load, calculate the SPL in watts

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A:

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A: 13. Given data, Terminal voltage V = 200 V Field resistance Rf=200 Ω

Q: To change the direction of rotation of a series wound DC generator the general rule is to

A: To change the direction of rotation of a series wound DC generator  Note: we always change the…

Q: In DC generators, lap winding is suitable for ) high voltage, high current low voltage, high current…

A:

Q: The RMS value of current, if the value of armature current is 13 A, a = 53 degrees, and B = 159…

A: We need to calculate RMS value of given wave , we will use RMS formula.

Q: Can you explain the given questions in an original way? Factors Affecting Electrical Energy in DC…

A: Electrical machines can be either generator, transformers, or motors. They can be either Ac machines…

Q: i need  theory about Characteristic of Separately excited Generator

A: To write the characteristics of separately excited Generator

Q: True or False: In a DC Machine, the field windings can only be found at the Stator

A: In DC motor the field winding is on the stator of the motor and the armature winding is on the rptpr…

Q: The generated voltage per phase of an alternator is E0 while the speed of rotor rotation is 3000…

A: We will establish the relation between the generated voltage and the speed of the alternator.

Q: If we need to use a DC generator witha very good voltage regulation we choose: * DC Generators…

A:

Q: In generator, the generated e.m.f will increase with the load. separately excited dc generator self…

A: In this question we need to choose a correct option.

Q: A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the…

A: First option is correct. The explanation is provided below.

Q: The type generator field winding is supplied from the external D.C. source. O Shunt O Self excited o…

A: Seld excited generator does not require addtional power DC supply.

Q: block diagram fro dc motor refrigerator

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: In a DC machine, the reversal of currentrom one direction to opposite direction is done by O…

A: In this we will write about reversal of current in dc machine....

Q: A 6-pole lap wound generator has 900 conductors. The e.mf induced per one tur being 3 V. the…

A: Given lap connected , So, No. of poles = No. of parallel paths = 6 Given voltage per turn = 3 volts…

Q: A long shunt d.c. compound generator delivers 110 kW at 220 V. If r = 0.01 ohm, r = 0.002 ohm, and…

A: We have been given an long shunt dc compound generator as shown in figure.  Given data, Voltage (V)…

Q: A 6 pole DC wave wound generator has 34 armature conductors with flux per pole is 29 m speed of the…

A:

Q: In long shunt DC generator Series field winding current Ise is equal to

A: -The circuit diagram for long shunt DC generator is given below:

Q: 8A (L 2A

A: In source transformation, one source works at a time. When 8 A is OC , 9 ohm and 3 ohm resistors…

Q: A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 25 mWb and the…

A: Let N is be the speed in rpm EMF induced = flux×speed N ×no. of conductors60×no.of polesno.of…

Q: A flat-compound DC generator is used when an essentially unvarying voltage is required True False

A: In this question we will write about flat compound generator...

Q: Prove that in a DC generator the maximum efficiency is obtained when constant loss is equal to the…

A: Solution: The efficiency of a D.C generator is given by the formula,…

Q: Select the most appropriate label for the type of d.c generator shown in the image below V Series…

A: In this question we need to find complete the given statement. In 2nd question we need to identify…

Q: True or False Due to their shape, full-pole generators are more affected by wind and centrifugal…

A: Due to their shape, full-pole generators are more affected by wind and centrifugal forces than other…

Q: The shunt DC generator gives almost O Constant current O None of these O Constant voltage O Constant…

A:

Q: In small transformers, the total iron losses may vary from % of the rated output. O 0.5 to 1 O 0.2…

A: They can either be graphite or precious metal brushes which have electrical motor connections. To…

Q: 1. Set up the circuit shown using a function generator for the source voltage Vs. Set the function…

A: Note: As per the policy we can solve only one question, please re-upload the remaining as a separate…

Q: Q10. The rotating machine of Figure Q10 has the following parameters: Lss = 0.18 H, L = 0.06 H, and…

A:

Q: A 6 pole DC wave wound generator has 22 armature conductors with flux per pole is 24 mWb and the…

A:

Q: The distribution factor for 90 slots, 10-pole, 3-phase winding is A 0.90 B C D 0.895 0.959 0.978

A: Given: A 3-phase winding machine with, Slots = 90. Pole = 10.

Q: n 8.2kW seriesd generator has an armature resistance is 0.25 ohms with a generated voltage equal to…

A: The above question is based on the DC generator. The major classification of DC generators is as…

Q: Fae number of parallel paths and the number of series conductrs required for a given kW reting are…

A: Number of parallel path and number of series conductor are required to?

Q: he power supplied to a three-phase induction motor is 20KW and the stator losses are 1000W. If ¤ ip…

A: Power input = 20kW Stator losses = 10000W If the slip =4% then copper losses?

Q: The DC generator has both shunt and series field winding which wound on to the san poles. O Shunt O…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.