The number of time slots in GSM1800 with uplink frequencies from 1710MHZ to 1785MHO 125O 1000O 375O 3000 Consider the following MFSK signal, the signal bandwidth is*s(t) = cos(21(f,+(2i-1-M)f,)t),with M=4, f =50 KHz, f,=5 KHzO 40 KHzO 100 KHzО 50 КHZО 20 КHZ

Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Answered: The number of time slots in GSM1800…

Engineering

Electrical Engineering

The number of time slots in GSM1800 with uplink frequencies from 1710MHZ to 1785MH O 125 O 1000 O 375 O 3000

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q5/ The bit sequence [1 01 11 01011] is to be transmitted using following formulas: (i) (ii) (iii)…

Q: Coincident factor is (FC) to the demand factor (FD) equal Indirectly proportional Directly…

A: Demand factor is the ratio of maximum(peak) demand to the total connected load. Maximum or peak…

Q: What are the entire DISADVANTAGES of FREQUENCY DIVISION MULTIPLEXING? 1:10 PM

A: i)all the channels of FDM are affected by wideband channel fading. ii)large number of filters and…

Q: In GSM 900, what is the amount of bandwidth allocated to each and every user

A: The solution is provided in the following section:

Q: List and give a brief explanation of two typical SSB modulation applications I need the answer Fast…

A: We need to give the explanation of two typical SSB modulation applications.

Q: Consider that the maximum voltage (Vmax) of the AM modulated carrier is 30V and the minimum voltage…

Q: Distortion occurs in which component of the receiving unit? O Mixer ODec frequency amplifier O…

A: Choose the correct option Distortion occurs in which component of the receiving unit?

Q: What are the different ways to carry out FSK modulation operation?

Q: 32 channel are multiplexed using flat top with TDM with pulse duration 1u sec with synchronization…

Q: What are the three most important effects due to multipath in mobile radio channel? Explain each…

A: We have given the problem What are the three most important effects due to multipath in mobile radio…

Q: Find the given values of the IC 555 timer circuit to work as Astable Multivibrator. а) find out duty…

Q: When the communication bandwidth increases while fixing the power and modulation order, Data rate…

Q: E) Compare sawtooth generated PWM versus hysteresis technique. ) Explain the switching stages for a…

A: (a) It is possible to alter both the voltage and the frequency(controlled) It is possible to…

Q: double sideband full carrier three analog channel video

A: DOUBLE SIDE-BAND FULL CARRIER: In DSB-FC, the modulation signal and carrier signal are supplied from…

Q: Which of the following multiple access techniques are used by second generation cellular systems? a)…

A: The solution is provided in the following section:

Q: What is the maximum time that can be measured with timer 0 given that: The PIC is clocked at 13.5…

A: Given PIC controller frequency = XTAL =13.5 Mhz PSA=1 ,PS <2:0>=1 Timer 0 in an 8 bit timer

Q: Question 1 25 analog signals (each is bandlimited to 15kHz) are transmitted simultaneously over a…

Q: identify the frequency band of voice channel is used in voice band modem. O 3000 to 3400 Hz O None…

A: We need to tell about frequency of voice .

Q: Need immediate help

A: The solution is provided in the following section:

Q: According to the commuter communication network, frequency division multiplexing and time division…

A: Frequency division multiplexing (FDM) and time division multiplexing (TDM) should be kept separate…

Q: What is the amount of bandwidth provided per user in GSM

A: GSM stands for Global System for Mobile Communications. It is a second generation (2G) mobile…

Q: What are the uplink and downlink bands for GSM 1800

A: The uplink frequency band is used to transfer information from the mobile station (MS) to the base…

Q: Define wy higher on-ofp 1- off ralio. on- Sevies JEFT has ratio compared to shunt as JEFT?

Q: a) Compare sawtooth generated PWM versus hysteresis technique. b) Explain the switching stages for a…

A: Pulse width modulation techniques are used to improve the steady and dynamic performance of the…

Q: a) In M-PSK digital modulation schemes, explain what happens to the following parameters, as the…

A: The given question is as follows:-

Q: For WBFM, the modulation index is A. More than 1 B. Less than 1

A: There are two types of FM modulation One is NBFM ( narrow band FM) Another is WBFM ( wise band FM)…

Q: a) Compare sawtooth generated PWM versus hysteresis technique. b) Explain the switching stages for a…

A: Pulse width modulation techniques are used to improve the steady and dynamic performance of the…

Q: For the data stream 011100101, sketch the transmitted sequence of pulses for each of the following…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Concept explainers

Uplink and Downlink Segment

The uplink and the downlink are the terminologies that are used in the satellite communications. The data when sent from the ground to the satellite is called the uplink and data when sent from satellite to ground is called downlink. The uplink and the downlink process goes in parallel and this is also a two way communication.

Question

The number of time slots in GSM1800 with uplink frequencies from 1710MHZ to 1785MH
O 125
O 1000
O 375
O 3000

Consider the following MFSK signal, the signal bandwidth is
*s(t) = cos(21(f,+(2i-1-M)f,)t),
with M=4, f =50 KHz, f,=5 KHz
O 40 KHz
O 100 KHz
О 50 КHZ
О 20 КHZ

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Uplink and Downlink Segment of Satellite

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3) Pina the . OTFT of ) x(n)= a pmd
For GSM 900, mention the uplink and downlink frequency bands?
Q5/Full the following blanks (15)10 = ( * )Gray=()BCD(5321)=( )EX-3 (15)10 = ( 1111 )Gray=( 0001 1001 )BCD(5321)=( 10010 )EX-3 (15)10 = (1000 )Gray=( 0001 0110 )BCD(5321)=( 10010 )EX-3 (15)10 = (1111 )Gray=( 0001 1000 )BCD(5321)=( 10010 )EX-3 None of them (15)10 = ( 1000 )Gray=( 1001 0011 )BCD(5321)=( 10010 )EX-3 O O O
i need the answer quickly
Q3. Draw a time division multiplexing PAM (TDM-PAM) and show that the minimum required channel BW is 2nfm where n is the number of users and fM is the maximum frequency of the message signal.
25
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in the system.Depending on the information given above, if the initial frequency of the frequency spectrum used by the FMDA system in one direction is 1000 MHz, which of the following is the correct spectrum of the bond's spectrum.A1.000.000 KHz - 10000.080 KHzB1000.000 KHZ - 1.000.040 KHzC1.000.000 KHZ - 1.040.000 KHzDNoneE1.000.000 KHZ - 1.020.000 KHZ
In TRF receivers, the greater the number of tuned stages cascaded, the narrower the bandwidth. (A) True B) False Question 2 The following are the characteristics of tuned radio frequency receivers, except A Relatively high sensitivity B) For high-frequency applications The simplest designed radio receiver available D Limited to single-channel
What are the uplink and downlink bands for GSM 900?
What are the uplink and the downlink frequency bands for GSM 1800?