The normal boiling points of the two pure components, n-heptane and n-octane are given as 98.4°C and 125.6°C at 1 atm, respectively. Construct a T-x-y diagram using the following data for n- heptane composition. A) Determine the composition of the liquid and vapor at temperature 118°C B) If a liquid containing 60 mol% n-heptane is heated in a container at 1 atm, determine the bubble, dew point temperature and composition of the liquid and vapor in both temperatures. T. ("C) Xtep YHep 98.4 1 105 0.656 0.811 110 0.487 0.674 115 0.311 0.492 120 0.157 0.279 125.6

Q: Please correct answer and step by step solution

A:

Q: Air with 100% humidity is not pleasant, even at 68°F. Air with 50% humidity at 68°F can be produced…

A: Air is dehumidified by cooling and mixing it with hot and humid air. The schematic of the process is…

Q: The vapour pressures of two pure liquids A and B are respectively 100 kPa and 60 kPa at 320 K. The…

A:

Q: The normal boiling point of liquid pen boiling point of C-H. when the exter

A: Normal boiling point of liquid pentane = 309 K molar heat of vaporization = 26.8 kJ/mol To find:…

Q: One mole of n-butane is held in a varying-volume reactor where its gas and liquid phases are in…

A: Given: T=1000c P=15.41 bar compressibility factor for Redlich kwong cubic equation of state for…

Q: A 0.0625m3 vessel is filled with 1.25 moles of O2 at a temperature of 30°C. Obtain the pressure…

A: Given: Volume of vessel is 0.0625 m3 Moles of O2 is 1.25  Molar volume is 50 m3/kmol Temperature is…

Q: 12.370 g of pure liquid methanol at 37 °C is converted to gaseous methanol at 274 °C at constant…

A: In increasing the temperature from37 oC to 274 oC, there are 3 steps 1. Rise of temperature from 37…

Q: Rapid determination of phase condition.

A: The temperature of the stream, T = 200 oFThe pressure of the stream, P = 200 psiastream composition…

Q: 1.11 Ethane at 10 MPa and 100°C is heated at constant pressure until its volume has increased by…

A: (a) Write the relation between temperature and volume at constant pressure process as follows: T1V1…

Q: Part 1: The triple point of CO2 is -56.2°C, and the vapour pressure of solid CO2 below this ten is…

A:

Q: 4.161. One thousand pounds of 10% NaOH solution at 100°F is to be fortified to 30% NaOH by adding…

A: 1. How much 73% solution must be used? Let's make a table to solve it:…

Q: 2. Draw an appropriate process path diagram for each of the two chemical systems undergoing…

A: Step 1:Step 2:Step 3:

Q: steady-flow process.

A:

Q: Provide solution in this given format: Given, required, solution and answer.  1. Hydrogen gas is…

A: Given:  Hydrogen gas is collected over water at 22.5 oC.             Total pressure = Pt = 94.4 kPa…

Q: 5. A tank contains a liquid composed of 60 mol% toluene and 40 mol% benzene in equilibrium with the…

A: Given: x1 = 0.6, x2 = 0.4, P = 1 atm, T = 80 0F To calculate the composition of the gaseous phase…

Q: The vapor pressure of liquid cadmium is 400 mm Hg at 983 K. Assuming that its molar heat of…

A: The vapor pressure of liquid cadmium at 959 K is to be calculated.

Q: At a temperature of 29.0°C, chloroform exerts a saturation pressure of 31.02 kPa. At 38.5°C, its…

A: According to the clausius clapeyron equation, ln(P2 / P1) = (-ΔH/R) X (1/T2 - 1/T1)  where P2 =…

Q: The humidity of an-air vapor mixture is H=0.030 kgH2O kg dry air. The dry bulb temperature of the…

A: Introduction: Humidity: Humidity is defined as the concentration of water vapour present the air.…

Q: A mixture of hydrocarbons with equal amounts of propane, i-butane, and n-butane exists at a pressure…

A: Pressure Antoine equation:Component ABC

Q: which of the following will be true, and why? You should not need to do any calculations here.

A: (i) Both the beakers will be at the same temperature.

Q: Carbon disulfide, CS2, has a normal boiling point (at 1 atm) of 35°C and a heat of vaporization of…

A: