The movement of the 225 g pin A in the circular guide is regulated by guide B which rises under the action of the guide screw to 1,8 m/s during a movement phase. Calculate the force N exerted by the circular guide on the pin when passing through position 0 = 30o. The friction is despicable.

Q: Problem-2 The tension in the guy wire is 2500 N. Determine: a) components Fx, Fy , Fz of the force…

A:

Q: Determine the maximum value of b (lb/ft) if the roller at point A can only support upto 148 lb. The…

A:

Q: Given: F = 750 N nd: a) force applied at the handle. 85 mm 140 mm 140 mm

A:

Q: Solve for A and B. P=400 lbs. 0=30° P 45° B www Drawing not to scale. Use given angles. Magnitude of…

A:

Q: For the problem shown, determine the magnitude of the force in member EF given that x = 2.3 m, y =…

A:

Q: Consider the pipe shown in (Figure 1). The forces F = 650 N, F = 700 N , and F3 = 700 N are paral…

A:

Q: ne of your classmates is tra ackyard and jumped off her rain. The student weighs 12 ne roof's height…

A: The above given question is based upon energy balance of the system at different positions. So, to…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.