The manometer fluid in the figure given below is mercury where D = 3 in and h = 1 in. Estimate the volume flow in the tube (ft3/s) if the flowing fluid is gasoline at 20°C and 1 atm. The density of mercury and gasoline are 26.34 slug/ft3 and 1.32 slug/ft3 respectively. The gravitational force is 32.2 ft/s2.

The manometer fluid in the figure given below is mercury where D = 3 in and h = 1 in. Estimate the volume flow in the tube (ft3/s) if the flowing fluid is gasoline at 20°C and 1 atm. The density of mercury and gasoline are 26.34 slug/ft3 and 1.32 slug/ft3 respectively. The gravitational force is 32.2 ft/s2.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the reservoir. The manometer fluid is mercury, which has a density of 845 Ib/ft3. The manometer fluid rises a distance d = 12 inches along the manometer tube, which is inclined e = 20° from the horizontal. The atmospheric pressure is 14.7 Ibf/in? and the acceleration of gravity is 32.2 ft/s?. Patm = 14.7 Ibf/in.? Gas reservoir g = 32.2 ft/s? a 20 in. Mercury (p = 845 Ib/ft³) Determine the gas pressure, in Ibf/in?. Express the pressure as a gage or a vacuum pressure, as appropriate, in Ibf/in2.
An incompressible fluid flows through a pipe without significant viscosity. It has a density of 124 kg per cubic meter. In a section of pipe with a 2.8 cm radius the fluid moves at a speed of 13 m/s, and has a pressure of 103,763 pascals. It flows into a section of pipe with a 3.87cm radius that is 5 meters higher than the first section. What the pressure in the second section of pascals?
When a clean glass tube with a diameter of 2 mm is immersed in water at 20 ° C, how many mm will the capillary rise occur in the glass tube? For water at 20 ° C, surface tension is given as 0.073 N / m, density 1000 kg / m3, contact angle 0 ° C and gravitational acceleration 10 m / s2.
(Just Question a.) A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1= 20.2 cm and the pressure is known to be P1= 7.00×104 N/m2 above atmospheric pressure. If the pipe carries the water 3.5 meters up hill without any change in diameter, what is the new absolute pressure within the pipe? After flowing up the hill described above, the pipe narrows to 80% of its original radius, what will be the new water velocity (v2) in the pipe? What will be the absolute pressure (P3) in the smaller pipe? a. What is the volume flow rate through the smaller pipe?
A tank containing helium has a manometer attached, as shown in the figure. The local atmospheric pressure, Po, is 100 kPa and the gravitational acceleration is 9.81 m/s. The heights of each fluid in the manometer are hi = 330 mm, h2 = 460 mm and h3 = 500 mm. Assume the densities of the water (pw), light oil (poi), and mercury (pH2) in the system are equivalent to those at standard atmospheric conditions. Determine the pressure of the helium in the tank, PHe, in kPa. P. Light Oil, Poil h1 Helium g h3 Water, Pw Mercury, PHg
The Super Soaker XP30 is a marvel of hydraulic dispersion weaponry. By pumping on the handle, you charge the chamber to high pressure. The pressure is maintained until you pull the trigger at which point the water (? = 1000 kg/m3) is released at high velocity.You have charged your pressure chamber to an absolute pressure of P1 = 697500 Pascals, much higher than today's outside air pressure of 101300 Pascals. The pressure chamber is location at a height of y1 = 0.103 meters above the exit point. The exit point has a small opening with radius r = 0.0033 meters.Determine all the following:The velocity at which the water exits the Super Soaker: v2 = m/sThe mass flow rate through the exit: kg/secThe volume flow rate through the exit: m3/secNOTE: You may treat the water chamber as a "tank" and approximate the water velocity there to be zero.
The Super Soaker XP30 is a marvel of hydraulic dispersion weaponry. By pumping on the handle, you charge the chamber to high pressure. The pressure is maintained until you pull the trigger at which point the water (? = 1000 kg/m3) is released at high velocity. You have charged your pressure chamber to an absolute pressure of P1 = 675500 Pascals, much higher than today's outside air pressure of 101300 Pascals. The pressure chamber is location at a height of y1 = 0.117 meters above the exit point. The exit point has a small opening with radius r = 0.0038 meters. Determine all the following: a) The velocity at which the water exits the Super Soaker: v2 = m/s b) The mass flow rate through the exit: kg/sec c) The volume flow rate through the exit: m3/sec
2. The gage pressure of the air in the Oil tank is measured to be 65 kPa. Find SG = 0.72 the differential height (h) of the 75 cm column. Specific gravities (SG) of Air -Water the manometer fluids are given in 30 cm -Mercury SG = 13.6 h the figure. Assume that the density of water is 1000 kg/m³.
A vertical venturimeter carries liquid of relative density 0.8 and has inle. and throat diameters of 150 mm and 75 mm respectively. The pressure connection at the throat is 150 mm above that at the inlet. If the actual rate of flow is 40 litres/sec and the C 0.96, calculate the pressure difference between inlet and throat N/m?.
For the sliding plate viscometer shown below. The top plate is moving to the right with a constant velocity of 9.6 m/s in response to a force (F) N. The bottom plate is stationary. The kinamatic viscosity of the fluid betwen the two plates is 0.001 m2/s. Find the magnitude of the force (F) N, if the fluid specific gravity = 0.85, and water density = 1000 kg/m³. Assume a linear velocity distribution. 100 mm 50 mm 1 mm
Water flows through a Venturi meter, as shown in the figure. The pressures of the water at locations a and b in the pipe support columns of water that differ in height by L = 12 in. The atmospheric pressure is 14.7 Ibf/in?, the specific volume of water is 0.01604 ft3/lb, and the acceleration of gravity is g = 32.0 ft/s?. Patm = 14.7 Ibf/in.? g = 32.0 ft/s² Water v = 0.01604 ft³/lb Determine the difference in pressure between points a and b, in Ibf/in?. Does the pressure increase or decrease from point a to point b?
A pipe flowing water has a manometer attached, as shown in the figure. The local atmospheric pressure, Po, is 101.3 kPa and the gravitational acceleration is 9.81 m/s². The densities of the water (pw), oil (po«), and mercury (png) are 1000.0, 800.0 and 13,600 kg/m³, respectively. The heights of the liquid levels in the manometer system are indicated in the figure. What is the absolute pressure at the center of the water pipe, Pw, in kPa. oil Poil = 800.0 kg/m³ P. h, = 110 cm h, = 30 cm h, = 20 cm h, = 95 cm h water h water Pu= 1000.0 kg/m³ mercury PHe=13,600.0 kg/m³