The magnetic flux through a metal ring varies with time t according to Pg = 3(at3 – bt2)T m2, with a = 3.00 s-3 and b = 9.00 s-2. The resistance of the ring is 3.00 Q. Determine the maximum current induced in the ring during the interval from t = 0 to t = 2.00 s. Give your answer in A. %3D

Q: 8 Look at the photo of the boys on the charity Write the correct answer. 1 Paul and Donny _are a is…

A: Given

Q: Q-01 (What is called Buck Converter & What is called Boost Converter?)  give two examples for each.

A: Explanation: The buck converter is a ubiquitous DC-DC converter that correctly converts an excessive…

Q: What will be the charge and mass of an electron? I am stuck. Please help. Will give good feedback.

A: Electrons are negatively charged particles and they revolve in elliptical orbits around the atomic…

Q: No, this question was not a message for somebody on a support team, I literally asked how you solved…

A:

Q: Help me do the K-Map For 01347

A: K-map

Q: how did you find Rth?

A:

Q: What is UHV and EHV?

A: EHV stands for Extra High Voltage transmission line whereas UHV stands for Ultra High Voltage…

Q: Question 4b The school board is trying to evaluate a new math program introduced to second-graders…

A: The  above chart tells us that all the points which are between the upper and the lower control…

Q: Give the drain current equation of JFET.

A: The output characteristic of a JFET is shown in the figure below:

Q: Please show the work in between the rearranged formula and the answer

A: Given: Calculate the S/N in dB if the passband circuit is 48kHz to 64kHz and the maximum bit rate is…

Q: 4.111. (a) Find the Q-point for the transistor in the circuit in Fig. P4.111(a) if VDD = +12 V. (b)…

A: Find the Q- point for the transistor in the circuita) if VDD=12Vb)Repeat for the circuit (a)

Q: Analyse the circuit as shown in Figure 2, Draw the state transition table and determine the module.…

A: JK FLIP-FLOP Truth Table:-           INPUT               J         INPUT                  K…

Q: 5. What are the advantages of Centre tapped and Bridge Rectifier?

A: Various loads work on DC, but the supply available to us naturally is AC supply. Rectifier is a…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.