The magnetic flux density in a region of free space is given as B= 6xag -9yay + 3za, T. the force on the side 4 of rectangular loop shown in Figure, it lies in the plane 3. 4. 25A 3 180 az None of the choices -90 az 30 az

Q: Black to 0.3 0.291 0.00882 3 -2.999 0.036 0.089 0.4 0.364 0.411 Anode -5.999 0.5 0.6 0.7 12 -11.998…

A: Multimeter- It is an electronic device which is used to measure different parameter like voltage,…

Q: (a) Describe the main sources of power loss in a digital integrated circuit. (b) Calculate the…

A: Since, we answer only upto 3parts.So the solution of first three parts are as follows : The major…

Q: Each subsatnce absorbs or emit unoque  level & quantities of energy/  e.m.r..   True  False

A: GIVEN: a statement  FIND: TRUE OR FALSE

Q: Recording Instruments Select one: a. Instruments that records the measured value over a period of…

A: In this question we will define recording instruments...

Q: What is the required resolution of an instrument if the product characteristic specification is 10.0…

A: The number of bits or portions that the output or displayed reading from a sensor or measuring…

Q: How many valence electrons does a donor atom have? Please choose one: a. 3 b. 4 c. one D. 5

A: Donor atoms are belongs to group V in periodic table.

Q: Convert 24.788832 to six significant figures

A:

Q: 17. Which of the following statements is correct? The resistance of most of the material is…

A: we need to tell which option is correct.

Q: The section bus-bars A and B are linked by a bus-bar reactor rated at 5000 kVA with ?? % reactance.…

A:

Q: 1. How iron loss in transfomer is minimized 2. On Cwhaf bushing size and comstouction is depending…

A:

Q: a) Explain FOUR (4) measurement standards available.

A:

Q: FETS usually; O a. are more sensitive to temperature changes than BJTS O b. are bulkier than BJTS O…

A:

Q: Describe the difference between donor and acceptor impurities.

A: For the given question we have to write the differences between donor and acceptor impurities

Q: Find the value of (1ti).

A: The complex number Can be solved easily.

Q: in el Eocs) / Ei (s)

A: The solution can be achieved as follows.

Q: What is the required resolution of an instrument if the product characteristic specification is 10.0…

A: Resolution is the smallest change that the instrument can measure.  It is the least count…

Q: A transistor is used as a switch and the waveforms are shown below. The parameters are given as…

A: Given  Transistor as switch and waveforms as shown  Vcc=200 vVCE(sat)=1 vICS=100 AICEO=1 mArise time…

Q: Explain the elements of measurement system in detail

A: Measurement system : measurement system is combination of various component which measures the…

Q: A resistor was measured 13 times at the same time conditions with the following results (in ohms):…

A: Measured resistance values is given by: R1= 100 ohm R2= 996 ohm  R3 = 990 ohm  R4 = 995 ohm  R5 =…

Q: Define the following terms (i) Linearity (ii) Fidelity

A: Linearity is closely related with proportionality. Linearity is represented as a  straight line in…

Q: 4. For 3 hours of pure music, determine the amount of storage needed to record based on 2 channels.…

A: For a pure music, given that: Time taken to play (t) = 3 hours = 3×60×60= 10800 seconds; Number of…

Q: Power across R1 Watts Power across RB = Watts Power across Diode Watts

A: In this question we need to find a power across R1 , RB & diode

Q: A Give the value of each digit in the following decimal numbers: fal 263 tb) 5436 (e) 234543

A:

Q: Q1) B A continuous state-space representation of a sys N-C-A y = [1 0 [x₂] Find the zero order hold…

A:

Q: 10 16 BCD Gray 3-code 10110111 FD 1011001 91 111001

A: Value of binary to decimal is given by:-  Num1 = 27×1+26×0+27×1+25×1+24×1+23×0+22×1+22×1+20×1…

Q: The width of the semiconductor is depends on the amount of impurities added to it. Select one: True…

A: Semiconductor is a matter which have the conductivity between the conductor and insulator. By adding…

Q: A synchronous generator has a constant mechanical input power of Po. In the fault followed by the…

A: Given  A1=1.6 A2=0.4

Q: Germanium Silicon Vo v2 V1 RL 1k 15 mi

A: The given circuit is,

Q: Unit 4: Table 1: Filter information A filter is required to attenuate all signal frequencies above…

A:

Q: is the Decimal equivalent of (0.235) O a 0.103 O b. 0.306 OC 0.113 O d. 0.224

A:

Q: 1.53. (a) What is 8(2t)? (b) What is 8[2n]?

A:

Q: What does gv(E) represent? Select one: O a. The number of electrons in the conduction band between…

A: In this question,  We need to choose the correct options What is gv(E) represention?

Q: A resistor was measured 13 times at the same time conditions with the following results (in ohms):…

A: Given: The measured values of a resistance 13 times are,…

Q: What is the Q, FF steady state answer ? Cik Cik Cik

A: The truth table of D flipflop is (for positive edge of clk) Clk D Q Q¯ Comment ↑ 0 0 1 Q output…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.