The inner diameter of this shaft is 80 mm and the outer diameter is 100 mm. The applied loads are shown in the figure below. The allowable normal stress on plane a -a is 80 Mpa and the allowable shear stress on the same plane is 45 Mpa. Determine the maximum allowable load P that can be applied on the member. Note that point A is on the surface of the shaft.

Q: answer is 900.8 please resolve

A: Given Data

Q: This still doesnt answer how to get points 2,  2', and 1', so how did you get it?

A: Itis asked to explain how the state points 2, 2' and 1' are obtained

Q: How did you solve for the velocity of b?

A: The given question was solved using velocity polygon method.If AB is a link which is rotating about…

Q: solve and show every step with right answer

A: Data given - Rectangular cross section 225×75 mm2 Torsional moment = 20kN Axial Compressive force =…

Q: How much force in lbs will it take to lift a 10 -lb weight with a wheel and axle, when the axle is…

A:

Q: Find in inches the inside diameter of this water pipe for an automatic icemaker. Express the answer…

A: Given     Outside diameter, d = 1 1/4 in                                  = 1.25 in…

Q: solve both

A: Power input, Gear speed of input shaft, Gear ratio, Power loss,

Q: Says.003 is wrong

A:

Q: Forces and moments are scalar Forces are moments are vector quantities.

A: Forces and moments are both physical quantities that can be used to describe the behavior of objects…

Q: What would it be in celcius

A: From the result, the final temperature of the air in the tank is 277.3 K

Q: Determine the mass of a steel ball whose diameter is 16mm.

A:

Q: Is 2.0cm3 of aluminum same as 2.0cm3 of lead

A: According to the given data, the volume of the aluminum object is 2.0 cm³  and the volume of the…

Q: 1. show all steps in detail, units and formulas please.

A:

Q: both answers are wrong :(

A: Given DataT1=310KP1=320kPaM1=0.3 To findV2=?P2=?

Q: 6.A 1.5-m pendulum swing through an angle of 6º.How wide is the swing, to the nearest centimeter?

A: To find: The value of width of the swing. Given: The value of length of the pendulum is, l=1.5 m.…

Q: Part C - Maximum allowable axial force for fixed-and-free-end support If the cylindrical column is…

A:

Q: la) Compare the relative load strength of the following two bolts: Bolt 1 = %" Dia x 3" Long and is…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.