The hot combustion gases of a furnace are separated from the ambient air and its surrounding which are at 25oC, by a brick wall 0.15 m thick. The brick has a thermal conductivity of 1.2 W/m-K and a surface emissivity of 0.80. Under steady state conditions the outer surface temperature of 100 oC is measured. Free Convection heat transfer to the air adjointing this surface is characterized by a convection coefficient of 20 W/m2-K. What is the inner temperature?

Q: A wall has inner and outer surface temperatures of 16 and 6°C, respectively. The interior and…

A:

Q: Consider a long bar of square cross section (0.8 m to the side) and of thermal conductivity 2 W/m-K.…

A: To find: The midpoint temperature of the bar, heat transfer rate between the bar and the fluid per…

Q: A solid circular rode of 40 cm long and 4 cm diameter is subjected to a uniform temperature at the…

A: Given: Length of the rod→L=40 Cm=0.40 m Diameter of the rod→d=4 Cm= 0.04 m Hence cross sectional…

Q: The free convection heat transfer coefficient on a thin hot vertical plate suspended in still air…

A:

Q: wo different fluids are separated by an insulating barrier. he barrier consists of two different…

A:

Q: You have to do thermal analysis of a building near an arctic observatory, which has a footprint of…

A: To find: 1. Total heat transfer 2. Dominate mode of heat transfer  3. Ratio between the heat…

Q: two 5 cm diameter, 15 cm long aluminum bars (k=176W/m(degrees Celsius)) with ground surfaces are…

A:

Q: You've experienced convection cooling if you've ever extended your hand out the window of a moving…

A: Given:Surface temperature of hand, Ts=30oCCondition A: Vehicle speed, VA=35 km/hAir temperature,…

Q: A field investigation of the thermal environment has been conducted for a room with an external…

A: Since you have put a multi-part question, we are providing the solution to the only first three…

Q: To increase the rate of heat transfer from a device, which has 0.1 m² of exposed surface, you added…

A:

Q: The inside surface of an insulation layer is maintained at 350°C and the outside surface dissipates…

A:

Q: A flat wall is exposed to an environmental temperature of 38oC. The wall is coveredwith a layer of…

A: Given: T1=41°CT2=315°CTe=38°Ck=1.4W/m°Cdx=2.5 cm = 0.025 m

Q: An electric wire, with 2 mm in diameter, is insulated by a rubberized liner (k = 0.13 W/m.K) of 2 mm…

A:

Q: calculate the heat transfer rate per unit length of a cylindrical wall of inner and outer radius as…

A: It is given in the data that inner radius is r1=0.1 m and outer radius is r2=0.2 m. Thermal…

Q: A square thermal window is constructed of two sheets of flat glass, each 4.00 mm thick, separated by…

A: Given:kglass=0.80 W/m.Kkair=0.024 W/m.KTcold=20oCThot=30oCCross-sectional area, A=6.00 m2Find:a The…

Q: To increase the rate of heat transfer from a device, which has 0.1 m² of exposed surface, you added…

A: Given data: Area of exposed surface = A = 0.1 m2 Length of fin = l = 4 cm = 0.04 m Diameter of fin =…

Q: Consider a 150-W incandescent lamp. The filament of the lamp is 5.7-cm long and has a diameter of…

A: GIVEN  DIAMETER OF FILAMENT =D =1.2MM=0.0012 M LENGHT OF FILAMENT =L= 5.7 CM=0.057 M ASSUMPTION…

Q: The wall of a furnace is made up of a material which has thermal conductivity of 2.65 W/m◦C and a…

A:

Q: An uninsulated steam pipe is passed through a room in which air and walls are at 25°C. The outer…

A:

Q: W Suppose that a finned surface is exposed to an environment with a temperature of 26 °C and a…

A: Given Data: Convection heat transfer coefficient h=27 Wm2.K Thermal conductivity of fin K=147 Wm.K…

Q: A refrigerated room is maintained at -10 The room IS sides are covered with 150mm thick rigid…

A: GivenDimensions of room=15m×5m×2mt=150mm=0.15mh=15W/m2Kk=0.020W/mkTI=-10°CTS=25°C

Q: Water flows at 67 C inside a 2.5 cm inside diameter tube such that hi = 3500 W/m² .C. The tube has a…

A:

Q: A box full of electronics with the dimensions shown in the diagram is buried deep in soil. The…

A: Heat transfer, in general, defines the movement of heat (thermal energy) caused by temperature…

Q: A double-glazed window assembly consists of two glasses, each 6 mm thick, and an air gap of 6 mm…

A:

Q: it is desired to understand the time - temperature behavior of a hot copper sphere. the sphere has a…

A: it is desired to understand the time - temperature behavior of a hot copper sphere. the sphere has a…

Q: The thermal conductivities of human tissues vary greatly. “Fat” and “skin” have conductivities of…

A: In heat transfer analysis, the rate of change of state is evaluated by calculating the rate of heat…

Q: Copper fins, 2.1 cm long and 2.1 mm in diameter, are attached to a base plate at 75 °C. A fan blows…

A: To find: The heat transfer through the tips. Given: The length of the fin is L=2.1 mm1 m1000…

Q: 1. Judging  from its unit W/m.K can we define thermal conductivity of a  material as the rate of…

A: 1. We can not define thermal conductivity as the rate of heat transfer through the material per unit…

Q: Determine the temperature variation inside the iron plate with a thickness 21 of 2 mm,…

A: A steady state is a state which remains the same over given time period. In heat transfer problems…

Q: A 14-cm x 20-cm circuit board houses on its surface 100 closely spaced logic chips, each dissipating…

A:

Q: A food product with 73% moisture content in a 10 cm diameter can wants to be frozen. The density of…

A: Given data, x = Moisture contains in the food product = 0.73 a = Diameter of the food product = 0.1…

Q: Calculate the heat transfer per hour through a solid brick wall 6 m long, 3 m high, and 240 mm…

A: find the heat transfer per hour.

Q: A pile of biomass (1.6 m deep, with a thermal conductivity of 0.41 W/mK) has been semi-buried in the…

A: Given : t = 1.6 m h = 13 W/m2K T = 23 C s = 15 W/m3 To find : Temperature at top surface at steady…

Q: A sphere at 120°C was being exposed to surrounding air at 30°C with convection coefficient of 33…

A:

Q: The two surfaces of a 1.0-cm-thick plane wall are at 10°C and 45°C, and the heat transfer rate is…

A: Thickness of the surfaceTemperatures:Heat transfer rate

Q: A cube of side 21 mm is made of a material with thermal conductivity 182 W m-1 K-1, density 1426 kg…

A: Given:Side of a cube, S=21 mm=0.021 mThermal conductivity of a material, k=182 W/m.KDensity of a…

Q: A food product with 80% water content in a 10 cm diameter can be frozen. Mass of the product type is…

A: Given data, x = Moisture contains in the food product = 0.8 a = Diameter of the food product = 0.1 m…

Q: A temperature difference of 85oC exists across a fibreglass insulation layer 13 cm thick, for which…

A: Given Data K=0.035 W/mK Thickness, t=0.13m Temperature difference, ∆T=85°C

Q: A 5.0 -cm-diameter aluminum cylinder is maintained at a temperature of 50-C in a large room where…

A: total heat transfer = heat transfer by convection + heat transfer from radiation

Q: Two parts and label (A) & (B) Solve carefully! Question : The roof of a car in a parking lot absorbs…

A:

Q: The roof of a house absorbs a solar radiant flux of 600 W/m", while the underside to the ceiling is…

A: Q= h A ( T2-T1) q= Q/A = h( T2-T1)