The hollow shaft shown is made of a steel that is assumed to be elastoplastic with Ty=145 MPa and G=77.2 GPa. The magnitude Tof the torques is slowly increased until the plastic zone first reaches the inner surface of the shaft; the torques are then removed. Determine the permanent angle of twist of the rod. Take L = 5.2 m. 60 mm 25 mm The permanent angle of twist of the rod is

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A:

Q: The solid shaft shown is made of a steel that is assu increased in magnitude until the shaft has…

A:

Q: 1

A: Given data:- Moment about a horizontal axis on the cross section is 0.80 kN-m

Q: A mild steel bar, 1.5 m long, has a square section 40 mm x 40 mm. The bar is subjected to a two-…

A:

Q: A vibration isolation support consists of a rod A of radius R₁ and a tube B of inner radius R₂…

A: G = 10.93 MPaP = 13 kN or 13000 N

Q: A 10 cm diameter solid alumin Assume that L=0.5 m. The yiel a) Normal stress due to bending caused…

A:

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A:

Q: A steel rod 26 mm diameter has a brass sleeve 40 mm external diameter and 26 mm internal diameter…

A: Axial deformation in a bar takes place due to axial force. The axial force depends upon the…

Q: A rigid plate C is used to transfer a 20-kip load P to a steel (E = 30,000 ksi) rod A and to an…

A: Detailed solution is provided below :

Q: A rod is composed of an aluminum section rigidly attached between steel and bronze sections, as…

A: σ=PA     ----( 1 ) here σ is stress , A is cross sectional area and P is force applied Calculate σst…

Q: An aluminum pipe (modulus of elasticity 10.1x10^6 psi) is fixed at one end and is subjected to a…

A: Element stiffness matrix for a cantilever beam subjected to both axial load and moment will be the…

Properties of materials

A property of a material describes its characteristics and distinguishes it from the others. The material properties are described it in terms of its hardness, color, appearances, and so on. The material properties generally depend on the type of material, or whether it is a metal or an alloy. There are different kinds of material properties such as mechanical properties, thermal properties, physical properties, and chemical properties. Chemical properties describe the material in terms of a chemical change. The mechanical properties come into existence when the material is acted upon by an external load. Thermal properties are associated with the temperature of the material and specific heat.