The hollow crank has an outside diameter of 35 mm and an inside diameter of 30 mm. The length dimensions are a = 70 mm, b= 130 mm, and c-85 mm. Using load magnitudes of Py = 1,800 N and P, -3,500 N, determine the normal and shear stresses on the side of the crank at point K. Answers: 0,= ay" MPa MPa MPal

Q: The bell-crank mechanism is in equilibrium for an applied load of P = 35 kN. Assume that a = 240 mm,…

A: Given Data Determine the average shear stress in the pin-B.

Q: Forces are applied at points A and B of the solid cast-iron bracket shown. The bracket has a…

A:

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: First we need to divide the section into 3 different parts. Then we need to calculate the neutral…

Q: For the shaft loaded as shown, which point(s) at the section shown experiences the maximum shear…

A: Let's draw the FBD  for first figure At the L shaft observe the stresses and their directions…

Q: A steel bracket of solid circular crosssection is subjected to two loads, each of which isP = 4.5 kN…

A: Given:- The magnitude of the force (P) = 4.5 kN The dimension variable (b) = 240 mm = 0.24 m The…

Q: The continuous beam and post system shown below supports a 10 kip vertical load and a 5 kip…

A: The moment and shear force will act at point B. Moment and shear will be caused due to force of 5…

Q: Two forces, each of magnitude P, are applied to the wrench. The diameter of the steel shaft AB is…

A: Calculate the value of P using both shear stress criteria and angle of twist criteria. The criteria…

Q: A solid 1.20 in. diameter shaft is subjected to a torque of T = 230 lb-ft and an axial load of P =…

A:

Q: Determine the principal stress and absolute maximum shear stress developed at point B on the cross…

A:

Q: 1. Draw the axial force diagram of the rod. The diameter d=10mm, F=5kN. E=210GPa. Determine the…

A:

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: Given: The value of b is 3.6 in. The value of d is 10.8 in. The value of a is 2.3 in. The value of t…

Q: Find the shear stress on the inside and outside of the hollow pipe shown, and the total angle of…

A: Given  T = 3500N-m Outside dia = 10.4 cm  Inside diameter = 7.6 cm  G = 7500 MPa  L = 3m

Q: The ends of the compound shaft are attached to rigid walls. The maximum shear stress is limited to…

A:

Q: The center post B of the assembly has an original length of 124.7 mm, whereas posts A and C have a…

A:

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.