The Hall voltage across a conductor in a 40 mT magnetic field is 2.0 μV. When used with the same current in a different magnetic field, the voltage across the conductor is 2.7 μV Part A What is the strength of the second field? Express your answer with the appropriate units. B₂ = HÅ Value Units ?

The Hall voltage across a conductor in a 40 mT magnetic field is 2.0 μV. When used with the same current in a different magnetic field, the voltage across the conductor is 2.7 μV Part A What is the strength of the second field? Express your answer with the appropriate units. B₂ = HÅ Value Units ?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

To construct a solenoid, you wrap insulated wire uniformly around a plastic tube 8.9 cm in diameter and 45 cm in length. You would like a 3.2 AA current to produce a 2.6 kGkG magnetic field inside your solenoid. Part A What is the total length of wire you will need to meet these specifications? Express your answer using two significant figures.
A simple generator has a square armature 9.0 cm on a side. The armature has 95 turns of 0.59-mm-diameter copper wire and rotates in a 0.800-T magnetic field. The generator is used to power a lightbulb rated at 12.0 V and 25.0 W. Part A At what rate should the generator rotate to provide 12.0 V to the bulb? Consider the resistance of the wire on the armature.
A coil has 180 turns enclosing an area of 10.4 cm². In a physics laboratory experiment, the coil is rotated during the time interval 0.046 s from a position in which the plane of each turn is perpendicular to Earth's magnetic field to one in which the plane of each turn is parallel to the field. The magnitude of Earth's magnetic field at the lab location is 5.00×10-5 T. Part A What is the magnitude of the magnetic flux through one turn of the coil before it is rotated? Express your answer in webers. View Available Hint(s) initial Submit Part B |final = = Submit —| ΑΣΦ = What is the magnitude of the magnetic flux through one turn of the coil after it is rotated? Express your answer in webers. ► View Available Hint(s) ΠΙ ΑΣΦ ? Wb ? Wb
Two VERY LONG wires are placed along parallel lines as shown below in the picture. LEFT (at X1= 0) has a current going out of the page of value, I1 = 4 A. The current on the RIGHT (at X2= d) has a current going into the page of the page of value, l2 = 6 A. The point "P" is at the location (x=6.00cm, z=10.4cm) The wire ON THE %3| d (X) d Wire 1 Wire 2
Please answer c and d
A rocket zooms past the earth at v = 2.0 x 10 m/s. Scientists on the rocket have created the electric and magnetic fields shown in the figure.(Eigure 1) Assume that B = 1.5 T and E= 1.5x106 V/m. Figure B E 2.0 × 10 m/s 1 of 1 ▼ Part A What is the electric field strength measured by an earthbound scientist? Express your answer using two significant figures. Π ΑΣΦ E = Submit Part B Up What is the direction of the electric field measured by an earthbound scientist? Down Left B = Request Answer Right Into the page Submit Out of the page Part C Previous Answers Correct ? V/m What is the magnetic field strength measured by an earthbound scientist? Express your answer using two significant figures. ΠΨΕ ΑΣΦ ? T
A 7.0-cm -long wire is pulled along a U-shaped conducting rail in a perpendicular magnetic field. The total resistance of the wire and rail is 0.30 N. Pulling the wire with a force of 1.3 N causes 4.1 W of power to be dissipated in the circuit. Part A What is the speed of the wire when pulled with 1.3 N ? Express your answer in meters per second. Π ΑΣΦ V = Submit Part B What is the strength of the magnetic field? Express your answer in tesla. —| ΑΣΦ B = Request Answer Submit Request Answer ? ? m/s T
A 550-turn solenoid is 12 cm long. The current in it is 38 A . A straight wire cuts through the center of the solenoid, along a 5.0-cm diameter. This wire carries a 23-A current downward (and is connected by other wires that don't concern us). Part A What is the force on this wire assuming the solenoid's field points due east?
1) A straight, stiff, horizontal wire of length 48 cm and mass 28 g is connected to a source of emf by light, flexible leads. A magnetic field of 1.33 T is horizontal and perpendicular to the wire. Find the current necessary to float the wire, that is, find the current for which the magnetic force balances the weight of the wire. A Submit You currently have 0 submissions for this question. Only 10 submission are allowed. You can make 10 more submissions for this question.
A 0.68 T magnetic field is applied to a paramagnetic gas whose atoms have an intrinsic magnetic dipole moment of 1.3 x 1024 J/T. At what temperature will the mean kinetic energy of translation of the atoms equal the energy required to reverse such a dipole end to end in this magnetic field? Number i Units
A wire with a length of 3.5 m and a mass of 0.74 kg is in a region of space with a magnetic field of 0.76 T. Part A What is the minimum current needed to levitate the wire? Express your answer using two significant figures. νΠ ΑΣφ I = A
The magnetic field around the head has been measured to be approximately 3.00x10-8 gauss. Although the currents that cause this field are quite complicated, we can get a rough estimate of their size by modeling them as a single circular current loop 16.0 cm (the width of a typical head) in diameter. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Magnetic field of a coil. Part A What is the current needed to produce such a field at the center of the loop? Express your answer in amperes. Π| ΑΣΦΑ I = ? A