Answered: the graph below, each unit on the… | bartleby

Related questions

Question

In the graph below, each unit on the horizontal axis is 2.20 x 10-3 m3 and each unit on the vertical axis is 0.300 atm.
РА
V
(a) Determine the change in internal energy of the gas if 2102 J of heat is added as it expands in volume along the direct path CA.
(b) To get the same change in internal energy, how much heat must be added to the gas as it goes along the path CBA?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

If you have 3 moles of a monoatomic ideal gas, how much heat is required to raise the temperature of this gas from 266.9K to 275.4K if the volume of the gas remains constant during the heating? Note: It is understood that your answer is in units of Joules, however do not explicitly include units in your answer. Enter only a number. If you do enter a unit ("J" in this case), you answer will be counted wrong.
A system consisting of 0.0816 moles of a diatomic ideal gas is taken from state A to state C along the path in the figure below. (b) What is the lowest temperature of the gas during this process? In kelvin. (c) Find the change in internal energy of the gas in going from A to C. Hint: Adapt the equation (for the change in internal energy of a monatomic ideal gas) ΔU=3/2nRΔT=3/2Δ(PV)=3/2(PcVc-PaVa) to a diatomic ideal gas. In joules. (d) Find the energy delivered to the gas in going from A to C. In joules.
While constant total pressure = 4.5 atm, an ideal gas grows from 500ml to 900ml. After, the heat flows out of the gas at constant volume. Pressure and temperature may drop until the temperature reaches its original value. During this process, what's the total work done by this gas (answer in J(? please use convsersion: 1atm=1.013x105 Pa
Suppose a tank contains 636 m³ of neon (Ne) at an absolute pressure of 1.01x105 Pa. The temperature is changed from 293.2 to 295.0 K. What is the increase in the internal energy of the neon? ΔU = i
A gas expands from I to F in the figure below. The energy added to the gas by heat is 354 J when the gas goes from I to F along the diagonal path. P (atm) 4 3 EN B 1 0 1 2 A 3 4 F V (liters) (a) What is the change in internal energy of the gas? J (b) How much energy must be added to the gas by heat for the indirect path IAF to give the same change in internal energy? J
A gas follows the PV diagram in the figure below. Find the work done on the gas along the paths AB, BC, CD, DA, and ABCDA.
The picture shows a pV diagram for an ideal gas in which its pressure tripled from a to b when 804 J of heat was put into the gas. Work done on or by the gas between a and b= 0 W Delta U=804 J a) What is the temperature of the gas at point bb in terms of its temperature at a, Ta?
A gas expands from I to F in the figure below. The energy added to the gas by heat is 302 J when the gas goes from I to Falong the diagonal path. Three paths are plotted on a PV diagram, which has a horizontal axis labeled V(liters), and a vertical axis labeled P (atm). The green path starts at point I (2,4), extends vertically down to point B(2,1), then extends horizontally to point F (4,1). The blue path starts at point I (2,4), and extends down and to the right to end at point F (4,1). The orange path starts at point I(2,4), extends horizontally to the right to point A (4,4), then extends vertically down to end at point F(4,1). (a) What is the change in internal energy of the gas?J(b) How much energy must be added to the gas by heat for the indirect path IAF to give the same change in internal energy?J
The PV diagram shows the compression of 40.9 moles of an ideal monoatomic gas from state A to state B. Calculate Q, the heat added to the gas in the process A to B. Data: PA= 1.90E+5 N/m2 VA= 1.83E+0 m3 PB= 1.01E+5 N/m2 VB= 8.90E-1 m3›44
64870 J of heat is added to a gas at a constant pressure of 1.75 x 105 Pa This causes a change in internal energy of 2570 J. If the starting volume is .864 m3, what is the final volume?
You would like to raise the temperature of an ideal gas from 295 K to 960 K in an adiabatic process. a)What compression ratio will do the job for a monatomic gas? b)What compression ratio will do the job for a diatomic gas?