The Governate of Al Buraimi is densely populated that is evenly distributed over an area of 1200 km2. It is given that a percent of the population is subscribed to a cellular system. Assuming that the cellular system is a Erlang B system with a traffic Intensity per cel of 37 Erlangs, a total spectrum of 40 MHz, and a simplex channel bandwidth of 30 kHz. The system covers the city using hexagonal cells with a diameter of 8 km and a cluster size of 7 cells. Find: a) The total number of cells in the system b) The number of channels per cell c) The total number of channels in the system d) Total number of clusters in the system

The Governate of Al Buraimi is densely populated that is evenly distributed over an area of 1200 km2. It is given that a percent of the population is subscribed to a cellular system. Assuming that the cellular system is a Erlang B system with a traffic Intensity per cel of 37 Erlangs, a total spectrum of 40 MHz, and a simplex channel bandwidth of 30 kHz. The system covers the city using hexagonal cells with a diameter of 8 km and a cluster size of 7 cells. Find: a) The total number of cells in the system b) The number of channels per cell c) The total number of channels in the system d) Total number of clusters in the system

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

(c) An AM radio transmitter operating on 3.9 MHz is modulated by frequencies up to 4kHz.(i) What are the range of the upper and the lower side frequencies? (ii) What is the total bandwidth of the AM signal?
Question 1 Consider a Frequency Modulation (FM) modulator with the following parameters: Modulation index, m=1.5 Modulating signal, Vm (t) = Vm sin(271000t) V Unmodulated carrier signal, vc(t) = 20 sin (2500kt) V Using the Bessel Table in Appendix I, answer the following questions: (1) Determine the number of sets of the significant side frequencies. (ii) Determine the sideband amplitudes. (iii) Draw the frequency spectrum. (iv) (v) (vi) (vii) Determine the bandwidth. Determine the bandwidth if the amplitude of the modulating signal increases by a factor of 2.65. Assume load resistance RL =500, determine the unmodulated camic power The total power in the angle modulated wave.
A) Write the equation of the message signal and what is the instantaneous frequency B) Determine the peak phase deviation and draw the block diagram of receiver C) The bandwidth of FM waveform Solve all parts or will dislike
5 Maximum frequency. Calculate the maximum frequency which can be transmitted by a duct of 100 m height if the total change in M is of the order of 0.040.
A WBFM system has a carrier frequency of 2 kHz with 3 volts amplitude. Let the message signal be a single sinusoid as follows m(t) = 4.95 cos(18 x 10 at) %3D If the modulation index is kf ==4kV at the transmitter answer the following: %3D 1. Find the modulation index B =
Question 48 Select the appropriate response On RF based systems, a method for eradicating poor system performance on a given channel is to and change to a different channel or channels. O deploy redundant facilities increase power until performance restores change antennas O employ frequency agility Submit Response ✓
Compile a table comparing the various amplitude modulation schemes (conventional, DSB-SC, SSB-SC) in terms of their power efficiency, bandwidth requirement, and the cost and complexity of the corresponding transmitters and receivers?
A certain city has an area of 1,300 square miles and is covered by a cellular system using a seven-cell reuse pattern. Each cell has a radius of four miles and the city is allocated 40 MHz of spectrum with a full duplex channel bandwidth of 60 kHz. Compute (a) the number of cells in the service area, (b) the number of channels per cell.
B- A FM modulator is used to transmit a message with amplitude of 4 Volts and frequency of 20 Hz, the frequency deviation constant for the modulator is 25 Hz/V, and the carrier wave has amplitude 10 Volts and frequency 2000Hz. 1- What is the power of the FM modulated signal? Assume R=1Ω 2- What is the approximate bandwidth of the FM modulated signal? 3- How would your answer to part (2) change if the amplitude of message is doubled? 4- How would your answer to part (2) change if the frequency of the carrier is doubled?
We want to send the message signal m(t) = 2 sin(20nt) - 8 cos(140nt) through an AM transmitter with a carrier signal c(t) = cos(2000nt). A) Find the frequency spectrum of the modulated signal and determine the bandwidth required to send the signal. B) Get the maximum possible modulation index (to achieve maximum power efficiency)