The gas has the pressure of 120 bar and critical pressure of 60 bar, then the reduced pressure of that gas is. O a. 2 Ob.05 Oc.7200 Od.720

Q: Which of the following device used to measure pressure difference in venturimeter? O a. Bourdon tube…

A:

Q: What is the engine piston displacement in liters of an engine whose displacement is listed as 460…

A:

Q: Viscosity of oils can be measured by: a. Its maximum pressure in a journal bearing b. None of the…

A: viscosity of a fluid is defined as the resistance to flow of fluid. Some viscosity measuring…

Q: An hydrogen vapour container is mounted with a pressure gauge which shows 10 bar. Then its absolute…

A: Pressure is a vector physical quantity that represents the amount of force acting on a unit area of…

Q: Describe the Relative Pressure and Relative Specific Volume

A: Relative pressure as the term states ,is a pressure measured relative to atmospheric pressure at sea…

Q: In order to measure the blood viscosity n, we have used the below viscometer with the following…

A:

Q: Give the boundaries of the indicated valve 5.5 milliliters

A: Answer: 5.45-5.55

Q: The pressure of oil in the pipe (in kPa)

A:

Q: When pressure is 0.05 atm, what is the: The melting temperature of ice The boiling temperature of…

A: The melting point of ice decreases with decreasing pressure. At 0.05atm, the phase diagram of water…

Q: The coal consumption per hour is the ratio of heat of combustion and calorific value.

A: True

Q: aturated R-410A at a pressure of 95 psig will change at a temperature of A. 295 F B. 29 F C. 95 F D.…

A: The refrigerant is R-410A.The pressure is

Q: What should be the working pressure of a cylinder with 3 in. piston diameter so that it can balance…

A:

Q: 10. Atmospheric pressure, Stau 11. Atmospheric pressure, stated in psig, is 12. Atmospheric…

A: 10. 14.7 psi 11. 0 psi (14.7-14.7) 12. 29.9212 in Hg 13. above and below 14. inversely as long as…

Q: The wall tappings along the clear tube measure what type of pressure? O Dynamic pressure Static…

A: To choose: The correct option. Concept used: Dynamic pressure: The ratio of the kinetic energy per…

Q: The unit of discharge in liter/kg Select one: True False

A:

Q: Why do cylinders of compressed gases need to be kept upright and secured to a wall or bench top?

A: Gases that are compressed and held under pressure in cylinders are known as compressed gases. Liquid…

Q: if Op1 is 18.6 °ccw, then Os1 is . CW

A:

Q: Discuss the FRACTIONATING COLUMN in Oil Refinery Plant

A: To Explain : The fractionating column in oil refinery plant.

Q: An hydrogen vapour container is mounted with a pressure gauge which shows 80 bar. Then its absolute…

A: Given data Gauge pressure = 80 bar

Q: Why does the gauge tube bend like this ?

A: We frequently notice pressure gauges in various pipelines in our daily lives. Surprisingly, the…

Q: How is the air exhausted at the back of the piston when the piston retracts?

A: By employing a single acting air cylinder in the application rather than a more traditional…

Q: What is called to "USE OF TEMPERATURE INTERVAL OR DIFFERENCE EQUAL TO THE KELVIN

A: The link between the Celsius and Kelvin scales can be expressed mathematically as follows: K = 273 +…

Q: A pitot tube consists of two concentric tubes. The central one has an open end that measures the…

A: A pitot tube is used to measure velocity of point by using pressure difference in the tube. later…

Q: A pressure vessel contains a gas at 1200 psi. Express the pressure in pascals,

A: GIVEN = PRESSURE IS GIVEN IN PSI [POUND PER SQUARE INCH ] THAT IS 1200 PSI TO FIND =PRESSURE IN…

Q: The Pump Work is the work required to push the water into the boiler at a higher pressure

A:

Q: Given two oil According to the standard by Society Automotive Engineers the oil , by comparing the…

A: Given: Given two oil According to the standard by Society Automotive Engineers the oil , by…

Q: The wall thickness of a pipe is referred to as the pipe's __________.

A: Thickness of the pipe is nothing but the difference between outer radius and inner radius.

Q: What is the area of a rectangular air supply opening measuring 12x10?

A: Given data  Side of a rectangular = 12 × 10 Find the area of rectangular Use  Area = length × width…

Q: n valves, when normally-closed (NC) valves are non-operating, the valve is passing a. True b.…

A: Normally closed valves are manufactured in such a way that they block the flow through the values.…

Q: 5.8 bar pressure is equivalent to mm of mercury. O a. 4347.30 O b.42647.06 OC.4547949.50 O d. 4.35

A:

Q: units The unit of temperature in S.I. units is Centigrade O Celsius O Fahrenheit O Kelvin O

A: Option d is correct.

Q: Write F if True and T if False. Oxygen is the most abundant and dominant gas in the Earth’s…

A: Answer: T

Q: A window is 2 feet 7 inches across. What is the largest width air conditionerin inches that will fit…

A: Write the given data. Width of window=2 feet 7 inches=2×12+7Width of window=31 in

Q: The gage atmospheric pressure is 1 bar Select one: True O False

A: The gage atmospheric pressure is zero bar, 1 bar is a value of atmospheric pressure.  Correct option…

Q: Alm that He Cafle

A:

Q: The bore on a cylinder of a compressor is 2 inches. The stroke is 3 inches.What is the displacement…

A: Compressor Displacement is defined as the volume swept by the piston. during the revolution of…

Q: The compressor is used to increases the pressure energy of the liquid Select one: True O False

A: The answer to the above statement is True. Yes, the compressor is used to increase the pressure…

Q: Why does a free-to-move piston hold a constant pressure in the cylinder?

A: Free-to-move piston is the one in which the friction is zero and the atmospheric pressure outside…

Q: Write a brief procedure for measuring the vapor pressure of water

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.