4. A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80 degrees Fahrenheit. After some of the acetylene was used the pressure at the drum was 100 psia and the temperature was 70 degrees Fahrenheit. The used acetylene was at 14.7 psia and 60 degrees Fahrenheit . The gas constant R for acetylene is 59.35 ft-lb/lb-R. Determine:

4. A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80 degrees Fahrenheit. After some of the acetylene was used the pressure at the drum was 100 psia and the temperature was 70 degrees Fahrenheit. The used acetylene was at 14.7 psia and 60 degrees Fahrenheit . The gas constant R for acetylene is 59.35 ft-lb/lb-R. Determine:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Oxygen is heated from 700 to 1000 R. Determine the enthalpy energy change Ah of oxygen, in Btu/lbm, using the cp value at the average temperature from the table. (You must provide an answer before moving on to the next part.) The enthalpy energy change of oxygen is 218 Btu/lbm.
Which of the following is correct statement for ideal/real gases. а. intermolecular forces is neglected in real gases intermolecular forces is neglected in real gases b. intermolecular forces is considered in ideal gases intermolecular forces is considered in ideal gases O c. Volume occupied by molecules is considered in real gases O d. Volume occupied by molecules considered in ideal gases
QUESTION 2 A new induced raft cooling tower is circulating 120 000 L/h of water that is cooled from 50 °C to 22 °C. How much blow-down and make-up is required to maintain the concentration of dissolved solids in the circulating water at four times the concentration in the make-up water? Assume the following: - The evaporated water contains no dissolved solids so all solids entering the system in the make-up must be removed by blow-down and windage. - The windage value of the induced draft cooling tower is 0.3% for each 5.6 °C. - The evaporative losses value is 1.1%.
In a cylinder of an automobile engine, immediately after combustion the gas is confined to a volume of 53.0 cm³ and has an initial pressure of 3.60 × 106 Pa. The piston moves outward to a final volume of 300 cm³, and the gas expands without energy transfer by heat. (Assume the gas in the engine is diatomic with y 1.40.) (a) What is the final pressure of the gas (in kPa)? = 317.920813906 kPa (b) How much work is done by the gas in expanding (in J)? 238.559389571 J (c) What If? If the engine operates in an ideal Otto cycle and 0.0125 mol of fuel-air mixture is injected into the cylinder during the intake stroke, what are the temperatures (in K) at points A, B, C, and D of the cycle as shown in the figure? P TA TC Adiabatic C processes ΤΑ A B TB То Тр = = = || B V V2 V₁ K K K K K
A dead body was found within a closed room of a house where the temperature was a constant 24° C. At the time of discovery, the core temperature of the body was determined to be 28° C. One hour later, a second measurement showed that the core temperature of the body was 26° C. The core temperature of the body at the time of death is 37°C. A. Determine how many hours elapsed before the body was found. Answer: hours B. What is the temperature of the body 5 hours from the death of the victim? Answer: °C
1. Determine the amount of energy (kJ) that needs to be transferred to the water to raise its temperature to 140°F if a water heater is initially filled with 50 gallons of water at 64.4°F.
On some temperature scale 0oC is equivalent to 80oV and 100oC is equivalent to 250oV. Determine the temperature in oC corresponding to 200oV.
! Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the hfg of refrigerant-134a at 20°F. Use data from the tables. The gas constant of refrigerant-134a is R= 0.01946 Btu/lbm.R. Consider Clapeyron-Clausius equation for calculations. The hfg of refrigerant-134a at 20°F is Btu/lbm.
QUESTION 2 Consider a quantity of 2.0 kg of refrigerant R-134a. The refrigerant fills a 9.9 ft weighted piston/cylinder apparatus that is at a constant pressure of 29 psi. The system is then heated until it reaches a temperature of 86 °F. a.) What is the initial temperature of the refrigerant? b.) What is the final volume of the refrigerant? Note: Refer to property tables in appendix 1 of textbook Attach File Browse Local Files
A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into gaseous products. The cylinder has a piston that moves in or out, as necessary, to keep a constant pressure on the mixture of 1 atm. The cylinder is also submerged in a large insulated water bath. (See sketch at right.) 1 atm pressure piston cylinder From previous experiments, this chemical reaction is known to absorb 322. kJ of energy. water bath The temperature of the water bath is monitored, and it is determined from this data that 188. kJ of heat flows out of the gases system during the reaction. O exothermic Is the reaction exothermic or endothermic? O endothermic O up Does the temperature of the water bath go up or ? O down down? O neither O in Does the piston move in or out? O out O neither O does work Does the gas mixture do work, or is work done on it? O work done on it O neither How much work is done on (or by) the gas mixture? Be sure your answer has the correct number of…