The following data are the cross section notes at station 12+046.58 and 12+066.58. The natural ground slope is almost even. The base width for cut is 9 m while for the fill is 8 m. The side slope for cut and fill is 1:1 and 1.5:1 respectively. (a) Compute the area of the section 12+046.58 in m². (b) Compute the area of the section 12+066.58 in m². (c) Determine the difference between the volume of cut and fill in m³. ? ? Station 12+046.58 +3.0 +1.50 4.5 0 0 0

The following data are the cross section notes at station 12+046.58 and 12+066.58. The natural ground slope is almost even. The base width for cut is 9 m while for the fill is 8 m. The side slope for cut and fill is 1:1 and 1.5:1 respectively. (a) Compute the area of the section 12+046.58 in m². (b) Compute the area of the section 12+066.58 in m². (c) Determine the difference between the volume of cut and fill in m³. ? ? Station 12+046.58 +3.0 +1.50 4.5 0 0 0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Draw Thiessen Polygon
How did they get x and y values
Draw a diagonal scale 20mm: 1m up to 8m and indicate 6.74m.
5. Draw a diagonal scale 1:1000 to show 1.5 meter. Show a distance of 25.5 meters on it. Defesen
Top H Front Right Draw an isometric based on the Front, Right, and Top Views.
Determine the centroid coordinates, Xc and Yc, use table attached.
1. What is the surface texture in microinches is specified for the cylinder surface with a maximum material condition of 1.250"? Leave out the units, it is microinches, just type the number. * 2. How many dimensions are expressed using the limit method? 3. Is the sectional view a half or full section? 4. What revision is this part on? Thank you!
What are the different kinds of overlays?
Draw the three projection
Derive the Trapezoidal rule for multiple segments. Also show a graphical sketch.
Define Splices
A line AB is 40 mm long.Endpoints A & B are 20 mm in-front of Vertical Plane.Endpoints A is 15 mm above Horizontal Plane at 45 degrees.Draw projections & trace of the line.