The following cross-section notes of the road was examined to calculate volumes. Thewidth of the roadway is 12m-12-3-64+6-6+24-9STA 5+040+6-15-4.5-6-630-12-7-8STA 5+140Compute the volume between two stations using end area method.

Answered: Image /qna-images/answer/fd4ed328-9d48-4f49-9a11-deba870b7d8c.jpg

The following cross-section notes of the road was examined to calculate volumes. The width of the roadway is 12m +24 STA 5+040 +6 30 -12 STA 5+140 Compute the volume between two stations using end area method.

The following cross-section notes of the road was examined to calculate volumes. The width of the roadway is 12m +24 STA 5+040 +6 30 -12 STA 5+140 Compute the volume between two stations using end area method.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Civil Engineering Given an undivided four-lane major road and a two-lane minor road. Traffic on the…

A: The given data is: Major road vehicle speed, VA=55 mi/h Minor road vehicle speed, VB=35 mi/h…

Q: The following diagram illustrates the number of conflicting points at a 4-approach unsignalized…

A: Conflicts on roads refer to situations where vehicles and/or pedestrians interact in a way that may…

Q: Q1/ Use the following speed data collected from 2-lanes freeway section of 0.5 km under free- flow…

Q: Determine the L.O.S of the road if PHF = 0.88, D= 60%, K=0.11, V=115 kph? For an Existing 4 lane…

A: It is required to determine the heavy vehicle adjustment factor. fHV=11+PTET-1+PRER-1 Here PT is the…

Q: A two-lane highway along the border has a horizontal curve segment with radius of 656 ft (measured…

Q: An existing urban freeway in rolling terrain is to be analyzed to determine LOS using the following…

A: Given Data: Base FFS=65 mph. Number of lanes in each direction is N=3. Peak hour volume is V=3500…

Q: CALCULATE THE EXTRA WIDENING OF A PAVEMENT AND THE LENGTH OF TRANSITION CURVE NEEDED ON A TWO LANE…

Q: 55 mph roadway with two northbound through lanes (both are 11 feet in width)

Q: Q5/ A- A highway section, +2% , meet -8%at point with 52.0 m at speed 110 Km/hr. Determine the…

A: Introduction : Horizontal Curves are the first of two major transition features in highway geometric…

Q: What super-elevation rate would you recommend for a roadway with a design speed of 110 kph and a…

A: given data: f=0.11 V=110 kph radius (R)=1400 ft

Q: During the peak hour, an urban freeway segment has a traffic flow of 6,000 veh/h, with 4,000…

A: During the peak hour, an urban freeway segment has a traffic flow of 6,000 veh/h, with 4,000…

Q: 1. Use CLV analysis approach to determine the LOS and v/c ratio of the intersection (usually…

A: Given,

Q: An existing urban freeway in rolling terrain is to be analyzed to determine LOS using the following…

A: Base FFS=70 mph.Number of lanes in each direction is N = 3.Peak hour volume is V = 3300…

Q: Consider the geometric and traffic characteristics shown below. Approach (Width) North (56 ft) South…

A: Since the solution for the given question is lengthy, so the first 6 parts will be solved below.…

Q: An eight-lane freeway section is designed to have a lane width of 10 ft, right-side shoulder width…

A: Number of lanes = 8 Number of Lanes in each direction = 4 Width of lane = 10 ft Right side shoulder…

Q: A new section of Richmond Highway is being designed as a six-lane facility (three in each…

A: FFS = BFFS - flw - flc - fm - fa BFFS = Base Free flow speed = 55 mph flw = Adjustment for lane…

Q: A reversed curve with diverging tangent is to be designed to connect to three traversed lines for…

A: The given data is shown below: AB=185mBC=122.4mCD=285mAzimuth=242°and 302°No. of lanes=2Width of…

Q: Which of the following statements are correct? The theoretical minimum value of peak hour factor is…

A: Some statements regarding highway design are given. We need to choose correct statement.

Q: In the simple highway network shown, the cost function (C) depends on the link traffic flow ().…

A: Traffic flow concluded that the cost between the origin and destination in any of the path is…

Q: Subject : Transportation Engineering Read the question carefully and give me right solution…

A: Set back distance: The distance measured from the centerline of a horizontal curve to the…

Q: You are asked to: A. Determine the maximum peak-hour volume that the segment can serve at a LOS C.…

A: Given data: Lane width=3.4 m Number of lanes(N)=2 in each direction Lateral Clearance=3m 85%…

Q: Patrice's Paving Company is fine grading a 3-acre lot prior to paving using a CAT 12K with the blade…

A: Given data: Angle of blade, 30o (2 ft overlap) Speed of grader, v=2.1 mph (forward)v=2.6 mph…

Q: 6. A large residential area has 1400 households with an average household income of $40,000, an…

A: No. of households = 1400 Average household income = $40,000 Household size = 4.8 Average working…

Q: 2 A vehicle initially traveling at (75 mile/hr.), skids to a stop taking (170) m to do so. the…

A: Stopping sight distance is the length on highway which is sufficient for stopping a vehicle…

Q: A four-lane urban freeway segment has a peak demand volume of 3,500 vehicles per hour for the two…

A: Freeway: Freeway is a roadway without any signals or intersections. A freeway does not have any…

Q: A 1/2-mile, 4 percent grade section of an urban freeway is to be designed for a LOS C. Determine the…

Q: A Blank 1 is an intersection with a central island around which traffic must travel Blank 2 and in…

Q: A westbound section of freeway currently has three 12-ft wide lanes, a 6-ft right shoulder, and no…

A: LOS: LOS is referred to as the Level of Service in Highway. It explains the quality of the traffic…

Q: What is the minimum radius of a horizontal curve required for a highway

A: ###calculation for the minimum radius of a horizontal curve required for a highway###

Q: A vehicle initially traveling at (75 mile/hr.), skids to a stop taking (170) m to do so. the…

Q: A 960 m segment of 5.2 km four-lane undivided multilane highway in a suburban area is at a 1.5%…

A: It is required to determine the heavy vehicle adjustment factor. fHV=11+PTET-1+PRER-1 Here PT is the…

Q: If a four legged roundabout has 8 conflict points, how many does a 3 legged roundabout?

A: Roundabout is circular intersection which allows slow and safe traffic flow around the central…

Q: A rural collector highway located in mountainous terrain is designed to carry a design volume of…

A: Given, This question Is related to Highway & Transportation Engineering. Our aim is to answer…

Q: elp with this question.

Q: Evaluate the level of service (LOS) on a selected section of class I two-lane highway segment with…

Q: A new section of Richmond Highway is being designed as a six-lane facility (three in each direction)…

A: Given data: Deman volume, V=3120 vehhour Peak hour factor, PHF=0.95 Free-flow speed, BFFS=55…

Q: Q10: Super elevation may be defined as the raising of the existing edge of the road along a O…

A: Horizontal curve.

Q: An eight-lane freeway section is designed to have a lane width of 12 ft, right-side shoulder width…

A: Given; Lane width = 12 ft. Right-side shoulder width = 3 ft. and 3 ramps over a 2- mile- long…

Q: . Which of the following are the accepted criteria for design of valley curve for highways? 1.…

A: Valley curve are the vertical curves with Convexity downward. Valley curve are formed when 2…

Q: 4-lane urban freeway; Interchange density 1.5/mile; Directional peak flow = 1950 veh/hr; 5% trucks;…

A: Given, 4-Lane urban freeway Interchange density = 1.5/mile Directional peak flow=1950 veh/hr 5%…

Q: For the through movement of the north-bound approach, what is the minimum change and clearance…

A: Given; Travel speed = 45 mph A geometric layout with a +3% upgrade = +0.03 And a semi truck with a…

Q: Calculate the FFS at this freeway section and then determine the level of service (LOS) when the…

A: j

Question

The following cross-section notes of the road was examined to calculate volumes. The
width of the roadway is 12m
-12
-3
-6
4
+6
-6
+24
-9
STA 5+040
+6
-15
-4.5
-6
-6
30
-12
-7
-8
STA 5+140
Compute the volume between two stations using end area method.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3: Indicate why Climbing lane is suggested to be used in highway works:
Problem 3: Highway segment is going under planning review. Given the following facts: Lane Width = 3.4 m Number of Lanes (N) - 2 (in cach direction) Total Lateral Clearance = 3.0 m Median No Median The 85th % Speed was found to be 100 km/hr (i.e. BFFS = 100 km/hr) PHF - 0.83 Terrain Type: Rolling You are asked to: A. Determine the maximum peak-hour volume that the segment can serve at a LOS C. B. Make suggestions on how to increase the total capacity while maintaining the LOS at C without major investments.
A 960-m segment of 5.4-km six lane divided TWLTL multilane highway in a suburban area is at a 1.5% grade. The highway is in level terrain and lane widths are 3-m. The peak-hour volume is 3500 veh/hr/In, PHF is 0.90, and there are 13% trucks and 2% RVs. Determine the LOS for the following: (a) extended directional segments (b) 3% upgrade(c) 4% downgrade
For the following conditions: Design speed 60 mph, V/C ratio = 0.6, Level of service = Curve radius, 955 ft, Time value = $4/hr. If the basic section cost for passenger cars on a multilane highway is $206/KV-M, estimate the highway grade. B, %3D
A new basic freeway segment will have 3 lanes in each direction. The left and center lane each has a width of 12 ft while the width of the right lane is 13 ft. The left shoulder is 4 ft while the right shoulder is also 4 ft. There are 2 interchanges within 6 miles (3 miles upstream and 3 miles down stream).The site has level terrain, the design speed is 80 mph the hourly design volume is 5250 veh/h, which includes 9.0% trucks and buses. The peak hour factor is 0.870. Calculate FHV, VP, FFS, LOS Show all work
A 960-m segment of 5.4-km six lane divided TWLTL multilane highway in a sub-urban area is at a 1.5% grade. The highway is in level terrain and lane widths are 3-m. The peak-hour volume is 3500 veh/hr/ln, PHF is 0.90, and there are 13% trucks and 2% RVs. Determine the LOS for the following: (a) extended directional segments (b) 3% upgrade Please include complete solution
During the peak hour on a Class I two-lane highway, volumes northbound are 1200 veh/h and volumes southbound are 400 veh/h. The PHF is 0.95, and there are 14% trucks/ buses and 4% RVs. Lane widths are 3.35-m, and shoulder widths are 1.2-m. The roadway section is 8-km in length, and there are 12 access points per mi. There are 50% no-passing zones and the base free-ﬂow speed is 96 km/h. Determine the base percent time following in the direction analyzed in percent. Assume Level terrain.
|-90 crosses the Snoqualmie River at about milepost 47.5. Here, the eastbound portion of the Interstate has the following characteristics: • Rural freeway classification • No HOV lanes • 12 ft lane width • 10 ft right-side shoulders • 4 lanes (there are 3 lanes going westbound for a total of 7 lanes) • 0.80 interchanges per mile • Volume = 2,800 vehicles/hour • Peak hour factor 0.98 • 18% trucks and buses • 2% recreational vehicles • 4% upgrade for 0.80 miles • Driver population %3D adjustment factor = 1.0. Free flow speed for this section of freeway (to the nearest mile per hour) will be. . 80 mph 65mph 55 mph 73 mph
Consider the three level sections shown in Table 1. i) If the width of the road, b=12 m, calculate the slope of the side slopes of the sections. ii) If the combined volume of the given sections has been calculated using the Average End Area method and is given as 215813 m3, correct this volume using the prismoidal volume correction formula
10. Compute the total volume in cubic meter using Average-End Area Method. Solution must be in Basket Method. The answer should be Round off to two decimal places. Draw the figure.
SOLVE FOR G ONLY. Complete solution.
4. Four-leg intersection on Rural 4-lane highway; Major highway volume = 150 veh/hr/In; Left-turn volume= 15 veh/hr/ln; Use Guideline given in NCHRP Report 745, determine whether a left-turn lane is recommended? 5. 4-lane highway; Major road grade = 2.7%; Minor road approach grade = 4%; Vmajor = 55 MPH; Find left turn and right turn departure sight distances for a passenger car.