The figureshows a copper rod that is placed in an aluminum tube. The rod is 0.005 in. longer than the tube of length L = 10.77 in. Find the maximum safe load P (in lb with four decimal places) that can be applied to the bearing plate, using the following data: area of copper = 2.09 sq, in.   area of aluminum = 3.13 sq, in.  E of copper = 17082712 ksi   E of aluminum = 10068197 ksi   allowable stress for copper = 19884 ksi    allowable stress for aluminum = 10200 ksi

Q: If load P = 20.1 kips, determine the normal force in bar (1). A 6 ft 46.6 kips 39.5 kips 33.5 kips…

A:

Q: the ground and free in the upper end. a) Calculate the compressive stress, then the minimum…

A: Given Data: H=3 mm=1000 kgFOS=3σut,c=241 MPaE=190 GPa   To Find: (a) The compressive stress. (b) The…

Q: 1. A vertical column with pinned ends is subjected to an end load P. The column has a radius of…

A:

Q: Calculate the largest load p on AB in order to keep AC safe:

A: Uniformly distributed load:- Force is evenly distributed over the span of beam It is given that,…

Q: An L-shaped bracket is supported by a frictionless pin at A and a cable between points B and D. If…

A:

Q: The rigid pipe is supported by a pin at A and an A-36 steel guy wire BD. Figure 4 ft 3 f 1 of 1 >…

A:

Q: QUESTION 13 The compound steel bar shown in Figure is made of three uniform segments marked as 1, 2…

A:

Q: A 10 ft long steel member with pinned ends (i.e., pinned-pinned) is used as a column. The member…

A: From question, Length of steel shaft, L = 10ft=10×12 inch= 120 inch Thickness of member…

Q: A rod with a cross-sectional area of A and loaded in tension with an axial force of P = 9800 N…

A:

Q: The axial assembly consists of a solid 1.03-in.-diameter aluminum alloy [E = 9700 ksi, v = 0.24, a =…

A:

Q: 1. A frame is shown to the right. The link BC is t = 6mm thick (into the page) and has width, w…

A:

Q: Give the following problem a try. If you get stuck, here is one way to work it: Essential Solution…

A:

Q: Use the Method of Sections to find the load in member EK of the bridge. Is it in tension or…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.