The figure shows three blocks attached by cords that loop over frictionless pulleys. Block B lies on a frictionless table; the masses are ma = 6.70 kg, mg = 6.20 kg, and mc = 12.0 kg. When the blocks are released, what is the tension in the cord at the right?
Q: An athlete pulls box E using an inextensible rope P while being resisted by another inextensible…
A:
Q: A 16 kg block rests on a 29 degree inclined frictionless surface and is attached by a light string…
A: Solution:-Given thatm1=16 kgm2=29 kgg=9.8 m/s2Inclined surface-frictionlesspulley-massless &…
Q: A cand passing ever a pulley connects two masses, as shown, where m, -3.60 kg and m.640 ka. The…
A: Given Data : The mass of block 1 is given as m1 = 3.60 Kg. The mass of block 2 is given as m2 = 6.4…
Q: A small object with mass 0.200 kg swings back and forth on the lower end of a light rope that is…
A: Given : Mass (m) = 0.20 kg Length of rope (L) = R = 3.0 m Speed of object (v) = 3.30 m/s…
Q: A small box of mass ?= 1.20 kg sits on a horizontal frictionless surface. A constant force ?⃗ is…
A:
Q: Two boxes, AA and BB, are connected to each end of a light vertical rope, as shown in the following…
A:
Q: Lili pulls a 6.00-kg crate across a horizontal floor for a distance of 3.00 m as shown. The tension…
A:
Q: A ball hangs from a 1.25 m string. If it is given a push at the bottom, what is the minimum speed…
A:
Q: Two blocks are arranged at the ends of a massless string as shown in the figure. The system starts…
A: Given m=4.36kg, M=5.77kg. Let a be the acceleration of the system. From the FBD of mass m, T - mg=-…
Q: Due to a jaw injury, a patient must wear a strap that produces a net upward force of 5.00 N on his…
A:
Q: One end of a rope is tied to a 11 kg hanging weight. The rope goes over a pulley and the other end…
A:
Q: ace attached to a pulley on the edge of the table where M2 is a block hanging off of this pulley.…
A: Given:- M1=128.41 g = 0.12841 kg , M2=49.80 g = 0.04980 kg Xi=33.50 cm= 0.3350 m , Xf=88.70 cm=…
Q: Mary applies a force of 75 N to push a box with an acceleration of 0.43 m/s?. When she increases the…
A:
Q: **11. The three blocks in the figure are on a frictionless surface. If F= 48.0 N, m₁ = 2.0 kg, m2 =…
A: Given: The applied force F is 48 N. m1=2 kgm2=1.5 kgm3=3.5 kg
Q: Three strings are attached a same middle point. String A goes out and down from the point at an…
A:
Q: A spider hangs from the junction formed by three strands of silk, as shown in the figure. The force…
A: According to Lami's theorem ,if three forces acting at a point are in equilibrium then each force is…
Q: Two boxes are connected to each other by a string as shown in the figure. The 10-N box slides…
A:
Q: A cow is pushing its baby from side of the farm to another. The floor of the farm is not…
A: we know that the net force is equal to the product of the mass and acceleration. the acceleration is…
Q: A rescue helicopter lifts a 57.7-kg person straight up by means of a cable. The person has an upward…
A:
Q: A weight of 800 N is suspended at a height of 6 meters above the ground. Julia, an acrobat weighing…
A: Given data: Weight (W1) = m1g = 800 N Height (h1) = 6 m Weight (W2) = m2g = 600 N Required: Height…
Q: Three blocks are connected as in the figure with mA=2 kg, mB-4 kg, mc-5 kg, and 0-5°. The inclined…
A:
Q: Fernanda is standing on a scale while riding an elevator. The elevator accelerates upward from rest…
A:
Q: A piece of string is hanging from a rod of 5 m as shown below. A 4500 N weight hangs from the…
A: The tension is the force that acts at both extremities of the string. This force helps to elongate…
Q: i need help with this please
A:
Q: M1=4 kg and m2=7kg. The system accelerates with a magnitude of .89 m/s2. The coefficient of kinetic…
A:
Q: Two blocks, M₁ and M₂, are connected by a massless string that passes over a massless pulley. M₁ has…
A:
Q: A man pushes a m = 3.20 kg block a distance d = 7.40 m along the floor by a constant force of…
A: As per guidelines, the first question is answered. For the remaining questions to be answered, post…
Q: A 17 kg block rests on a 32 degree inclined frictionless surface and is attached by a light string…
A:
Q: The drawing shows box 1 resting on a table, with box 2 resting on top of box 1. A massless rope…
A:
Q: The figure to the below shows a mass, m₁=7.80 kg, on a frictionless incline with an angle 32.2º. It…
A:
Q: Two weights are connected by a massless wire and pulled upward with a constant speed of 1.50 m/s by…
A: Given data *Weight of upper block, m1g = 25 N *Weight of lower block, m2g = 100 N *The given tension…
Q: F A Rope 1 В Rope 2
A:
Q: how large does m have to be to start the blocks moving? Please answer in kilograms.
A: When the block is about to start friction will be maximum and the forces on mass M will be balanced
Q: Lili pulls a 6.00-kg crate across a horizontal floor for a distance of 3.00 m as shown. The tension…
A:
Q: A 3 kg body is connected via an inextensible cable to a 1 kg body. A 30 N force at 37 degrees to the…
A:
Step by step
Solved in 2 steps with 1 images
- A 41.0-kg child swings in a swing supported by two chains, each 3.04 m long. The tension in each chain at the lowest point is 348 N.Two blocks connected by a rope of negligible mass are being dragged by a force at a 21° angle above horizontal (see figure below). Suppose F = 117.0 N, m, = 10.0 kg, m, = 26.0 kg, and the coefficient of kinetic friction between each block and the surface is 0.136. Use g=9.8 m/s?. T F (b) Determine the acceleration of the system. X m/s2 (c) Determine the tension T in the rope. X NA 250 gram block on a 30 deg inclined plane is attached by an inextensible string going over a frictionless pulley to a 500 gram hanging weight. The static and kinetic friction coefficients are .25 and .123. While moving, what is the tension ii the connecting string? O 174530 dynes O 121000 dynes O 262400 dynes O 7430 dynes O 42930 dynes
- A child's swing is held up by two massless ropes tied to a tree branch. The distance between the ropes at the top of the swing is less than the distance between the ropes at the bottom, so that the ropes hang 14.01° from the vertical (see the picture). If the tension in each rope is 2.4 N, what is the weight of the swing?Your 10.0kg cell phone on a frictionless table is accelerated by a 5kg mass hanging from a table. How much time do you have to grab the cell phone if it is 25cm from the edge of the table? The rope and pulleys are frictionless and massless.A drag chute must be designed to reduce the speed of a 1171 kg dragster from 342 km/hr to 80 km/hr in 4 seconds. Assume that the drag force is proportional to the velocity (kv). a) What value of the drag coefficient k is needed to accomplish this? kg · s? (Leave an exact answer.) m2 k = b) How far (in meters) will the dragster travel in the 4-sec interval? d = meters. (Round to the nearest meter) Question Help: O Message instructor Submit Question
- An elevator has a mass of 200kg. An average person has of 40 kg. The elevator must accelerate upward at 3 m/s^2. If the elevator cable is capable of supporting 6500 N of tension before it breaks. What is the maximum number of people you could have on board?Computation. The figure below shows a system comprised of three blocks, a light frictionless pulley, and ideal ropes. Mass B is on a frictionless table and the coefficient of kinetic friction between blocks A and B is uk -0.145. When released from rest, block C accelerates downward. Find the magnitude of its acceleration if mA=1.99 kg, mg-1.88 kg, and mc =5.49 kg. a = MA MB m/s² OL Record your numerical answer below, assuming three significant figures. mc Dea @ * GO 10:14 PM 10/19/2022Two blocks of mass m, = 10 kg and mg = 5 kg are connected by a massless string that passes over a pulley as shown in the figure. The system is in static equilibrium. There is friction between m, and the inclined surface (u.-0.4), Neglect the friction between the string and the pulley. Determine the tension in the string. 10 kg 5.0 kg 37 65.35 N () 147.0 N 98.0 N 49.0 N O 52.3 N
- Two blocks of mass m1 = 3.0kg and m2 = 2.5kg are attached with a rope. The rope goes around several ideal pulleys. Two of the pulleys are attached directly to the ceiling (grey shaded region at the top) and will not move up or down. The lower pulley will move with block 1. Block 1 is free hanging and will move vertically. Block 2 rests on an inclined ramp at angle θ = 30°. The ramp is frictionless. Block 1 is observed to accelerate upwards. The experiment is done on earth, g = 9.8 m/s2 What is the tension in the long rope? by using variables onlyThe chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T₁ is 3.4 kN when 0 = 33°, determine the force P required on the lever and the corresponding tension T₂ for this position. Assume that the surface under A is perfectly smooth. Assume a = 100 mm, b = 460 mm. T₁ Answers: P = T₂ = i i 9 A B KN 2 KN 2 b Topoces T₂Two masses of weight 30.0 NN are suspended at opposite ends of a rope that passes over a light, frictionless pulley. The pulley is attached to a chain that goes to the ceiling. What is the tension in the rope? What is the tension in the chain?