The figure shows a shaft carrying three gears that rotates at 1150 rpm. Gear A delivers power to a mating gear that drives a mixer. Gear C delivers power to a different mating gear that drives a circular saw. All power comes into the shaft through gear B. Draw sheardiagramand bending moment diagram . Considering only torsion, compute the shearing stress in each part of the shaft. Consider stress concentrations, assume the Material is 1144 OQT 1300,And GearA=10kw, Gear C=15kw.

Q: The shaft in the figure below is part of a drive for an automated transfer system in a metal…

A:

Q: Design the outside and inside diameters for a hollow stell shaft subjected to a torque of 1,000,000…

A: Given data: The torque applied is, T = 1,000,000 lb-in. The shear stress developed, τ = 8,000 psi.…

Q: A circular shaft with 50mm and its lenght is 850mm long and is made of steel, the shaft is subjected…

A: GIVEN :- diameter : d=50mm length: L=850 mm Torque subjected: T=800Nm (to determine θ we need the…

Q: Compute the torsional shear stress in a circular shaft with a diameter of 50 mm that is subjected to…

A: GivenT=800 Nmd=50mm=0.05 mFormulaσT=16Tπd3

Q: A gear train is composed of four helical gears with the three shaft axes in a single plane, as shown…

A:

Q: Problem 2: A solid circular drive shaft with a diameter of 0.5" transmits a torque of 200 in-1bf and…

A: The diameter of the shaft, Transmitted torque, The maximum bending moment, The yield strength of…

Q: A drive shaft is made of a hollow tube with an outer diameter of Do 2.5 in. It is desired to…

A:

Q: an aluminum shaft is 6ft. and has toruq of 500 lb-ft. the shear stress is 6500 psi and the angle of…

A:

Q: what is the Moment at point A

A: First find the moment produce by given torque as follows.

Q: A planetary gear used on the Mars rover uses a 25-tooth helical gear with ψ = 20° has a 25° pressure…

A: Given Data The number of tooth are: N=25 The angle of the thread is: ψ=20° The pressure angle is:…

Q: Section 12-1 to 12-6 For the shaft subjected to the external torque in each of Figs. P12-1 to P12-6,…

A:

Q: In the double-reduction gear train shown (dimensions are in inches), shaft a is driven by a motor…

A: Step 1: Step 2: Step 3:

Q: A B 55² 240 N.mm 420 N.mm 300 N.mm 480 N.mm Figure 1 - Torques applied to the driveshaft 1) DERIVE…

A: Find the  Angle of twist expression Shaft diameter Maximum shear stress

Q: The figure shows a shaft carrying three gears that rotates at 1150 rpm. Gear A delivers power =10kw…

A: Given, Gear A deliver 10KN Gear C deliver 15KN A shaft carrying 3 gears that rotates at 1150 rpm…

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.