the figure below shows a fixed horizontal conductor passing through the poles of a permanent magnet, being equidistant from them.The magnet is placed on a scale.When no current flows in the conductor, the scale shows 102.45 grams.When in the conductor current flows with intensity 4 amps, the scale shows 101.06 grams. The length of the conductor part located inside the field is 5cm. Calculate the induction value of the magnetic field.

the figure below shows a fixed horizontal conductor passing through the poles of a permanent magnet, being equidistant from them.The magnet is placed on a scale.When no current flows in the conductor, the scale shows 102.45 grams.When in the conductor current flows with intensity 4 amps, the scale shows 101.06 grams. The length of the conductor part located inside the field is 5cm. Calculate the induction value of the magnetic field.

Similar questions

A circular region 4.00 m in radius is filled with an electric field perpendicular to the face of the circle. The magnitude of the field in the circle varies with radius and time as E(r, t) = Arcos (@t) where A = 1000. V/m² and w = 3.00 x 10⁹ s¨¹. What is the maximum value of the magnetic field at the edge of the region? i T
A 2800-turn circular coil of wire has an area of 2.270 x 10-2 m2. It is placed with its axis along the direction of the Earth's magnetic field. Assume that the magnitude of the magnetic field of the earth at that location to be 61 x 10-6 T. a) What isthe magnitude of the voltage induced in the coil if you can flip the coil by 180° in 0.185seconds? Provide the answer in Volts. b) What is the magnitude of the voltage induced in the coil if you can flip the coil by 90° in 0.185seconds? Provide the answer in Volts.
An electrically conductive rod is moving through a uniform magnetic flux at a constant velocity at right angles, as shown by its cross-section in the diagram. The velocity is in the x-direction, the rod is of length 150 mm along z, and the magnetic flux density is 0.2 T in the positive y-direction. Speed If the potential difference (voltage) across the ends of the rod is 5.8 Volts, what is the magnitude of the velocity? m/s Not perpendicular If the rod is passing through the flux with its axis not at right angles what can you be sure of? The speed to generate 5.8 V would have to be smaller. • The speed to generate 5.8 V would have to be bigger. The speed to generate 5.8 V would be the same.
A rectangular loop of wire is moving toward the bottom of the page with a speed of 0.020 m/s. The bottom part of the loop is outside the region. The field strength inside the region is 2.4 T and the magnetic field outside the region is and the magnetic field outside the region is zero. The width of the loop is 0.080 m and the length is 1.0 meter. What is the current induced in the wire if the resistance of the loop is 0.12 ohm?
Consider the Hall voltage induced on a patient’s heart while being scanned by an MRI unit. l = 8.5 cmv = 7.5 cm/s Approximate the conducting path on the heart wall by a wire 8.5 cm long that moves at 7.5 cm/s perpendicular to a 1.50 T magnetic field. Find the Hall voltage across the patient's heart in mV.
A 48 turn coil of wire creates a circular area of 6.95 cm2. If a magnetic field of 90.79 T hits this area at a right angle, what is the magnetic flux (in Wb) through the coil?
AM Mon Nov 7 bconline.broward.edu b) 2.1 nT c) 1.6 nT d) 3.1 nT e) 3.6 nT 48 6. The electric field amplitude of the signal at that point is 0.780 V/m. What is the amplitude of the magnetic field of the signal at that point? a) 2.6 T 67% 1
The magnetic field of the Figure below decreases from 1 T to 0.4 T in 1.2 s. A 6 cm diameter conducting loop with a resistance of 0.01 Ω is perpendicular to magnetic field as shown. What are the size and direction of the current induced in the loop?
The magnetic field in a region of space is given by B-8 +8. A coil of N turns is oriented so that its cross-sectional area is in the x direction: A-A1. A small bulb is connected across the ends of the coil. The total resistance of the coil and the bulb is R. Find an expression for the current through the bulb if By(t) = Bo(t/to) and By-Bo where Bo and to are constants. (Use the following as necessary: A, B, N, R, to, and t. Enter the magnitude.)
A circle wire loop with 10 turns of wire has an area of 0.5 m2. It is initially in a 0.3 T magnetic field. Then over 0.5 seconds it is moved to a location with no magnetic field. What is the magnetic flux? (The unit of flux is Weber, W) What is the induced emf (voltage)?