Answered: the enthalpy of air is increased by 140…

the enthalpy of air is increased by 140 kJ/kg in a compressor. the rate of air flow is 16.42 kg/min. the power output is 48.2 kW. what is the heat loss from the compressor? in kW

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter37: Air Distribution And Balance

Section: Chapter Questions

Problem 2RQ: The two ways that fresh air enters a structure are _______and_____.

See similar textbooks

Related questions

Q: rate of 15 m3³/s. If heat is lost from the gas in the duct to the surroundings at a rate of 51 kW,…

A: Given data; A gas is heated in a duct as it flows over a resistance heater, consider electric…

Q: A garden hose attached with a nozzle is used to fill a 10 liter bucket. The inner diameter of the…

A: Here,Volume flow rate,V= 10 litre50 s=0.2 l/s=(0.2×0.0353)ft3/s=0.00706 ft3/sNow,Mass flow…

Q: A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors…

A: Given data: *The diameter of the duct is constant. *The density of the air at inlet is ρi=1.2…

Q: 2. At a certain location, wind is blowing steadily at 10 m/s. Determine the mechanical energy of air…

A: iven: v = 10 m/s density = 1.25 kg/m3 diameter = 60 m

Q: Wind blows steadily at 7 m/s into the blades of a wind turbine. Compute the actual electric power…

A: Given data, V= 7m/s D= 80 m So area A = π*802/4 = 5026.55 m2 R= 1.25 kg/m3 n= 30% = 0.3

Q: Q1/ The air circulation in a large room by using fan (10 hp). Assuming a well-insulated, sealed room…

A: Given, Large room is well-insulated. Hence, heat transfer to and from room is zero. Hence, δQ = 0.…

Q: garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the hose…

A: Given Data The volume of the bucket is: V=40 L The inner diameter of the hose is: d=2 cm=0.02 m The…

Q: An air compressor takes in air at 128 kPa at the rate of 0.87 m^3/sec, and discharge 685 kPa.…

A: Calculated power of compressor in kW.

Q: Q1:A pump is to increase the pressure of 200 L /s of water by 4 MPa. The water enters through a…

Q: The mass flow rate of refrigerant entering the compressor is 0.25 kg/s and the change of enthalpy…

A: As per given question Refrigerant mass=0.25 kg/s Change enthalpy between =320kj/kg Motor power=134…

Q: 2. At a certain location, wind is blowing steadily at 10 m/s. Determine the mechanical energy of air…

Q: The enthalpy of air is increased by 139.586 KJ/kg in a compressor. The rate of air flow is 16.42…

Q: For constant-volume systems, the total actual and useful works are identical (Wu = W).

A: For constant-volume systems,

Q: Helium is used in the Carnot engine where the volumes beginning with constant temperature heat…

Q: If velocity of entering air and jel are 150 m/ s and 350 m/s, the thrust power will be equal to…

Q: The mass flow rate of the gas in a gas turbine is 40 kg/s. The specific enthalpy and velocity in the…

Q: A fan is powered by a 0.5-hp motor and delivers air at a rate of 85 m3 /min. Determine the highest…

A: Given data : Since the mass crosses the system boundary, consider the motor and fan assembly, and…

Q: The approach and efficiency of cooling tower are 10 oC and 65 %, respectively. If the temperature of…

Q: A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors…

A: Flow rate: the amount of fluid flowing through a particular cross-section per unit time is known as…

Q: A fluid flows at 450 ft/s with specific volume of 12.8 ft3 /lbm, pressure of 14.7 psia and specific…

Q: Consider a device with one inlet and one outlet. If the volume flow rates at the alet and at the…

Q: Water is flowing through a horizontal pipe. Water enters the left side of the pipe at a pressure P =…

Q: A 0.2 m³ vessel contains 120 kg of water at 90 °C. Determine pressure, specific and total internal…

A: Given data:

Q: If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7…

Q: 1. Steam flows into a turbine at the rate of 10 kg/s and 10 kW of heat are lost from the turbine.…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: 1.8 kg/s of steam expands in a turbine producing 550 kW of power output. The steam enters at a…

Q: Consider a wind turbine that is situated in an area that has steady winds. The turbine rotates at 16…

Q: The driving force for fluid flow is the pressure difference, and a pump operates by raising the…

A: As per given data, del P = 5 kpa, power input = 7 kw. maximum volume flow rate Q (m^3/s) = ? for…

Q: A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors…

A: Given data: The subscript “i” is used for the inlet conditions and subscript “e” is used for the…

Q: 2. Air flow steadily at the rate of 0.5 kg/s through air compressor, entering at 7 m/s speed, 100…

A: Given Data The mass flow rate is: m=0.5 kg/s The inlet velocity is: v1=7 m/s The inlet pressure is:…

Q: Consider the flow of air over the wings of an aircraft. Is this flow internal or external? How about…

A: Internal flow –when the flow is completely bounded by the surface then this type of the flow is…

Q: A vehicle travelling at 100 km/h has air passing through its radiator at the rate of 100 kg mol per…

A: Given: The vehicle speed, v = 100 km/h The air flow rate through radiator, ma = 100 kg mol/min The…

Q: At the inlet to a certain nozzle the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60 m/s.…

Q: The water level in a tank is 10 m above the ground. A hose is connected to the bottom of the tank,…

Q: When a fan is operated at 1200 rpm the input power is 5 kW. If the speed is increased to 1300 rpm…

A: Power P=5 kWN1=1200 rpmN2=1300 rpmTotal pressure(h) =250 m of airρair=1.20 kg/m3So P=ρairgh…

Q: Hw : The ventilating building has a volume flow rate of 30 Lis and runs continuously. kg/m,…

Q: Consider a wind turbine that is situated in an area that has steady winds. The turbine rotates at 16…

A: GIVEN Number of rotation of turbine N=16RPM Mass flow rate through turbine m=41025kg/s Tip velocity…

Q: Air enters a gas turbine systenm with a velocity of 105 m/s and has a specific volume of 0.8m/kg.…

A: Air inlet velocity, V1=105 m/s Specific volume of air at inlet, v1=0.8 m3/kg Inlet area of gas…

Q: . The mass flow rate of the gas in a gas turbine is 40 kg/s. The specific enthalpy and velocity in…

A: Given Data Mass flow rate of the gas, m=40 Kg/s h1=1300 KJ/kg v1=160 m/s h2=350 Kj/Kg v2=50 m/s…

Q: An air compressor handles 8.5 m3/min of air with a density of 1.26 kg/m3 and a pressure of 1 atm,…

Q: A 0.2 m³ vessel contains 188kg of water at 90 °C. Determine pressure, specific and total interna…

A: Given:V=0.2 m3m=188 KgT=90°C

Q: steam turbine receives a steam flow of 1.35 kg/s and the power output is 500 kW. The heat loss from…

Q: Air at 2.50 kg/m3 enters a nozzle that has an inlet-toexit area ratio of 2:1 with a velocity of 120…

A: Given, Inlet density of the air ρ1=2.50kg/m3 Outlet density of the ait= ρ2 Inlet velocity V1=120m/s…

Q: ive hundred kilograms per hour of steam moves a turbine. The steam enters the turbine at 44 atm and…

A: Solution :- Given data :- mass flow rate m˙ =500 kg/hr =5003600…

Q: and 82 percent for the turbine, determine (a) the air temperature at the turbine exit, (b) the net…

A: given data minimum temperature = 310 K Maximum temperature = 1160 k pressure ratio =8

Q: In a centrifegal compressor air flows steadily at a rate of 2,1 kg/s and 81,00m/s with a pressure of…

Q: 2. Air whose density is 0.078 enters the duct of an air-conditioning system at a volume flow rate of…

A: Given data as per question Density of air =0.078 lbm/ft3 Volume flow rate =450 ft3/min Diameter of…

Q: 1.8 kg/s of steam expands in a turbine producing 550 kW of power output. The steam enters at a…

Question

100%

the enthalpy of air is increased by 140 kJ/kg in a compressor. the rate of air flow is 16.42 kg/min. the power output is 48.2 kW. what is the heat loss from the compressor? in kW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

The enthalpy of air is increased by 139.586 BT/lb in a compressor. The rate of air flow is 16.42 lb/min. The work done tot he compressor is 58.2 hp. What value most nearly equals the heat loss from the compressor in KW?
The enthalpy of air is increased by 139.586 KJ/kg in a compressor. The rate of air flow is 16.42 kg/min. The power input is 48.2 KW. How much is the heat loss from the compressor in KW?
The enthalpy of air is increased by 139.586 KJ/kg in a compressor. The rate of air flow is 16.42 kg/min. The power input is 48.2 KW. Determine the heat flow in KW. pls include in the equation what is energy in and energy out
The mass flow rate of the gas in a gas turbine is 40 kg/s. The specific enthalpy and velocity in the inlet are 1300 kJ/kg and 160 m/s respectively while the outlet are 350 kJ/kg and 50 m/s respectively. Calculate for the work of the turbine if there is a heat loss of 1000 kW. (kW)
The enthalpy of air is increased by 139.586 KJ/kg in a compressor. The rate of air flow is 16.42 kg/min. The power input is 48.2 KW. Determine the heat flow in KW. pls show how you derive your formula
What is the work of the compressor in KJ/kg?
Turbo machines . The density of water is 999 kg/m3
Three boilers have capacities of 200 kg/hr and 250 kphr. If 150.000 kg of coal are supplied to three boilers for 10 days. What is the capacity of the third boiler?
3. The power requirement of a fan in kW in order to supply air at a rate of 500m3/h at a total discharge pressure of 0.5psia in kW is
Water is pumped from a lake to a large storage tank that is onthe top open to the atmosphere. The water surface in the tank is 20 m above the water surface of the lake. The volume flow is 50 litres/s and 15 kW of electrical power is used for it. Disregard losses in flow energy due to friction and from changes in the kinetic energy of the water. Use ρ = 997 kg/m3as mass density for liquid water.a) Calculate the total efficiency of the pump-motor unit.b) Calculate the pressure difference between inlet out outlet ofthe pump needed to pump the water up to the idea.
A pump is used to raise the pressure of water from 0 psig to 55 psia. How much power (in kW) will be required to pump 1.5ft3/s of water? What is the effect of the water temperature on the pump power that is required? a. Sketch the problem. b.Draw lines identifying the control volume, or control mass. c.Identify the states with numbers, letters, or descriptions such as “in” and “out”. d.Write down the knowns and unknowns. e.Identify what is being asked for. f.State all assumptions.
A turbine produces a power of 7500 ft-lbf/s. Calculate thepower in hp and in watts.