The drag force, Fd, imposed by the surrounding air on a vehicle moving with velocity V is given by Fd= Cd ApV²/2 where Co is a constant called the drag coefficient, A is the projected frontal area of the vehicle, and p is the air density. An automobile is moving at V = 30 miles per hour with C = 0.28, A = 24 ft², and p = 0.075 lb/ft³. Determine the force, in lbf, and the power, in hp, required to overcome aerodynamic drag.

The drag force, Fd, imposed by the surrounding air on a vehicle moving with velocity V is given by Fd= Cd ApV²/2 where Co is a constant called the drag coefficient, A is the projected frontal area of the vehicle, and p is the air density. An automobile is moving at V = 30 miles per hour with C = 0.28, A = 24 ft², and p = 0.075 lb/ft³. Determine the force, in lbf, and the power, in hp, required to overcome aerodynamic drag.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

32. Fine-grained materials have stress-hardening properties. a. True b. False
PP RT ㅇㅈ? др a. Ə 2.?
The below column (diameter 1 in.) is subjected to a compressive force where the diameter is increased by 0.0001 in. Determine the shear modulus G of the material. Assume that the material behaves elastically with E= 10000 ksi. P=100Kips L- 12' TOSHIBA
Question 3 10 points V Sav The basic principle to select a material for a product is to use a material with properties that meet or exceed the product performance requirements, and keep the cost of the product as low as possible to use a material with properties that meet the product performance requirements, and keep the cost of the product as low as possible to use a material with properties that exceed the product performance requirements as much as possible, and keep the cost of the product as low as possible to use a material with properties that meet or exceed the product performance requirements, and keep the cost of the material as low as possible
Question 12 Based on the diagram below, calculate the stress at each hole, assuming that the holes are sufficiently far apart that their effects do not interact. Thickness 0.50 in 1.40 in .0.72-in L0.40-in 0.50-in dia. 6200 lb dia. dia. Axial tensile force
Q/ Correct the under line words 14. Al-4%. Mg alloys are produced by extrusion because has high strength 15. Mg -Zn - Zr alloy is not proper to produce by extrusion because of susceptible to micro porosity and can be used for casting process 16. Brass-alloys are expensive because of difficulties experienced of its casting 17. The density, T.S. and hardness of Fe alloys can be decreased by working
Aluminum shell 10 in. 1 in. Steel core 2.5 in.
_% od 25m is 9m
How is the ideal column determined?
F126KN 180KN 26 -3m 1.5m 48 65° 145KN V165 KN
=DF=20.033 N d=12m Find mark done.
9) Straight gibs are adjusted by screws spaced out along the length of the gib. Select one: True False