The diagrams show three circuits with identical batteries, identical inductors, and identical resistors. Rank them according to the current through the battery just after the switch is closed, from least to greatest and also rank them according to the current through the battery after a long time has passed, from least to greatest. 2 3

The diagrams show three circuits with identical batteries, identical inductors, and identical resistors. Rank them according to the current through the battery just after the switch is closed, from least to greatest and also rank them according to the current through the battery after a long time has passed, from least to greatest. 2 3

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Inductance

Section: Chapter Questions

Problem 32.4OQ: In Figure OQ32.4, the switch is left in position a for a long lime interval and is then quickly...

See similar textbooks

Similar questions

The 5.00 A current through a 1.50 H inductor is dissipated by a 2.00 ( resistor in a circuit like that in Figure 23.44 with the switch in position 2. (a) What is the initial energy in the inductor? (b) How long will it take the current to decline to 5.00% of its initial value? (c) Calculate the average power dissipated, and compare it with the initial power dissipated bythe resistor.
Construct Your Own Problem Consider a double transformer to be used to create very large voltages. The device consists of two stages. The first is a transformer that produces a much larger output voltage than its input. The Output of the first transformer is used as input to a second transformer that further increases the voltage. Construct a problem in which you calculate the output voltage of the final stage based on the input voltage of the first Stage and the number of turns or loops in bath parts of both transformers (four coils in all). Also calculate the maximum output current of the final stage based on the input current. Discuss the possibility of power losses in the devices and the effect on the output current and power.
Integrated Concepts Hydroelectric generators (see Figure 20.43) at Hoover Dam produce a maximum current of 8.00 103 A at 250 kV. (a) What is the power output? (b) The water that powers the generators enters and leaves the system at low speed (thus its kinetic energy does not change) but loses 160 m in altitude. How many cubic meters per second are needed, assuming 85.0% efficiency?
What percentage of the final current I0 flows through an inductor L in series with a resistor R, three time constants after the circuit is completed?
In Figure OQ32.4, the switch is left in position a for a long lime interval and is then quickly thrown to position b. Rank the magnitudes of the voltages across the Four circuit elements a short time thereafter from the largest to the smallest.
Unreasonable Results A 25.0 H inductor has 100 A of current turned off in 1.00 ms. (a) What voltage is induced to oppose this? (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
The switch S in Figure 20.27 is closed at t = 0 and the current at a reference time tref 0 is Iref. If the circuit is changed as, described below and the switch is again dosed at t = 0, determine whether the current I at the same time would be greater than, less than, or equal to the original value of Iref. Indicate your answers wilt G. L. or E, respectively. (a) Both the battery voltage and the resistance R are doubled. (b) The inductance L b doubled. (c) The battery voltage . the resistance R, and the inductance L are each doubled. Figure 20.27 A series RL circuit. As the current increases toward its maximum value, the inductor produces an emf that opposes the increasing current.
Using RHR-l, show that the emfs in the sides of the generator loop in Figure 23.23 are in the same sense and thus add.
A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the inductance?
11 - Four resistors, one uncharged capacitor and two inductors are arranged as shown in the figure. Then a potential difference eo is applied across the circuit as shown. Just after S is closed, what is the current through resistor R3 ? R2 R, a R3 LI L2 R 4. а) R1+R2+R3+RĄ E0 b) R1+R4 E0 c) R3 e) O R1+R2+R3 Boş bırak
Mcq
(Basics of Digital Electronics-CLC) a. Can we use both a multiplexer and demultiplexer in the same circuit? If yes, how and why. Then give three sub types of multiplexers and demultiplexer each