The diagram below shows three rectangular loops moving with the same speed v but in dif-ferent directions. Loops A and C are identical; loop B has the same height but has twice the length. Letthe resistance of each loop (in milli Ohms) be equal to the perimeter of the loop (in cm). At the instantshown:(a) Is the absolute value of the induced emf in loop A greater than, less than, or equal to the absolutevalue of the induced emf in loop C? Briefly explain your reasoning.(b) Is the absolute value of the induced current in loop A greater than, less than, or equal to the abso-lute value of the induced current in loop B? Briefly explain your reasoning.(c) Determine the direction of the induced current in loop A. Briefly explain your reasoning.loop Aloop Bloop Cuniform B

Answered: The diagram below shows three…

Similar questions

The current in a 62 mH inductor changes with time as I = bt- at. With a = 6 A/s and b = the magnitude of the induced emf, E, at 6 A/s, find t = 0.7 s. Answer in units of V. At what time is the emf zero?
Shown in the following figure is a long, straight wire and a single-turn rectangular loop, both of which lie in the plane of the page. The wire is parallel to the long sides of the loop and is 0.50 m away from the closer side. At an instant when the emf induced in the loop is 8.3 V, what is the time rate of change of the current in the wire (in A/s)? (Enter the magnitude.) 0.50 m 0.50 m 3.0 m A/s
In the circuit shown in the figure, let L = 7.40 H, R = 5.90 ohms and E = 120 V. What is the self induced emf 0.200 s after the switch is closed?
Consider the circuit shown in the figure below. Take E = 6.00 V, L = 7.92 mH, and R = 3.60 Ω. S + I R ww (a) What is the inductive time constant of the circuit? ms (b) Calculate the current in the circuit 250 us after the switch is closed. A (c) What is the value of the final steady-state current? A (d) How long does it take the current to reach 81.0% of its maximum value? ms
A 2-turn planer loop of flexible wire is placed inside a long solenoid of n turns per meter that carries a constant current I0 . The area A of the loop is changed by pulling on its sides while ensuring that the plane of the loop always remains perpendicular to the axis of the solenoid. If n = 500 turns per meter, I0 = 20 A, and A = 20 cm2, what is the emf induced in the loop when dA/dt = 100?
A long, straight solenoid with a radius of rs = 3.0 cm and a length of y = 25 cm is wound with 1,500 closely packed turns of wire. The windings carry an upward current of I1 = 20 A that is delivered by a power supply. A conducting loop of radius rc = 2.0 cm is inside the solenoid and is oriented parallel to the solenoid windings as shown in the figure below. Find the induced EMF in the conducting loop when the power supply is adjusted to increase the current in the solenoid to I2 = 35 A in a time of t = 0.40 s. a. 0.714 volts b. 0.255 volts c. 0.533 volts d. 0.624 volts e. 0.410 volts
A square coil of wire of side 3.30 cm is placed in a uniform magnetic field of magnitude 2.50 T directed into the page as in the figure shown below. The coil has 37.5 turns and a resistance of 0.780 Ω. If the coil is rotated through an angle of 90.0° about the horizontal axis shown in 0.335 s, find the following. (a) the magnitude of the average emf induced in the coil during this rotation (b) the average current induced in the coil during this rotation