The depth of water flow at a section of a rectangular channel of 4m wide is 0.5 m. This discharge through the channel is 16 3 m³/s. If a hydraulic jump takes place on the downstream side, find the depth of flow of the jump-

Q: w²/2 F UDL Shear Force Bending Moment Deflection Max Deflection ↓ Į W II 2 -↑ w²/2

A: Given:A simply supported beam of length "l" carrying a udl of intensity w per unit length. Here,…

Q: *11-48. The beam is made from three boards nailed together as shown. If the moment acting on the…

A:

Q: Determine the moment of inertia and inertia product of the shaded area about the x and y axis

A: To determine the moment of a given semicircular section.   The moment of inertia of a plane area…

Q: Ah G Av E 60° 49 30 Bh B x F x D x •METHOD OF JOINTS 20 N Tabulation of forces from Method of…

A:

Q: Problem No. 1.: All bars in the truss shown are 25-mm diameter steel rods (E = 200 GPa). SET P1, kN…

A:

Q: -1: Find Reactions and pin force 6' A Homework 7: 20' 12k 2: Find Reactions and pin force 2' 5' 10'…

A: To find reaction and pin force

Q: A roof purlin, supported by a rafter, must support a 500# vertical snow load. PURLIN- RAFTER 14…

A: Consider the figure,

Q: Locate the centroid of the plane area shown.

A: Given: r1=72 mmr2=120 mm To find: Centroid of plane area.

Q: 3. A plate is held against a horizontal water jet in the horizontal plane as shown. The jet has a…

A: Given data:- The diameter of the jet (d), d=30 mm=0.03 m The given force required to hold the plate…

Q: 4-47 If the diameter of the steel beam shown is 1.25 in, determine the deflection of the beam at x =…

A:

Q: *6-40. Locate the centroid y of the cross-sectional area of the concrete beam. 120 mm 120 mm 30 m…

A: Consider the following diagram of given cross-sectionalarea as follows:

Q: Determine the forces exerted at C and E on the tong BCE.

A:

Q: 3) The truss shown below in Fig 4.3 is in static equilibrium. Determine the support forces at A and…

A: Free body diagram of the given truss:

Q: Find the location of the shear center for a beam with the cross-section shown in dimensions are in…

A: To find Location of shear centre of a beam.

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.