The current through the battery and resistors 1 and 2 in Figure (a) is 2.60 A. Energy is transferred from the current to thermal energy. Eth in both resistors. Curves 1 and 2 in Figure (b) give the thermal energy Eth dissipated by resistors 1 and 2, respectively, as a function of time t. The vertical scale is set by Eth,s = 94.0 mJ, and the horizontal scale is set by t = 4.60 s. What is the power supplied by the battery? Number i (a) Unit R₁ R₂ Eth.s 2 (b) t(s) 2

The current through the battery and resistors 1 and 2 in Figure (a) is 2.60 A. Energy is transferred from the current to thermal energy. Eth in both resistors. Curves 1 and 2 in Figure (b) give the thermal energy Eth dissipated by resistors 1 and 2, respectively, as a function of time t. The vertical scale is set by Eth,s = 94.0 mJ, and the horizontal scale is set by t = 4.60 s. What is the power supplied by the battery? Number i (a) Unit R₁ R₂ Eth.s 2 (b) t(s) 2

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Figure a shows a rod of resistive material. The resistance per unit length of the rod increases in the positive direction of the X axis. At any position x along the rod, the resistance dR of a narrow- differential-section of width dx is given by dR = 5.00xdx, where dR is in ohms and is in meters. Figure b shows such a narrow section. You are to slice off a length of the rod between X = O and some position = L and then connect that length to a battery with potential difference V = 5.0V (Fig. c). You want the current in the length to transfer energy to thermal energy at the rate of 6.2 W. At what position x = L in meters should you cut the rod? Keep 2 decimla points in your aanswer. dx 1.0 -x (m)
8
You are working at a company that manufactures electrical wire. Gold is the most ductile of all metals: it can be stretched into incredibly long, thin wires. The company has developed a new technique that will stretch 1.00 g of gold into a wire of length L = 2.40 km and uniform diameter. Your supervisor gives you the task of determining the resistance of such a wire at 20.0°C.
In Figure (a) below, a 11.16 V battery is connected to a resistive strip that consists of three sections with the same cross-sectional areas but different conductivities. Figure (b) gives the electric potential V(x) versus position x along the strip. The horizontal scale is set by xs = 10.16 mm. Section 3 has conductivity 3.008 × 10' (2·m)-1. What is the conductivity of section (a) 1 and (b) 2? x= 0 x= X5 (a) (b) x (mm) (a) Number Units (b) Number Units (A) A
1.00 MQ A conducting sphere is charged by an emf source E through a 1.00 MO resistor. When the sphere is fully charged, it has 2 µC charge. The highest current during the charging was I mA. What is the electrical potential energy of the sphere when it is fully charged? Give your answer in mJ.
A toaster oven is rated at 1900 WW for operation at 120 VV, 60 HzHz. Part A What is the resistance of the oven heater element? Express your answer with the appropriate units. Part B What is the peak current through it? Express your answer with the appropriate units. Part C What is the peak power dissipated by the oven? Express your answer with the appropriate units.
Consider the following circuit diagram. The potential difference across the battery is 40.0 volts, and it supplies a current of 5.00 amperes to the circuit. There is a current of of 2.70 amperes flowing through R1. Resistor R2 has a resistance of 5.50 ohms. What is the resistance of R3? Answer in ohms to two decimal places, but do not include units in your answer.
In the figure, a resistance coil, wired to an external battery, is placed inside a thermally insulated cylinder fitted with a frictionless piston and containing an ideal gas. A current i = 220 mA flows through the coil, which has a resistance R = 560 0. At what speed v must the piston, of mass m = 17.0 kg, move upward in order that the temperature of the gas remains unchanged? Number i Units