Answered: The current ig in the circuit shown is… | bartleby

Related questions

Question

100%

2.10 The current is in the circuit shown is 2 A.
Calculate
a) Vs,
b) the power absorbed by the independent
voltage source,
c) the power delivered by the independent cur-
rent source,
d) the power delivered by the controlled cur-
rent source,
e) the total power dissipated in the two resistors.
Answer: (a) 70 V;
(b) 210 W;
(c) 300 W;
(d) 40 W;
(e) 130 W.
2is
10 Ω
5 A(
30 Ω
Vs

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A = 60 B = 70 C = 170 D = 7
Don't use chat gpt
A fully charged capacitor with capacitance of C= 80 uF is being discharged. If the total electric resistance of the circuit is 24.0 k and the initial voltage of capacitor is V=10 V, then: a) How long does it take for the capacitor to discharge by 70%? b) Calculate the energy lost from the capacitor by this time? c) Calculate the heat energy produced in the resistor by this time. d) Are the values of energies in parts c and d expected to be the same? Explain.
An automatic irrigation system is going to be used, this system is represented by the following block diagram: The irrigation system will work optimally when the connected load (resistance) has the value such that it can receive the most power from the control circuit, otherwise it could be wasted energy or even damage the system for its operation. Optimum operation of the entire system must be guaranteed. The control circuit of the irrigation system is represented by the following electrical diagram: Donde la resistencia de carga que se conectará entre las terminales a y b debe ser una de entre las tres cargas existentes:
In the circuit shown in the figure all resistors are 5 ohm resistors and the source EMF is 12 volts. (a) Calculate the equivalent resistance of the circuit below when the switch is (1) open (2) closed. (b) Calculate the Power in Rg and the current in R4 if the switch is (1) Open (2) Closed R1 si ww R2 R3 R5 R4
The capacitance in the figure circuit shown is C-0.30µF,, the total resistance is 20kΩ and the fem battery is 12 V. Determine a) the time constant b) the maximum charge that the capacitor could acquire, c) thetime it takes for the load to reach 99% of that value, d) current I when the Q load is half its value maximum, e) the maximum current and f ) the Q load when current I is 0.20 of its maximum value.