The combustion of natural gas (5% v/v CH,) produces a lot of c0g. One exhaust gas was examined at 1.2 atm and 80 °C contained 20 MT of CO, in a day. Calculate the m3 amount of CO, consumed in hr

Q: isothermal absorber

A:

Q: A 6.75 g sample of roronite oxide (MM = 115.75 g/mol) was burned in excess oxygen in a…

A:

Q: 1. A combustion chamber is used to treat a contaminated air stream containing 400 g/m of carbon…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A fire-tube steam boiler must produce 1.2 kg/s of saturated steam with 4% humidity, at 140°C. The…

A: The following information has been given,Steam Requirements:The mass flow rate of saturated…

Q: An enrichment distillation tower, its fed with 45 mol% benzene (A) at 101.32 kPa absolute pressure…

A: (a) Flow rate of feed be, F = 100 kmol/hr   Write the overall balance as follows: F = D+W…

Q: Saturated steam-water mixture is split in a knockout drum at a rate of 3040 kg/h. The incoming steam…

A: Saturated steam is splitted in a knockout drum into pure steam and water.

Q: 100 kg of pyrite mineral is burned per hour in a furnace. The composition of this pyrite mineral is…

A: Given that, The mass of pyrite mineral fed to furnace per hour mF = 100 kg The mass fraction of FeS2…

Q: 4.5 L of O2 is in the cylindrical container with a diameter of 30.0cm at 30oC and it is at…

A: Given data: Initial volume of oxygen = 4.5 L Final volume of oxygen = 6 L Diameter of cylindrical…

Q: Question is attached

A: mass of solid cadmium m=48g initial temperature T1=301°C final temperature  T2=434°C specific heat…

Q: 4. The discussion of electricity costs in section 8.6 stated that coal costs of $1.00 - $1.50 per…

A: Given : Coal costs of  per million BTU are equivalent to about  per ton.Natural gas costs of  per…

Q: A bomb calorimeter, or constant volume calorimeter, is a device often used to determine the heat of…

A: The mass of heptadecanoic acid, The molar mass of heptadecanoic acid, The mass of water in the bomb…

Q: The typical vent-gas analysis from the recycle stream in an oxyhydrochlorination process for the…

A: Component calorific values, from Perry and Chilton (1973)CO =  67.6 kcal/mol = 283 kJ/molC2H4 =…

Q: Determine the final temperature of a gold nugget (mass =13.5 g) that starts at 28 C and loses 3.95…

A: Since you have asked for the solution of both the question but there is additional data required…

Q: A 100 lbmol/h gas stream consisting of 35 mol% ammonia (NH3) and air is scrubbed with water to make…

A: Ammonia is separated from the mixture of air-ammonia mixture.

Q: Conditions for the bottoms at 229°F and 282 psia from a depro- panizer distillation unit in a…

A: Given in the problem are temperature , pressure , component flow rates Where we have assumed that…

Q: Complete the question by hand calculation(please show every step):- Do the mass balance and energy…

A: The following syngas gas conditions and composition are givenComponent Composition (mol%)Carbon…

Q: During a wintertime inversion, the mixing height of an urban area is 0.143 km and winds are calm.…

A: Given data: Number of vehicles = 8000 Maximum height of urban area = 0.143 km

Q: Raw sulfur, 80% pure, is burned in 33 % excess air (S to SO3). Ninety percent of S is burned to SO2…

A: Given that, Raw sulfur contains 80% pure sulfur and 20% Inerts. The %excess air (S to SO3) 90% of S…

Q: A gas mixture composing of 40% methane and 60% butane enters a 2-in ID pipe at 120°C and 1.2atm at a…

A: Given: D = 1/2 in = 0.5 in = 0.0127 m T = 120 °C = 393 K P = 1.2 atm = 121.59 KPa v = 7.67 m/s Gas…

Q: 100 kg of pyrite mineral is burned per hour in a furnace. The composition of this pyrite mineral is…

A: Given that, The mass of pyrite mineral fed to furnace per hour mF = 100 kg The mass fraction of FeS2…

Q: A distillation column with a partial reboiler and a total condenser is being used to separate a…

A: In distillation, separation is possible only above the minimum reflux ratio, which is the lowest…

Q: 2) Benzene-Toluene Separations. We wish to separate benzene from toluene in a sieve-plate…

A: "Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Question 4-Propane gas (C3H8) is used as a propellant in aerosol cans. a. Calculate the density of…

A: Note: As per our guidelines, we are only allowed to answer first three subparts. To get the…

Q: Liquefied petroleum gas (LPG) is a mixture of 40% butane (C4H10) and 60% propane (C3H8). During…

A: Given that, The mass of fuel (LPG) gas mf = 1 kg = 1000 g Gas mixture composition is generally…

Q: A crystallizer is to produce 500 lbs/h of copperas (FESO4 · 7 H20, 277.85) crystals by cooling a…

A: Given, Mass of product formed, P = 500 lbs/hr The molar mass of the product formed is 277.85…

Q: Propane ( C3H8) flowing at 1 mol/s is combusted in 35.2% excess dry air forming CO2 and H2O. The…

A:

Q: It takes 15 kWh (kilowatt-hours) of electrical energy to produce 1.0 kg aluminum metal from aluminum…

A: NOTE : 1 Watt = 1 J/s and not 51 J/s  And 1 KWh = 3600 KJ

Q: Ammonia is removed from a 10 % ammonia-air mixture by scrubbing with water in a packed tower, so…

A: Absorption is a separation process in which solute is separated from the air mixture with the help…

Q: 2. Find the smallest diameter particulate (pp = 1700 kg/m') to be collected with 100% efficiency in…

A: Given: L1 = 2m, L2 = 1 m and H = 35 cm  At 20 0C, μ = 1.825×10-5 kg/m.s and density of gas = 1.204…

Q: A 95kg/hr hot fluid is used to heat a cold fluid from 6oC to 63oC using a double pipe heat exchanger…

A: Given data: Mass flow rate of hot fluid = mh= 95 kg/h Hot fluid temperature entering =T1= 205 oC Hot…

Q: A pipeline is carrying natural gas that contains 85 mol % methane, 10 mol% ethane and 5 mol %…

A: Given data: Temperature = 12 0C Pressure = 10 MPa Volumetric flow rate of natural gas = 0.534 m3/s

Q: One method to remove NOx from diesel exhaust is adding urea (CO(NH2)2) and running the exhaust…

A: To calculate the amount of urea needed to meet the regulatory standard for NOx emissions, we can use…

Q: Q5/ A single-effect evaporator concentrates a 20wt% aqueous solution of H₂SO4 to 70%. The feed rate…

A: An aqueous solution of H2SO4 is concentrated in e single effect evaporator.

Q: PROBLEM 2 To prepare a delicious banana milk on an industrial scale, there is an experimental…

A: Given data: Stream of banana fed to peeler, 99.9% of the peel is removed. In extruder press 50:50…

Q: Suppose that a tank with a capacity of 24 gallons initially contains 16 gallons of pure water. A…

A: Given data:The amount of water in the tank after t min is : So, the tank will be full when :

Q: Determine the rate equation and rate constant k for the following reaction:

A: Given the following data for the following reaction: 2ICl+H2→I2+2HCl The rate expression is given as…

Q: (i) Flux of oxygen gas in kgmol/s•m² and gmol/s·cm². (ii) Flux of propane gas in kgmol/s•m². (iii)…

A: Given that d = 5 mm = 0.005m Z =10 cm = 0.1 m Temp,T =298.15 k Total pressure ,P =1 atm PA1 = 0.06…

Q: Example (2): - Nicotine (C) in a water (A) solution 1% is to be extracted with kerosene B at 20°C,…

A:

Q: You want to know what effect convection will have on evaporation if you leave a petri dish of agar…

A: To find How many times faster water evaporates into an air stream of 2 m/s in fume hood at the rate…

Q: How many pounds per day (lbs/day) of lime and soda ash need to be delivered daily to a plant…

A: Given data: Calcium carbonate hardness = 200 mg/L as CaCO3 Magnesium Non-Carbonate hardness = 100…

Q: 1. A feed of 10,000 kg/h is 10 wt% acetic acid in water. The acetic acid will be removed using a…

A: