The channel shown below is rectangular in cross-section, and it is 10 feet wide. Determine the total energy head, hydraulic head, and specific energy and Sections 1 and 2. Also determine the head loss between Sections 1 and 2 due to the spillway

Q: characteristics of the two pipe system configurations (series and parallel) in terms of discharge,…

A: Given:  Pipes in series  Pipes in parallel To find:  Discharge and headloss relationship  Notations:…

Q: 4. Determine the total discharge from the stream data provided. Velocity (m/s) Point Depth (m) 0.2d…

A: the diagram of given streams in which specific point is provided

Q: The difference in energy grade line between inlet and outlet is 20 cm when Ethyl Alcohol (specific…

A: Given Data: Specific gravity of Ethyl Alcohol is S=0.79. Density of Ethyl Alcohol is given by:…

Q: 7.60. Water is to be pumped from a lake to a ranger station on the side of a of pipe immersed in the…

A: The given data is: Flow rate, Q=95 gal/min                    =365.75 in3/sec The pipe internal…

Q: Two observation wells are located 1.4 km apart in the direction of flow. Water level in well A is…

A: when there is no pumping then the hydraulic gradient will remain constant.

Q: discuss the differences between a full pipe flow and a partially full pipe flow.

A:

Q: The upstream and downstream depth of flow of a sluice gate is 1 m and 0.2 m respectively. Calculate…

A: Given: Upstream depth, y1 = 1 m Downstream depth, y2 = 0.2 m

Q: The discharge in a channel is proportional to AR2/3 if the flow is uniform. For a circular conduit…

A: Circular conduit having an inside diameter D is given. We need to prove that the discharge is…

Q: Determine the downstream depth in a horizontal rectangular channel in which th bottom rises 0.75 ft,…

A: The given data is: Discharge, Q=550 cfs Width, B=5 ft q=Q/B q=550/5=110 ft2/s

Q: A rectangular channel 4 m wide has a depth of 2.5 m at a flow rate (discharge) of 12 m^3/s. Draw a…

A:

Q: please answer if sure it is correct. will thumbs up if correct.

A: The time of concentration from point "a" to "c" 1) kirpich Method =8.606 min2) Kerby  Method = 19.06…

Q: There are two main types of water distribution system layouts. In the Answer system, the main line…

A: There are two main types of water distribution system layouts. In the looped system, the main line…

Q: Using the pump selection table below to determine the best pump for the given condition: Imp.gpm • A…

A: Following is required answer :

Q: QUESTION 4 Water at 10 C flows in a 1.3-cm-diameter pipe at a rate of 1.33 L/min. The hydrodynamic…

A: D = 1.3 cm or 0.013 m  Q = 1.33 L/min

Spillway design

A spillway is the overflow portion of the dam that carries the surplus discharge flow from the reservoir to the downstream, that is, it carries the flood water safely downstream, which is enough to be stored in that reservoir. Therefore, it acts as a safety valve for the dam because many failures of the dam arise due to the incorrect design of the spillway.