The beam shown has a self-weight of 5 kN/m in addition to the load shown in the figure. Determine the rotation at B in radians. I = 1800 x 106 mm4

Q: Please solve all points

A: 1.1 Proper F/M (Food to Microorganism) ratio in a conventional activated sludge process typically…

Q: settling basin is designed based on a surface overflow rate that can achieve a removal efficiency of…

A: d1=0.05mm d2=0.1mm

Q: The two spheres A and Beach have a mass of 400 g. The spheres are fixed to the horizontal rods as…

A: The initial velocity of the spheres, vo = 2 m/sThe mass of each sphere, m = 400gmThe couple moment,…

Q: 1.1

A: Step 1:Given:The force applied on the block: P=543NThe direction of the applied force above…

Q: The initially stationary 24-kg block is subjected to the time-varying force whose magnitude P is…

A: Given data:- The given mass m = 24 kg Block. The force is zero then all-time greater than,=5 sec.…

Q: A propped cantilever beam is loaded by a bending moment of the magnitude M, at the point B as shown…

A:

Q: An equilateral triangular prism (SG = 2/3) is floating on water as shown. A side of the equilateral…

A:

Q: beam is loaded and supported as shown. (a) Use the double-integration method to determine the…

A:

Q: The beam shown, determine the support reactions by using the deflection charts. Given: EI is…

A: Given:- EI = Constant

Q: The beam in the figure has constant E and I as shown for each of the two segments AB and BC. Find…

A:

Q: For the beams shown in below, determine the displacements and rotations of the nodes, the element…

A:

Q: A non-prismatic rod is attached between two supports as shown in figure. It is subjected to axial…

A: For a non prismatic rod Axial load applied is 80 kN and  100 kN as shown in figureTo determine…

Q: Q 7. Use the method of conjugate beam to find the slope and defection at the free end of the…

A: Given: IAB = 4000 cm4  Or IAB = 0.4 m4 EIBC = 2EIAB EICD = 3EIAB

Q: A trapezoid is shown in the figure. 6 6 6 6 6 Compute the area of the trapezoid. 2 Compute the…

A:

Q: The 9-cm diameter 20 degrees Celsius water in the figure strikes a plate containing a hole of 7-cm…

A: Given data  D1 = 9cm = 0.09 m  D2 = 7cm = 0.07 m  Assume density of water = 1000 kg/m3

Q: frame shown below, P=20 kN and a=2 m. Use the virtual work method to calculate the rotation of node…

A: Given:P = 20 kN and a = 2mRequired:Rotation of node A

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.