The beam shown below is subjected to two 4 kN concentrated loads located 1.5 meters from each support. The bending moment diagram for the beam is plotted. Using the moment-area method, determine the deflection at point С. (A Assume E=200GPA, I=4×106 mm4) 4 kN 4 kN VD А В D00. 1.5 m 3 m 1.5 m 6 Bending Moment Diagram (kN.m) +

The beam shown below is subjected to two 4 kN concentrated loads located 1.5 meters from each support. The bending moment diagram for the beam is plotted. Using the moment-area method, determine the deflection at point С. (A Assume E=200GPA, I=4×106 mm4) 4 kN 4 kN VD А В D00. 1.5 m 3 m 1.5 m 6 Bending Moment Diagram (kN.m) +

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Vertical deflection at A please help
For the beam shown in Figure, using the moment area theorems determine the maximum deflection.
The inverted T-beam supports the loads as shown in the figure. Using E-200 GPa, a=25 mm, b=180 mm and c=80 mm. Find, by double integration method, a. the deflection at the right end of the beam. b. the maximum deflection between supports 40 kN 20 kN 15 kN/m a 2m. 3 m 1.5m
Slope-Deflection Method please show all your solutions.
A simply supported beam carries a load as shown in the figure below. What is the value of deflection and slope at point B if and the beam cross section is 300 mm by 550 mm. Use Moment-Area Method.
Please solve correctly otherwise skip it please (solve by hand )
Find the deflection at the midpoint BC of the loaded beam as shown in the figure by the double integration method. E = 200GPa, I = 6.87x10 ^-6
5. Given the beam loaded as shown, determine the deflection at the midspan in terms of EI. Use Area Moment Method. Ax MA Ay 24 kN/m 10 m El constant = B
An 8m simply supported beam supports a uniformly varying load from 0 kN/m at point C to 20 KN/m at point B as shown. Find the slope at the right support and the deflection at the midspan of the beam. Use E = 200,000 MPa and 19 x 107 mm. Double integration. (Boundary method)
For the simply supported steel beam [E = 200 GPa; I = 129 × 106 mm4 ] shown in figure, use the double-integration method to determine the deflection at B. Assume L = 4 m, P = 60 kN, and w = 40 kN/m.
Use double integration method
1. By using Conjugate Beam Method, Determine the deflection at the midspan of the beam shown. 30 kN/m ↓ ↓ ↓ ↓ ↓ ↓ B 5 m- El = constant E = 200 GPa 1=1460x10 mm² -2 m- C