The beam is subjected to applied loads as shown. Determine the moment at 12 ft from support A & shear at 6 ft from right end E. (Check all correct answers) * 20 kips 12 kips 1.5 ki ps/ft !! A E B 8 ft. 6 ft -10 ft-- 81

Q: FIND PA - PB

A:

Q: 3. Find the following: I 2 -1 [B] -5 4 [4]- 7 3 3 3 4 5 a. [A] + [B] b. [А]-[8] C. 3[A] d. (A][B]

A:

Q: given P[AuB] =.7 P[AuB'] =.9. Determine P[A]

A: Given: P[AUB] = 0.7 P[AUB'] = 0.9

Q: 2. Find the equation for the four linear sections of the moment diagram below. 25 kips |25 kips 25…

A:

Q: In Ralston's Method, az is equal to O 1/3 O 1/2 O 2/3 O 3/4

A: this question is from ralston method  in this question we are asked to find out parameter a2

Q: HI= BM+BS RL SNO BS IS FS HI RL 1.115 0:745 7245 1-065 O'785 1.315 2150 845 325-675 150 326-825…

A: student must write data as given below since the BS are the reading which are done from already…

Q: Replace the forces acting on the bar by a resultant force and a couple moment about point A. Specify…

A:

Q: The beam below supports 3-point loads. The beam is supported by a pin at A and a roller at D. a)…

A:

Q: 1. xsin L dy = y sin ²+ x. x dx 2. xy' =y+2xey/x, 3. (x2 - 3y? ).dx + 2xydy = 0 untuk.x = 2, y = 1

A: Given:-

Q: Given the function 2x3 – 4x2 – 1 = 0, a root is from the x = 2 and x = 3. Newton-Raphson method to…

A:

Q: The assembly consists of two brass rods AB and CD and one steel rod EF between a rigid bar. If the…

A: Horizontal displacement of end F of rod EF is, ∆=0.47 mm Material Length (mm) Diameter (mm)…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.