The assembly consists of three titanium (Ti-6A1-4V) rods and a rigid bar AC. Agr=2 in² 1 ft F-2A- P The cross-sectional area of each rod is given in the figure. A force of P = 42 kip is applied to the ring F. 2 ft

Q: 2. Determine the horizontal displacement of joint A by unit load method (i.e., principle of virtual…

A: Force acting in vertical directions are FACsin60=7 kNFAC=8.083 kN Force acting in x direction is…

Q: The beam-column is fixed to the floor and supports the load as shown in (Eigure 1). Take F₁ = 7.5…

A: The beam-column is fixed to the floor and supports the load  F₁ = 7.5 kN F₂ = 5 kN M=1.3 kN-m

Q: 2. In the following truss structure, the angles of A and B are 6A = 120° and B = 30°, respectively.…

A: Given:Yield stress, The factor of safety, The length of the member AB

Q: The shaft is supported at its ends by two bearings AA and BB and is subjected to the forces applied…

A:

Q: Please solve in Handwritten format with free body diagram. Don't use chatgpt.

A: Step 1:

Q: *3-32. The block is made of titanium Ti-6A1-4V and is subjected to a shortening of 0.06 in. along…

A:

Q: Determine the force in each member of the Pratt roof truss shown in Figure 1-94. 10 kN 10 kN 10 kN B…

A:

Q: A bronze bar (E = 103 GPa, v = 0.34) with initial dimensions shown is loaded with P = 80 kN. change…

A:

Q: A cylinder (d₁ = 1.6 in) in contact with an internal cylindrical surface (d2 = 4.6 in), as shown…

A: given,A cylinder (d₁ = 1.6 in) in contact with an internal cylindrical surface (d2 = 4.6 in), under…

Q: A metal bar is made out of A-36 steel and has a diameter d = 23mm with the end at A fixed to the…

A: To findCalculate the displacement of point C relative to point A.Givendiameter, d = 23 mmLoad, Load,…

Q: A metal bar is made out of A-36 steel and has a diameter d = 23mm with the end at A fixed to the…

A: Calculate the displacement of point C relative to point A.Given,Diameter, d = 23 mmLoad, Load,…

Q: The pin is used to connect the three links together. Due to wear, the load is distributed over the…

A:

Q: 7 ft 5 ft 8 ft The assembly shown above includes column AB, which has the following properties: •…

A: Option c is correct.

Q: The 24-mm-diameter A-36 steel rod is subjected to the axial forces shown. Take E= 200 GPa. (Figure…

A: The 24-mm-diameter A-36 steel rod is subjected to the axial forces shown.Take E=200 GPa.Determine…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.