The aorta carries blood away from the heart at a speed of about 45 cm/sec and has a radius of about 1.0 cm. The aorta eventually branches into a large number of capillaries that distributes blood to the varius organs of the body. In a capillary the blood speed is approximately 0.063 cm/sec and the radius is about 5.0 x 10-4 cm. Treat the blood as an incompressible fluid. Use the data to approximate the total number of capillaries in the human body

The aorta carries blood away from the heart at a speed of about 45 cm/sec and has a radius of about 1.0 cm. The aorta eventually branches into a large number of capillaries that distributes blood to the varius organs of the body. In a capillary the blood speed is approximately 0.063 cm/sec and the radius is about 5.0 x 10-4 cm. Treat the blood as an incompressible fluid. Use the data to approximate the total number of capillaries in the human body

Related questions

Q: The human iliac artery has a radius of 0.35 cm. The presure gradient is 390 Pa/m Assume blood is 4…

A: Given, radius of artery, r = 0.35 cmpressure gradient, ∆PL= 390 Pamviscosity of blood, ηblood =…

Q: The two pipes below are connected by a differential manometer, which contains mercury. The fluid in…

A: Write the equation of the pressure from the provided differential manometer.

Q: a modified U-tube: the right arm is shorter than the left arm.The open end of the right arm is…

Q: A water line has an internal radius of 6.3 x 10-3 m and is connected to a shower head that has 14…

A: Given information:

Q: As the depth in a fluid increases, the pressure increases due to the larger weight of the column of…

Q: A glucose solution being administered with an IV has a flow rate of 4.00 cm3/min . What will the new…

A: Initial Volume rate = 4 cm3/min final viscosity =2.5 times the initial viscosity

Q: A circular cylinder of mass m, diameter D and length L is pulled vertically upwards within a…

Q: Unfiltered olive oil must flow at a minimum speed of 3.0 m/s to prevent settling of debris in a…

A: In order to answer this issue, we must determine the oil's portion (a) speed as it leaves the pump.…

Q: A cylindrical tank has a base area A and a height L, open at the top. Initially it was full of a…

A: Given data: The base area of tank is A. The length of tank is L. The density of liquid is ρ.

Q: Water flowing out of a horizontal pipe emerges through a nozzle. The radius of the pipe is 1.5 cm,…

Q: How do the velocity and the gauge pressure of a fluid flowing through a pipe change when it enters a…

A: initial area = A1initial velocity = v1final area = A2final velocity = v2

Q: The Venturi tube as shown in the figure may be used as a fluid flowmeter. Suppose the device is used…

A: Density of gasoline, ρ=700 kg/m3∆P=P1-P2=51.2 kPaInlet radius,r1=2.4 cmOutlet radius,r2=1.2 cm

Q: smaller pipes are 27, 15, and 11 L/min, what is the flow rate in the 2.0 cm pipe? (b) What is the…

Q: A glucose solution being administered with an IV has a flow rate of 4.05 cm3/min . What will the…

Q: medical technician is trying to determine what percentage of a patient’s artery is blocked by…

Q: An intravenous (IV) system is supplying saline solution to a patient at the rate of 0.120 cm3/s…

A: Rate of flow, V = 0.12 cm3 = 0.12 x 10-6 m3 radius, r =0.15 mm =0.15 x 10-3 m length, L =2.5 cm =…

Q: = Water is stored in a pressurised container at a height HT 9 m. It then moves through a horizontal…

Q: In the figure, the fresh water behind a reservoir dam has depth D = 15.5 m. A horizontal pipe 5.62…

A: The given data are: D=15.5 mdp=5.62 cm=5.62×10-2 md=5.24 m

Q: An intravenous (IV) system is supplying saline solution to a patient at the rate of 0.120 cm3 /s…

A: It is given that, P1=8 mm Hg =1.066×103 N/m2η=1×10-3 N.s/m2l=2.50×10-2 mr=0.150×10-3 mQ=1.20×10-7…

Q: An ideal fluid is flowing at a rate of 1.8 m/s through a pipe with a radius of 20 cm. (a) What is…

Q: The water flowing through a 1.9 cm (inside diameter) pipe flows out through three 1.3 cm pipes. (a)…

A: Given that, Inside Diameter of pipe 1.9 cm Pipe flow outs three 1.3 cm Pipes To Determine that(a) if…

Q: A pumping station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: Given Density of gasoline is given as ρ=7.10×102 kg/m3 Radius of the inlet and outlet are…

Q: A glucose solution being administered with an IV has a flow rate of 2.34 cm3/min. What will the new…

A: Given that, the initial volume rate is 2.34 cm3/min and final viscosity is 2.7 times the initial…

Question

Treat the blood as an incompressible fluid. Use the data to approximate the total number of capillaries in the human body

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A mass m₁ = 70 kg is balanced by a mass m2 = 1200 kg on an oil hydraulic lift. The diameter of the piston on which mass m2 is standing on is d₂ = 2m. (1) What is the diameter d₁ of the piston on which mass m₁ is standing? (2) A third mass m3 is added on top of mass m₁. The piston sinks 35 cm. Determine m3.
An ideal fluid is flowing with a speed of 12 cm/s through a pipe of diameter 5 cm. The pipe splits into three smaller pipes, each with a diameter of 2 cm. What is the speed of the fluid in the smaller pipes?
Two identical containers are open at the top and are connected at the bottom via a tube of negligible volume and a valve that is closed. Both containers are filled initially to the same height of 1.00 m, one with water, the other with mercury, as the drawing indicates. The valve is then opened. Water and mercury are immiscible. Determine the fluid level in the left container when equilibrium is reestablished.
Problem 4: Water flows through a water hose at a rate of Q1 = 660 cm/s, the diameter of the hose is d = 2.13 cm. A nozzle is attached to the water hose. The water leaves the nozzle at a velocity of v = 11.6 m/s. Part (a) Enter an expression for the cross-sectional area of the hose, A1, in terms of its diameter, dj. A1 = 7 8 9 HOME A1 d 4 5 di g h 1 2. 3 P Q1 END m t V1 V2 vol BACKSPACE DEL CLEAR Submit Hint Feedback I give up! Part (b) Calculate the numerical value of A1, in square centimeters. Part (c) Enter an expression for the speed of the water in the hose, v1, in terms of the volume flow rate O, and cross-sectional area A1. Part (d) Calculate the speed of the water in the hose, vị in meters per second. Part (e) Enter an expression for the cross-sectional area of the nozzle, A2, in terms of vị, v2 and A1. Part (f) Calculate the cross-sectional area of the nozzle, A2 in square centimeters.
Atherosclerosis is a cardiovascular disease that involves the accumulation of cholesterol in the arterial wall in regions with damaged endothelial cells. Assume that the damaged region is a circular hole with radius b. the thickness of the endothelial layer can be neglected. The endothelial layer is impermeable to cholesterol and plasma, except in the damaged region. The subendothelial space can be treated as a semi-infinite porous material with hydraulic conductivity K. The transport of fluid and cholesterol is in the radial direction and is symmetric about the center of the hole. The diffusion coefficient of cholesterol in the subendothelial tissue is D. The concentration of cholesterol and the hydrostatic pressure at r = b are approximately equal to those in the plasma, which are Cp and p0 respectively. The concentration and pressure at r→∞ are assumed to be zero. Determine the distribution of pressure in the subendothelial space in the steady state and evaluate the pressure at r =…
Is it possible for a fluid in a tube to flow in the direction from low pressure to high pressure? If so, give an example. If not, why not?
The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is used at a service station to measure the flow rate of gasoline (p = 7.00 x 102 kg/m³) through a hose having an outlet radius of 1.02 cm. The difference in pressure is measured to be P₁ P₂ = 1.90 kPa and the radius of the inlet tube to the meter is 2.04 cm. P₁ P2 (a) Find the speed of the gasoline as it leaves the hose. 2.40 m/s (b) Find the fluid flow rate in cubic meters per second. 0.0007 m³/s
A cylindrical storage tank has a cross sectional area A1=1.5 m². The tank is set up vertically on the ground and filled with V=7.5 m³ of water. There is a valve at the bottom of the tank with an internal cross sectional area of 1.5 cm². What fraction of the total volume will be drained in the first 50 minutes after the valve is opened?
An intravenous (IV) system is supplying saline solution to a patient at the rate of 0.120 cm3 /s through a needle of radius 0.150 mm and length 2.50 cm. What pressure is needed at the entrance of the needle to cause this flow, assuming the viscosity of the saline solution to be the same as that of water? The gauge pressure of the blood in the patient’s vein is 8.00 mm Hg. (Assume that the temperature is 20ºC .)
The pulmonary artery, which connects the heart to the lungs, has an inner radius of 2.60 mm and a length of 8.40 cm. If the drop in pressure between the heart and the lungs is 4.0 hPa. a) What is the average speed of the blood in the pulmonary artery?
A medical technician is trying to determine what percentage of a patient's artery is blocked by plaque. To do this, she measured the blood pressure just before the region of blockage and finds that it is 1.20 × 104 Pa, while in the region of blockage it is 1.15 x 104 Pa. Furthermore, she knows that blood flowing through the normal artery just before the point of blockage is travelling at 30.0 cm/s. What percentage of the cross-sectional area of the patient's artery is blocked by the plaque?
U-shaped tube, open to air on both ends, contains oil. Water is poured into the left arm until the water column is 10 cm deep. What is the height of the oil column (in cm) when the system is in equilibrium? The density of oil is 801 kg/m3