The aluminum rod ABC (E = 70 GPa), which consists of two cylindrical portions AB and BC, is to be replaced with a cylindrical steel rod DE (E = 200 GPa) of the same overall length. Determine the minimum required diameter d of the steel rod if its vertical deformation is not to exceed the deformation of the aluminum rod under the same load and if the allowable stress in the steel rod is not to exceed 165.5 MPa

Q: 2. For the bone shown to the left, assume the cross-section at C can be approximated as annular,…

A: Given:Average normal stress, σ=3.8 MPaLoad applied, P=1200 Nouter diameter, d=25 mm

Q: Determine the value of Q so that the deformation at A is zero.

A: Given:E = 70 GPaP = 3.5 kNDiagram is givenTo find:Value of Q so that the deformation at A is zero

Q: A tensile stress is to be applied along the axis of a cylindrical brass rod that has a diameter of…

A: given; diameter (d)=10mmchange in diameter (δd)=2.5*10-3mmelasticity(E)=10.1*104MPapoisson's…

Q: orce of P₂ = 610 N is exerted on control arm BC, which is securely attached to the solid 39 mm…

A:

Q: A) Using the ultimate stress found earlier, determine the minimum diameter of post BD required for…

A:

Q: 5 mm 20 mm 5 mm Steel core E = 200 GPa Brass shell E = 105 GPa 5 mm 20 mm .5 mm 250 mm

A:

Q: 5 in. 2. Two wooden members of uniform rectangular cross section are joined by a glued scarf splice…

A:

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.375 in., and each side…

A:

Q: Link BC is to be made of a steel for which the ultimate normal stress is 250 MPa. Determine the…

A:

Q: The 1.4-kip load P is supported by two wooden members of uniform cross section that are joined by…

A: Given Data: The load on member is P = 1.4 kip. The cross-section area is A = 3 in ×5 in. The angle…

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 9 mm².…

A: Given: The cross sectional area of rod 1A1=9 mm2=9×10-6m2 The cross sectional area of rod 2A2=18…

Q: The rigid bar ABD is connected to the rod BD which consists of a single bar with a width of 25,0 mm…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.