The air in an automobile tyre with a volume of 0.015 m3 is at 30°C and 140 kPa. Determine the amount of air that must be added to increase the pressure to 210 kPa. Assume atm. pressure to be 100 kPa and temperature and volume to remain constant, assuming Ideal gas equation.

The air in an automobile tyre with a volume of 0.015 m3 is at 30°C and 140 kPa. Determine the amount of air that must be added to increase the pressure to 210 kPa. Assume atm. pressure to be 100 kPa and temperature and volume to remain constant, assuming Ideal gas equation.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: How much work (in ft-lb) is done when 10 ft of an air is initially at a pressure of 1 atm and a…

A: 0 is the correct answer. Since the volume of cylinder remains constant. It is an isochoric process.…

Q: The surface tension of water in contact with air at 20°C is 0.0725N/m. The pressure inside a droplet…

A: Given: Surface Tension σ=0.0725 N/m, Pressure intensity, P in excess of outside pressure is…

Q: 2.15 The tire of an airplane is inflated at sea level to 410 KN/m2 Assuming the tire does not…

A: at sea level standard atmosphere pressure p1atm=101.325 kPa, T1=150c=2880k tyre pressure…

Q: 1) Consider a chunk of fluid that is initially shaped as shown hanging off of the edge of a table in…

A: Let us consider the given shape "A" Assuming that the fluid section labeled is able to maintain its…

Q: In the figure shown, determine the gage pressure at B when its absolute pressure is 290 kPa. Encode…

A: DETERMINATION OF GAUGE PRESSURE AT B ###

Q: An automobile tire is inflated to 30 psig pressure at 50F. After being driven, the temperature rise…

Q: 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Volume of water = 1m3 pressure (P)= 40MPa

Q: The tank contains a liquid having a density of 2.52 slugs/ft^3 10 in 5 ft 10 ft 7 ft Pliquid = 2.52…

A: GIVEN Density of liquid = 2.52 slugs/ft3 L = 10 ft B = 5 ft H = 7 - 10/12 = 6.167 ft Glycerine, SG…

Q: A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific…

A: given atmospheric pressure = 96 kPa S.G= 0.95 ρw=1000 kg /m3 h=65 cm=0.65 m Gauge…

Q: A glove box is an enclosure held at a lower pressure than its surroundings to ensure that any fluid…

A: Given The pressure inside a sealed container sitting in the laboratory = 5.2 psig and pressure in…

Q: Calculate the density, specific weight, and specific volume of oxygen at and 40 kPa abs. b. If the…

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Given data The volume of the water = 1 m3 The pressure of piston = 36 MPa We are supposed to…

Q: An open tube is attached to a tank as shown. If Liquid X (Glycerin SG=1.26) rises to a height of 800…

A: Apply the principle of manometry the pressure at A can be easily calculated

Q: Air within a piston-cylinder assembly, initially at 15 lbf/ in.2, 510°R, and a volume of 6 ft3, is…

Q: The air in an automobile tyre with a volume of 0.015 m3 is at 30°C and 140 kPa. Determine the amount…

A: Given data in question Volume = 0.015m3 Temperature = 30°C Atm pressure 100kPa Initial pressure…

Q: The air exits the nozzle to the atmosphere and enters a vertical plate as shown in the figure. it…

A: Assumptions: 1. The flow is incompressible 2. The flow is frictionless.

Q: Determine the amount of air added to the tank (in Ibi

A: Amount of air added is 9.8lbm

Q: 5. A slab of concrete used in highway construction is set in place when the ambient temperature is…

A: The given data is: Ambient temperature=20 °C Length of slab, L=20.478 m Maximum temperature=55 °C…

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12…

A: As per guidelines of bartleby, experts are allowed to solve only first three subparts. Please post…

Q: For a Newtonian fluid flowing under turbulent flow conditions, show mathematically (without using…

A: Due to the derivational nature of the problem i am giving u a handwritten solution

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: To Determine (a) the gage pressure reading on the pressure gage Pressure gage is 1m below the liquid…

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Given : Volume of water , V = 1 m3 Pressure = 33 Mpa = 33 * 106 N/m2 Required : Change in the…

Q: In the figure shown, determine the height h of water and the gage reading at A when the absolute…

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: A compressor takes 1.2 cu in of gas at a pressure of 14.7 psia and compressesit into a volume of…

A: Given: Initial volume, V1 = 1.2 in3 Initial pressure, P1 = 14.7 psia Final volume, V2 = 0.36 in3…

Q: atmospheric pressure is 1.013 bar. Determine the absolute pressure of the system. O 2.026 bar O O…

Q: 16. Fluid Flow through a Compression Chamber A compressible gas flows into and out of a compression…

Q: 1. The pressure in an automobile tire depends on the temperature of the air in the tire air…

Q: A 3.5-m³ rigid tank initially contains air whose density is 2 kg/m³. The tank is connected to a…

A: The formula to find the mass m of a substance is:[ m = ρ . V ]where ρ is the density and V is…

Q: Determine the mean effective pressure in kPa of a certain air -standard Diesel cycle which has a…

Q: A steel container expands in volume 1 percent when the pressure within it is increased by 10,000…

A: Given data:Change in pressure,∆P=10000 psiChnage in volume,∆V=1% of Vi

Q: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the…

Q: An open tube is attached to a tank as shown. If Liquid X (Water) rises to a height of 800 mm in the…

Q: Air is flowing from a reservoir through a long, insulated, isentropic nozzle. The pressure and…

A: P= 15 atm T= 950K M= 0.05 Pipe is smooth To find- length of the pipe

Q: A typical automobile tire is inflated with air to a pressure of 32 psi. Convert this pressure to…

A: A typical automobile tire is inflated with air pressure of 32 psi Change the unit of pressure from…

Q: A fluid is stored in a container. The fluid can be approximated as an ideal fluid having no viscous…

Q: *A person holds her hand out of an open car window while the car is drives through still air at 65…

Q: An air compressor intakes atmospheric air at 101.325 kPa and increases its pressure to 1.275 MPa…

A: Given: Atmospheric pressure, Patm = 101.325 kPa Gauge pressure, Pgauge = 1.275 MPa

Q: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon…

A: Height of closed tank, H =18inchesDepth of carbon tetrechoride, H1 =4inDepth of water,H2 =2indepth…

Q: 5- tire having a volume of 5 ft contains air at a gage pressure of 36 psi and a temperature of 80 F.…

Q: ne the volume V and total surface area A of the solid z k 63 mm 43 mm *

Q: A gasoline line is connected to a pressure gauge through a double U-shaped manometer, as shown from…

A: Given data:- ρwater = 1000 kg/m3g = 9.81 m/s2 hwater = 45 cmSGoil = 0.79hoil = 50 cmSGHg = 13.6hHg…

Concept explainers

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with. 

Question

The air in an automobile tyre with a volume of
0.015 m3 is at 30°C and 140 kPa. Determine
the amount of air that must be added to
increase the pressure to 210 kPa. Assume atm.
pressure to be 100 kPa and temperature and
volume to remain constant, assuming Ideal gas
equation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the water when a piston applies a pressure of 43 MPa. m³
2. If the atmospheric pressure is 101.33 kPa and the absolute pressure at the bottom of the tank as shown in the figure is 215 kPa. a.) What is the specific gravity of olive oil? b. ) What is the absolute pressure at the interface of the olive oil and the mercury c.) What is the pressure at the bottom of the tank Sea Oil (sg-0.89) Water Olive oil Mercury (sg= 13.6) 1.5 m 2.5 m 3.0m 0.5 m
Problem 15.1 R = 287.14 J/kg°K and k = 1.4 for air. Assume temperature as 15°C. Find the velocity of bullet fired in standard air if the Mach angle is 30°. Take
Can you follow the instruction given: Determine the specific weight on each liquid by using the concept of P2 = P1+γh. Start with the upper most reader (Elevation 2m) since its P1 is zero. Repeat this until you reach the third elevation. Get the average of the three (3) specific weights. Divide this into the specific weight of water. Take this as your Specific Gravity for Fluid A. Gravity= 9.8 m/s2 The atmosphere is off in the simulation. These are the sample data given:
Neglecting vapor pressure, what is the pressure of the air at point E in the container shown? The atmospheric pressure is 1.0 atm (14.7 lbf/in², 101300 Pa). 2 in (5 cm) # 3 in (8 cm) 26 in (66 cm) E civilstrupea amail.com T air SG-0.72 SG - 0.87 mercury SG 13.6
Civil The height of a liquid column of mercury open to the atmosphere is 2.493 ft. Calculate the absolute pressure at the base of the column 1B_{t} / f * t ^ 2 psia, mm Hg. and in H-O. Assume that the density of mercury is 848.7 lb/ft and atmospheric pressure is 2116 lb/ft² absolute.
*2-16. Due to its slight compressibility, the density of water varies with depth, although its bulk modulus Eş = 2.20 GPa (absolute) can be considered constant. Accounting for this compressibility, determine the pressure in the water at a depth of 300 m, if the density at the surface of the water is Po = 1000 kg/m. Compare this result with water that is assumed to be incompressible. www.jar
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3. pls answer asap thank you
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3.
2.19 Determine the change in the kinematic viscosity of air that is heated from 10°C to 70°C. Assume standard atmospheric pressure.
1. The compressed air tank has a volume of 0.4 m. The temperature is 25°C and the atmospheric pressure is 101.35 kPa. When the tank is filled with air at a gage pressure of 262.74 kPa, determine the density of the air and the weight of air in the tank. Hint: Ideal gas law should be used. R-28 m/s?K
Which of the following unit is NOT the Pressure unit? o Pascal o psi o kelvin o standard atmosphere • A vacuum gage connected to a chamber reads 7 psi at a location where the atmospheric pressure is 14.5 psi. What is the absolute pressure in the chamber? o 7.5 psi o 21.5 psi o -7.5 psi o 8.7 psi Pressure is a scalar quantity, the pressure at a point in a fluid is the same in all directions. o True o False