The 28000-1b airplane is flying in the vertical plane at 390 ft/s. At the instantshown, the angle = 30°, and the cartesian components of the plane'sacceleration are a = -5 ft/s², ay = 25 ft/s².Figure< 1 of 1Part AWhat are the tangential and normal components of the total force acting on the airplane (including its weight)?Enter your answers numerically separated by a comma.Ft, Fn =SubmitPart B* Incorrect; Try Again; 4 attempts remaining■AΣ vecde/dt =Previous Answers Request AnswerWhat is de/dt in degrees per second?(Figure 1)SubmitVAZ † vecRequest Answer??lb°/s

Answered: Image /qna-images/answer/d6a82586-6662-4aa7-ba3d-ae8511653d14.jpg

The 28000-1b airplane is flying in the vertical plane at 390 ft/s. At the instant shown, the angle = 30°, and the cartesian components of the plane's acceleration are a = -5 ft/s², ay = 25 ft/s². Par Wha Ente F

The 28000-1b airplane is flying in the vertical plane at 390 ft/s. At the instant shown, the angle = 30°, and the cartesian components of the plane's acceleration are a = -5 ft/s², ay = 25 ft/s². Par Wha Ente F

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The helicopter flying in Figure 4 with a constant velocity of 180 km/h and is directly above point A when a loose part begins to fall. The part lands 6.5 seconds later at point B on an inclined surface. 16. The vertical motion component of the falling part is A. uniform motion B. non-uniformly accelerated C. uniformly accelerated D. stationary
5. A ball of mass m = 0.275 kg swings in a vertical circular path on astring L = 0.850 m long as in the Figure.(a) What are the forces acting on the ball at any point on the path?(b) Draw force diagrams for the ball when it is at the bottom of thecircle and when it is at the top. (c) If its speed is 5.20 m/s at the top ofthe circle, what is the tension in the string there?(d) If the string breaks when its tension exceeds 22.5 N, what is themaximum speed the ball can have at the bottom before that happens?
Problem 2 ( The rod AB has a velocity and an acceleration at the wheel A of 4 m/sec and 6 m/sec?. Given the information, please VA=4 m/sec answer the following questions. a,=6 m/sec2 30 AB=0.6 m (a) Angular velocity of the rod AB. (Hint: locate the IC for this problem). 30° (b) Angular acceleration of the rod AB. (c) Linear acceleration of the wheel B (along the inclined plane).
Q1 : The position of a particle moving along the x-axis is given by X-4t -9 calculate the acceleration and displacement if velocity =1m/sec Q2 : a ball thrown from the top of a house is given an initial velocity 10 m/sec straight upward .the house is 55 m high and after ball reach the maximum hight then down to the ground calculate : 1-time at which the ball reach maximum and the maximum height 2- The velocity and the position of the ball at time 2 sec Q3: A senior physics class conducting a research project on projectile motion constructs a device that can launch a cricket ball. The launching device is designed so that the ball can be launched at ground level with an initial velocity of 50 m s-1 at an angle of 45° to the horizontal. Calculate 1- The horizontal & vertical components of the velocity of the ball initially. 2- What is the maximum height that is achieved by the ball? 3-How far from lunching point will the ball attain its original level and the total time when attain at…
Situation #4: At the bottom of a loop the speed of an airplane is 650kph. This causes a normal acceleration of 8g m/s². Find the radius of the loop.
In the figure shown, the load needs to be raised 28 ft. Noting that Gear A is initially at rest and it has a constant acceleration until it reaches 120rpm velocity in 5s, it maintains a uniform velocity of 120 rpm after. Solve for (a) the total time the load was raised at the required height(in seconds). (b) the angle of change of Gear A (in revolution). A 3 in. B 18 in. 15 in. Load
As shown in Figure 1 of the ski ramp, you need to make sure that theskier lands safe once they jump from the ski ramp. Given that ramp A has an angle(theta)A = 25° with the horizontal. (a) Calculate the initial speed, VA if the skier lands on the ground at point B.
A horizontal bar, 11 ft long and of negligible weight, rests on rough inclined planes as shown. The coefficient of friction for all contact surfaces is 0.27. What is the normal force at contact point A? How close to A may the 120lb force be applied before motion impends? 120 Ib 210 lb 2.50 ft 2 56 11 ft
Think about how this relates to (c). Ihe center of the circle? 2. A 1500 kg car is driving on a concrete highway, on a sunny day. The road makes a sharp turn, with a radius of curvature of 50. meters. What is the maximum speed at which the car can make the turn without sliding sideways?? The centripetal force is provided by the friction force that the concrete road exerts on the rubber tires. Calculate the friction force, then plug that into F.-mv/r, as F M 9 EESE
A commercial airliner with four jet engines, each producing 94 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below. 94 kN 6.4 m 3 13.2 m 13.2 m 94 kN 6.4 m 94 kN- Answer: d = m
Vo 2. A bowler projects an 8.5-in diameter ball weighing 16 lb along an alley with a forward velocity vo of 25 ft/s and a backspin wo of 9 rad/s. Knowing that the koefficient of kinetic friction between the ball and the alley is 0.10, determine (a) the time t₁ at which the ball will start rolling without sliding, and (b) the speed of the ball at time t₁.