The 193-kg lunar lander is descending onto the moon's surface with a velocity of 7.5 m/s when its retro-engine is fired. If the engine produces a thrust T for 3.6 s which varies with the time as shown and then cuts off, calculate the velocity of the lander when t = 4.1 s assuming that it has not yet landed. Gravitational acceleration at the moon's surface is 1.62 m/s?. The velocity is positive if moving downward, negative if up. 7.5 m/s 8 T, N 892 1.8 3.6 t, s Answe: v = i m/s

The 193-kg lunar lander is descending onto the moon's surface with a velocity of 7.5 m/s when its retro-engine is fired. If the engine produces a thrust T for 3.6 s which varies with the time as shown and then cuts off, calculate the velocity of the lander when t = 4.1 s assuming that it has not yet landed. Gravitational acceleration at the moon's surface is 1.62 m/s?. The velocity is positive if moving downward, negative if up. 7.5 m/s 8 T, N 892 1.8 3.6 t, s Answe: v = i m/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

By itself, the 2700-kg pickup truck executes a 0–98 km/h acceleration run in 11.0 s along a level road. What would be the corresponding time when pulling the 550-kg trailer? Assume constant acceleration and neglect all retarding forces.
Q17. As shown in the image below, the 0.7-kg ball strikes the rough ground and rebounds. The directions of its velocities before and after the strike are shown. If the speeds are v₁ = 27 m/s and v₂ = 12 m/s, determine the magnitude of the impulse (in N.s) the ground exerts on the ball. Assume that the ball does not slip when it strikes the ground, and neglect the size of the ball and the impulse produced by the weight of the ball. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. V₁ Your Answer: 45° Answer 30° 02
Please show full work for thumb up.
The double pulley shown in the figure is formed by two wheels that are coupled to each other. The complete pulley (formed by the two wheels) has a mass of 15 kg and a turning radius of 110mm. Block A has a mass of 40 kg. If a force of 2 kN is applied to the tied rope of the inner pulley wheel, determine the speed of block A after 3 seconds. At the beginning, the whole system was at rest. Disregard the mass of the string and consider that the moment of inertia (kg.m²) of the complete pulley is given by IP = mko²where m is the mass of the pulley and Ko is the radiusspinning
The athlete with a mass of 85 kg moves from point A with a velocity vA. The circular orbit it slides has a radius of 4.9 meters and an angle of 60 degrees. As it is know that the reaction force affecting the athlete at the D point is 4. (Coefficient of Dmg); a) Calculate the athlete initial velocity vA and the velocity vB at point B. b) Calculate the height y, which is the highest distance that the athlete can climb after point B, and the distance between BC that he can travel horizontally.
Determine the acceleration due to the gravity of Earth, g, as it is felt at the geosynchronous orbit. The geosynchronous orbit is approximately 36,000 km above the Earth.
The 12-Mg truck drives onto the 396-Mg barge from the dock at 17 km/h and brakes to stop on the deck. The barge is free to move in the water, which offers negligible resistance to motion at low speeds. Calculate the speed of the barge after the truck has come to rest on it. 17 km/h 396 Mg 12 Mg Answer: v = km/h
The disk rotates at a constant acceleration of 0.005 revolutions per second and starts movement from rest, and what is its angular speed after one minute 1 If an external force does not act on an object, that means: 2. If the body is in free fall then: 3- One of the ways in which the friction between the contact surfaces can be reduced 1 ................ f
01: The slider of mass m= 0.7-kg, starts from rest at position A and the undeformed (unstretched) length of spring is Lo = 210 mm. Under the action of the constant force p= 55N force in the cable, calculate the velocity v of the block as it reaches position B. B 200 mm A 200 250 mm P mm 250 mm k m 200
2) The collar has a mass of 2 kg and is attached to the light spring, which has a stiffness of 30 N/m and an unstretched length of 1.5 m. The collar is released from rest at A and slides up the smooth rod under the action of the constant 50-N force. Calculate the velocity u of the collar as it passes position B. Ans. V=4.93 m m 1.5 m 30° 50 N k= 30 N/m 2m 3