Template Assisted Crystallization (TAC) is a a commercial softening alternative. Which of the following description is wrong O A. TAC involves the adsorption of cations and anions O B. TAC involves the crystallization of hardness ions O C. TAC involves the detachment of nanocrystalls back to the treated water O D. TAC has a greater removal efficiency for hardness than RO or ion exchange

Template Assisted Crystallization (TAC) is a a commercial softening alternative. Which of the following description is wrong O A. TAC involves the adsorption of cations and anions O B. TAC involves the crystallization of hardness ions O C. TAC involves the detachment of nanocrystalls back to the treated water O D. TAC has a greater removal efficiency for hardness than RO or ion exchange

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A, +e- > A; + 2e A; +e- K » 2A A +A-K A, + A Write down the rate equation for the species. Do not include a diffusion term.
5) In the adsorption of N2 at 90.1 K on a certain solid, the following volumes of gas, reduced to standard condition, were found to be adsorbed per gram of the solid at the indicated relative pressures. Determine: a) the BET constants b) E, and E c) identify the type of isotherm P/po 0.05 0.10 0.15 0.20 0.25 V, cm³ 51.3 58.8 64.0 68.9 74.2
Sketch within a cubic cell the following Miller Indices: a. [0 -1 -1] b. [10 -2]
(c) Batch adsorption of 900 mg/L phenol was studied at 298 K using 50 mL aliquot at an optimized dose of 1.5 g of activated carbon. What is the adsorption capacity in mg/g at an equilibrium concentration of 650 mg/L?
For each of the following questions, more than 1 answer may be correct: 1. Molecular adsorptiona. Describes the adsorption of gases on the surface of a solidb. Is used in the separation of substancesc. Describes the preferential adsorption of substances with positively or negativelycharged function groupsd. Has utility in the production of purified water in pharmacy 2. Mechanism of action of polar solvents (water) includesa. Dissolving with similar internal pressures through induced dipole interactionsb. Breaking covalent bonds and ionized weak electrolytec. Formation hydrogen bridges with non-electrolytesd. Reduction the attraction between the ions of strong and weak electrolytes.
(c) Batch adsorption of 900 mg/L phenol was studied at 298 K using 50 mL aliquot at an optimized dose of 1.5 g of activated carbon. What is the adsorption capacity in mg/g at an equilibrium concentration of 650 mg/L?
In this table the Kr volume adsorbed on an active carbon surface are given, as a function of the pressures, at 193.5 K. a) Does this data fit well to a Langmuir isotherm? If yes, determine vm and b.
Effect of dose on adsorption percentage of cadmium onto magnetite (pH 7; adsorbent dose = 0.05, 0.1, 0.5, 0.10, 0.15 g; initial concentration 100 ppm, T = 25°C, 150 rpm, Contact Time = 2 h) performed with ASS instrument. What is the optimal dosage?
1. What the time ol submevs ion in day of Brass alloy (25%2n, 45%.cu) , avea was 10 cm2, that 2.5 kg had lost(w) duri'ng the submersion in3-5 %% Nacl solution and (200 mm) millimeter per year |Pznz 7.13 glem3 Peu=8-948 Cm 3
2. The data below were obtained for a polymerization reaction at 350 K: [M] (kmol / m³) [1] (mol / m³) -d[M]/dt (mol/m³s) 9.04 0.235 0.193 8.63 0.206 0.170 7.19 0.255 0.165 6.13 0.228 0.129 4.96 0.313 0.122 4.75 0.192 0.0937 4.22 0.230 0.0867 Where [M] = monomer concentration and [I] = initiator concentration. Show that the data are consistent with the model for the rate of polymerization by free radical mechanism. Assume that the initiator efficiency is independent of monomer concentration.
The rate of adsorption increases by; А. В. Increasing the temperature of the Increasing the pHof the adsorption medium adsorption medium C. D. Increasing the molecular size of the adsorbed Increasing the surface area of the adsorbent species
What is the difference between effect of pH and Point of zero charge with regards to Adsorption