Consider the vapor-compression refrigeration cycle shown belowwith tetrafluoroethane as the refrigerant. If the evaporationtemperature is -12°C, determine the coefficients ofperformance for condensation temperatures of 16°C, 28°C, and40°C. Use the table containing the properties of saturated 1,1,1,2-tetrafluoroethane (R134A) and the PH diagram fortetrafluoroethane (HFC-134a).TSVapor-compression refrigeration cycle.4ThrottlevalveCondenserCompressorEvaporatorAssume isentropic compression of the vapor.The coefficient of performance for a condensation temperature of 16°C isThe coefficient of performance for a condensation temperature of 28°C is3The coefficient of performance for a condensation temperature of 40°C is2

Given Data The evaporation/outlet temperature is:Tc=-12°C=261K The inlet temperature…

temperature is -12°C, determine the coefficients of performance for condensation temperatures of 16°C, 28°C, and 40°C. Use the table containing the properties of saturated 1,1,1,2- tetrafluoroethane (R134A) and the PH diagram for tetrafluoroethane (HFC-134a).

temperature is -12°C, determine the coefficients of performance for condensation temperatures of 16°C, 28°C, and 40°C. Use the table containing the properties of saturated 1,1,1,2- tetrafluoroethane (R134A) and the PH diagram for tetrafluoroethane (HFC-134a).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3 Determine the mass of 0.25 m° of steam at 5 bar pressure and 0.85 dryness fraction. 3 Proceed to calculate the heat content 1 m° of this steam.
Pre-lab 8: Cold Engine The experimental setup for this week's lab consists of a syringe connected to a metal can (reservoir), a cold bath (water - ice mixture) and a "hot" bath (water at room temperature). A schematics of the syringe - reservoir system is shown below. Plunger of mass m Filled with gas (air) Syringe of volume Vcor VH - Volume Vo includes tube + Metal can -Metal can submerged in water of temperature Тс or TH. Tube Stopper Figure 1: Schematic of the syringe - reservoir system. The syringe is essentially a glass cylinder fitted with a movable piston (plunger). The markings on the syringe indicate the volume of gas in the syringe, but do not include the additional, unknown volume, Vo, in the gas can and tubing.
Problem 3 An FCC iron-carbon alloy initially containing 0.35 wt% C is exposed to an oxygen-rich and virtually carbon- free atmosphere at 1400 K (1127 °C). Under these circumstances the carbon diffuses from the alloy and reacts at the surface with the oxygen in the atmosphere; that is, the carbon concentration at the surface position is maintained essentially at 0 wt% C. (This process of carbon depletion is termed decarburization.) At what position will the carbon concentration be 0.15 wt% after a 10-h treatment? The value of D at 1400 K is 6.9 x 10¹¹ m²/s.
An FCC iron–carbon alloy initially containing 0.25wt% C is carburized at an elevated temperature and in an atmosphere wherein thesurface carbon concentration is maintained at 1.0 wt%. If after 55.0 h the concentrationof carbon is 0.35 wt% at a position 5.0 mm below the surface, determine thetemperature at which the treatment was carried out.
Can someone please answer part a and part b. but please transform the PV diagram to a TS diagram first and express Ti in terms of Cp, Cv, TL, and TH
PROBLEM 2 In general, the disposal of hot streams to the environment is not a good a practice due to the risk of violating EPA regulations and also, it represents as waste of potential useful energy. For example, raising the temperature of lakes, rivers, and atmosphere have negative consequences on the ecosystems. In this problem, a gas stream at 500°C contains eight percent mole carbon monoxide and the balance carbon dioxide. Before disposing this gas mixture stream into the atmosphere, it makes sense to recover some of its energy first. To achieve this we will use a heat exchanger where the gas stream flows across the tubes. Water flows inside the tubes entering at 25°C and it is fed at a ratio of 0.2 mole water per mole of the hot gas. The water is heating to its boiling point forming saturated steam at five bar. The steam produced can be used for heating or power generation in the facilities or as the feed for another unit operation. You can assume that heat exchanger is thermally…
d. An Aluminum-Copper alloy initially containing (0.4 wt% Cu) is placed and held in an atmosphere that gives a constant surface Aluminum concentration of (1.0 wt% ). If after (43 h) the concentration of copper is (0.55 wt%) at a position (4.0 mm) below the surface. What is the diffusion coefficient of copper in aluminum for the treatment conditions. z erf(z) 0.6778 0.70 0.75 0.7112 0.80 0.7421 0.85 0.7707 0.90 0.7970
On a hot humid summer day, the air can be considered saturated steam at 950C. If you were to take an ice-cold beverage (40C) from the cooler, you would notice drop-wise condensation on the side of the can forming. What is the condensation heat transfer coefficient for the cold can? Assume the can is 12-cm tall and has a diameter of 8-cm.
At approximately what temperature (in Kelvin) would a specimen of an alloy have to be carburized for 2.0 h to produce the same diffusion result as at 760°C for 13 h? Assume that values for Do and Qd are 1.3 × 10-4 m²/s and 135 kJ/mol, respectively. T= i K
At approximately what temperature (in Kelvin) would a specimen of an alloy have to be carburized for 2.1 h to produce the same diffusion result as at 920°C for 14 h? Assume that values for Do and Q are 3.7 x 10 m/s and 156 kJ/mol, respectively. T- K
Question 1: The PV diagram shown below applies to 2.1 moles of an ideal diatomic gas. (a) (b) Calculate temperature at all points Calculate the heat transferred along paths AB, BC, CD and, DA. (atm) 40 A D V (m') 0.01 0.05 Question 2: Consider an engine with efficiency of 25%. How much must the temperature of the hot reservoir increase, so that the efficiency increases to 50%. The temperature of the cold reservoir remains at 5°C