Task 1 The Data: - Clearance volume of 70 cm3, the bore of cylinder is 130 mm, the stroke of compressor is 70 mm, the measured low and high pressures are 120 and 700 kPa, respectively, the volume before and after compression are 900 and 250 cm3, respectively. 1. Determine the volumetric efficiency of a reciprocating compressor 2. Calculate the isothermal and polytropic work of a reciprocating compressor 3. Evaluate the isothermal efficiency

Q: D1/ The folle and a fixed r blade speed angle of the fa factor for all Using a suitat (i) Developed…

A: INTRODUCTION : Steam turbines are the prime movers in which the heat energy of the steam is…

Q: running and delivering air at 12

A: Given: t=12 minPmax=180 PsiPmin=155 PsiQr=25 scfmQc=0

Q: 1 is 5MPA, and the setting pressures of the valve 2 is 3MPA. Please answer the following questions:…

A: We are to determine the pressure in the line AB

Q: 2. Areciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079…

A:

Q: Q2 An automotive engine has a bore of 90 mm; the stroke is 110 mm; and the length of the connecting…

A:

Q: 6. Steam enters a pressure reducing valve at a pressure of 2000 kPa, dry saturated. It is throttled…

A:

Q: A single stage single acting air compressor with runs at speed 600 rpm. It has a polytropic index of…

A:

Q: Q2/ The compression ratio of a diesel engine is 20, and cut-off occurs at 5% of he stroke. Calculate…

A:

Q: For a centrifugal compressor rotating at 2500 rpm, find the compression ratio for the following…

A: Given that, Ta0=300 K,N=2500 rpm,ηst=0.85rb=0.55,ra=0.015,Q=1.25 m3/sec,βb=60°t=0.15 m,   Determine…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.