Take into account that each user needs 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate on an 8 Mbps connection with a probability of at least 0.9? What is the statistical multiplexing benefit in this case?

Take into account that each user needs 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate on an 8 Mbps connection with a probability of at least 0.9? What is the statistical multiplexing benefit in this case?

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Related questions

Q: How long does the asynchronous transmission of a 150 KByte (1 KByte = 1024 bytes) file take via a…

A: Solution:-- 1)The given question has required for the solution which is to be provided as the…

Q: what is the total latency for a frame of size 5 million bits that is being sent on a link with 10…

A: Link Length = 2000 Km = 2000 * 103 m Light speed inside the link = 2 * 108m/s Frame size is 5…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: Let's say each user has a 500 kbps need and is online for just 25% of the time. With packet…

A: Answer:-

Q: work that transm (108 bits per se ble with no repea ере required for this at is the signal s

Q: factor in the delay of a store-and-forward packet-switching system is how long it takes to store and…

Q: For a 10 Mbps Ethernet with 100 stations connected to it has 50 % efficiency. Velocity of…

A: The Answer is in Below Steps

Q: If each packet is 50KB and the transmission rate between sender and receiver is 1Gbps with a…

A: Transmission time = 50KB/1Gbps = 50*1024*10-9 = 51.2 *10-6 sec Propagation time = 20ms = 20000 *10-6…

Q: Consider sending real-time data from Host A to Host B over a packet-switched network. Host A takes…

A: Given: Real-time data is being sent from Host A to Host B over a packet-switched network. Host A…

Q: Suppose that there are three inter-media nodes between Host 1 and Host 2, and the transmission rate…

A: Given that, Transmission rate or Band width= 4.096 Mbps End to end circuit establishment time= 0.5…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: Find the throughput of this system, expressed in terms of packet/slot

A: Formula for throughput for slotted ALOHA is S(threshold) = G*e^-G Where G is the number of…

Q: In a pure Aloha network with G = 1/2, how is the throughput affected in each of the following cases?…

A: Throughput for pure ALOHA: The maximum throughput for pure ALOHA is as follows: Here, G refers to…

Q: Assume that the propagation speed in a coaxial cable is 2.108 m/s a. Packets are transmitted using…

A: We are considering the alternative bit protocol for packet transmission over a full-duplex coaxial…

Q: Assume that each user demands 500 kilobits per second and is only active 25% of the time. How many…

A: Explanation: The first step is to learn about statistical multiplexing gain. Switching systems in…

Q: A data channel at 5 Gbps is shared by two users. Assume that each user is transmitting at 2.5Gbps…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107…

A: Given: -> Transmission speed or bandwidth = 107 bits/sec -> Data packets size = 400 bytes…

Q: All links in the path between source and destination have a transmission rate of 10 Mbps. Assume…

Q: Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we…

A: Statistical multiplexing gain is performed by switching systems in communication networks that merge…

Q: 200 nodes are connected to a 1,500-meter length of coaxial cable. Using some protocol, each node can…

A: The answer is as follows:-

Q: What is the total delay (latency) for a frame of size 5 million bits that is being sent on a link…

Q: Dnetwork running at 1Mbps ignal speed in the cable is 2 would be

Q: We define data link layer communication efficiency as the ratio between a packet transmission time…

A: The complete answer is given below.

Q: What is the length of a bit in a channel with a propagation speed of 2 x 108 m/s if the channel…

A: The solution to the given problem is below.

Q: You are designing the Wi-Fi for a classroom of 20 students and all students are using Wi-Fi at the…

A: The given information is, The number of students is 20 The protocol efficiency is 40% = 0.4% The…

Q: an asynchronous 8 bit transmission using a UART (8051), the crystal in use is 22.1184 MHz. The…

A: It is defined as Universal Asynchronous Receiver Transmitter. It is a hardware peripheral that is…

Q: CD network running at 10Mbps over signal speed in the cable is 106 km/s 500 bytes, then what is the…

Q: What is the delay of sending a data file from a source station to a destination station? Suppose…

A: Here the total delay for sending file from source to destination => Transmission delay +…

Q: Let's pretend every user has a need for 500 kbps and is only online for 25% of the time. Using…

A: Introduction Statistical multiplexing is a technique used by packet-switching networks to…

Q: 200 nodes are connected to a 1,500 metre length of coaxial cable. Using some protocol, each node can…

A: Given; 200 nodes are connected to a 1,500 metre length of coaxial cable. Using some protocol, each…

Q: Consider building a CSMA/CD network running at 1 Gbps over a 1km cable with no repeaters. The signal…

A: Given that, Bandwidth= 1 Gbps Length of the cable= 1 km Speed of the signal= 200000 km/sec

Q: For example, let's say each user needs 500 kbps and is only active 25% of the time. In order to…

A: Multiplexing is a method of combining and transmitting several data streams over a single channel.…

Q: Assume that each user requires 500 kbps and is only active 25% of the time. How many users can we…

A: Answer Statistical multiplexing gain is performed by switching systems in communication network that…

Q: A signal in a network has a propagation velocity of 1.77x10' m/s and a delay of 4.3 us introduced by…

A: Given that, Velocity= 1.77*108m/s Delay of repeater= 4.3 * 10-6 sec Round trip delay including three…

Q: The minimal frame size in a CSMA/CD network with a data throughput of 10 Mbps is discovered to be…

A: The answer is

Q: What is the length of a bit in a channel with a propagation speed of 2 x 10° m/s if the channel…

A: The following is the formula for the calculating the bit-length using bandwidth and propagation…

Concept explainers

Fundamentals of WAN

A collection of networks and/or local area networks (LAN) which communicate with each other is called a wide area network (WAN). A telecommunication network is extended over the geographical area for the basic computer network purpose (by connecting all smaller networks). From any part of the world, WAN allows communication and sharing the data between devices.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Let's say each user has a 500 kbps need and is online for just 25% of the time. With packet switching, how many people can we accommodate on an 8 Mbps connection with a probability of at least 0.9? How much of an improvement does statistical multiplexing make in this case?
Let's pretend every user has a need for 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate with a probability of at least 0.90 on a connection capable of 8 Mbps? What benefit does statistical multiplexing have in this case?
A signal in a network has a propagation velocity of 1.77x10" m/s and a delay of 4.3 us introduced by each repeater. If the round trip delay for two computers at either end of a link that includes three repeaters is 52.92 us, calculate the length of this link? Express your answer in kilometers.
I need the answer as soon as possible
What is the transmission time of a packet sent by a station if the length of the packet is 1 million bytes and the bandwidth of the channel is 200 kbps? We need to send 300 kbps over a noiseless channel with a bandwidth of 40 kHz. How many signal levels do we need?
Give unique answer only. Do not use AI or plagiarized answer.
Assume that each user demands 500 kilobits per second and is only active 25% of the time. How many people can we multiplex onto an 8 Mbps connection using packet switching with a probability of at least 0.9? What is the statistical multiplexing advantage in this scenario?
200 nodes are connected to a 1,500-meter length of coaxial cable. Using some protocol, each node can transmit 50 frames/second, where the average frame length is 2,000 bits. The transmission rate at each node is 100 Mbps (where 1 Mbps = 1,000,000 bps). What is the efficiency of this protocol?
200 nodes are connected to a 1,500 metre length of coaxial cable. Using some protocol, each node can transmit 50 frames/second, where the average frame length is 2,000 bits. The transmission rate at each node is 100 Mbps (where 1 Mbps = 1,000,000 bps). What is the efficiency of this protocol?
Consider building a CSMA/CD network running at 10Mbps over a cable with no repeaters. If the signal speed in the cable is 106 km/sec and minimum frame size is 1500 bytes, then what is the cable length (km)?
i need the answer quickly
In an asynchronous 8 bit transmission using a UART (8051), the crystal in use is 22.1184 MHz. The required Baud rate is 19200. What is the minimum time to transmit a packet containing 124 bytes? Give the answer in ms.