Answered: T y M x Z

Engineering

Civil Engineering

T y M x Z

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the principal stress, the maximum in-plane shear stress, and average normal stress. Specify the orientation of the max stress element in each case. Solve the question using Mohr Circle. (Picture Attached) σx = 60psi σy = 120psi τxy = 30psi
Plane AB is under pressure and Plane AB has an angle = 30 degrees to sigma = 50 nPa.a. Determine the equations used to calculate the normal and shear stress in the plane ABb. Draw a normal vector sketch on the plane AB and the angle formed between the normal vector andc. Calculate normal stress and shear stress in plane AB (Round up to 4 digits after comma)d. Plot the point normal stress and shear stress plane AB on the Mohr Diagram sketch.
Question 1 Find the state of of stress for the element in Figure Q1 inclined by 30° counter clockwise by using: a) Equation Method b) Mohr's Circle Method 60 MPa Txy = 20 MPa 90 MPa Figure Q1
Consider a point in a structural member that is subjected to plane stress. Normal and shear stress magnitudes acting on horizontal and vertical planes at the point are S=2 ksi, Sy=20 ksi, and Sy = 33 ksi. (a) Draw Mohr's circle for this state of stress. (b) Determine the principal stresses and the maximum in-plane shear stress acting at the point () Show these stresses on an appropriate sketch (eg, see Fig. 1215 or Fig 12.16). (d) Determine the absolute maximum shear stress at the point. Sy Part 1 Calculate the average normal stress and determine the radius of Mohr's Circle. Then draw Mohr's Circle for this state of stress. Answer ksi ksi
Solve it correctly
An element in uniaxial stress is subjected totensile stresses σx = 57 MPa, as shown in the figure.Using Mohr’s circle, determine the following.(a) The stresses acting on an element oriented at anangle θ =-33° from the x axis (minus meansclockwise).(b) The maximum shear stresses and associatednormal stresses.Show all results on sketches of properly orientedelements.
Consider a point in a structural member that is subjected to plane stress. Normal and shear stress magnitudes acting on horizontal and vertical planes at the point are Sx = 40 ksi, Sy = 17 ksi, and Sxy = 10 ksi. (a) Draw Mohr's circle for this state of stress. (b) Determine the principal stresses and the maximum in-plane shear stress acting at the point. (c) Show these stresses on an appropriate sketch (e.g., see Fig. 12.15 or Fig. 12.16). (d) Determine the absolute maximum shear stress at the point. Sxy Sx Answer: (a) Draw Mohr's Circle for this state of stress. (b) Op1 = ksi Op2 = i ksi Tmax in-plane i ksi
The triangular plate is fixed at its base, and its apex A is given a horizontal displacement of 5 mm. Calculate the shear strain, Yxy, at A. Also, calculate the average normal strain & along the x' axis. 800 mm 45% 45° 800 mm 5 mm
Q1) A stat of stress is specified in Figure. By using Mohr's circle determine the normal and shearing stresses on the principal plane, and sketch the results. 18 MPa 60 MPa 15 MPA
n=8