2:334G+ ull 39%SITUATION 5 – 8: Shown in the figure is anon-concurrent force systemY300 bs.500 Ibs1'1'A200 Ibs220 IbsBX380 Ibs.150 Įbs150 Įbs5) Determine the magnitude of the resultantforce. *523.119 Ibs591.112 IbsO 529.113 lbs531.219 IbsOther:6) Find the moment of the resultant at pointO.1969.298 Ibs*ft1298.969 Ibs*ft

Answered: Image /qna-images/answer/4a1da047-0c63-4730-8341-0a2f86392f2a.jpg

Answered: syster Y 300 Ibs 500 Ibs 1' 1' A 200…

Engineering

Civil Engineering

syster Y 300 Ibs 500 Ibs 1' 1' A 200 Ibs 220 Įbs 380 Ibs 150 Įbs 150 Įbs B.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The 14-Mg truck drives onto the 303-Mg barge from the dock at 16 km/h and brakes to stop on the…

A: Given data : Mass of truck (MTruck)=14 MgVelocity of truck (VTruck)=16 Km/hMass of barage (MBarage…

Q: Load factor for a single flight can be determined by dividing the number of passengers by the number…

A: Load factor for a single flight can be determined by dividing the number of passengers by the number…

Q: what are the various methods used b traction control to eliminate wheel spin?

A: The various methods which are used traction control to eliminate wheel spin:- Application of…

Q: An airport has 4 gates which are available for all the airesaft. It serves three classes of aircraft…

Q: QUESTION 7 hat is the braking distance (ft) when the design speed is 65 mph, assuming the AASHTO…

A: Reaction time(t)= 2.5 sec Design speed V= 65mph Deceleration rate= 11.62 ft/ s2

Q: We want to build a depot in a city, the depot will be supporting some different distributor. The…

A: Given,

Q: Match the following: I 47 Number of subtasks that a driver needs to perform Number of classes of…

A: Highwau Capacity Manual (HCM) is a set of guidelines framed by the government that helps to compute…

Q: 50 100 100 50 h i O None of the above 75 * g 75 a b d 75 For rupture of the net section, what factor…

Q: QUESTION 8 When describing operating conditions, a level of service C is better than a level of…

A: Solution:- Given:- It is asked when operating conditions a level of service C is better than a level…

Q: Refers to irregularities in the pavement surface that affect the smoothness of the ride.Blank 1…

A: SMOOTH SURFACE is a surface defect that refers to the irregularities in the pavement surface that…

Q: Manufacturers use a to express percentage of reduction in rated vehicle power at various altitudes.…

A: Deduction Factor: The thrust deduction factor, (generally represented by t) is obtained from the…

Q: Drawing figures to show N60E，S15E and S30W

A: Draw the figure of N60E.

Q: 25 - Which rail vehicles do not use axle brakes? A) Locomotives B) Subway vehicle C) EMU D)…

A: The rail locomotive, EMU, Passenger vehicle and DMU all these uses axle brake for their braking…

Q: he wireframe below shows each of the sequences, relationships, and durations of the activities. It…

A: where D = Duration ES = Earliest start EC Earliest close LS = Latest start LC= Latest close

Q: in this phase, the driver acquires sufficient information concerning the object or condition…

A: To Determine Which of the given option is correct regarding perception reaction time (PRT).

Q: A +2% grade intersects with a -1% grade at station (535+24.25) at an elevation of 300 ft. If the…

Q: The hourly passenger volume is expected to be 8,750. The transit center is being design with 6, 2.5…

Q: 13. Design a short circular column to carry Pu = 500 kips and Mu = 160 ft-k. Assume f = 4000 psi and…

A: Since the question number that has to be attempted is not specified, so the solution for question…

Q: slope has a slope face dipping at an angle of 60 degrees. A bedding plane dipping 25 degrees in the…

A: Given data in question Height of slope Unit weight Angle of internal friction Height of crack…

Q: Discuss the circumstances under which design exception would mitigate/minimize the impact on safety.…

A: Mitigation strategies for design exemptions is prepared for providing designers with practical…

Q: A technique used to provide more balance between motorized and non-motorized users on local and…

A: Vehicles are very used for transferring people and goods to another place. The amount of pollution…

Q: Exit 63 of I-90 includes a tight loop ramp with a radius 250 ft. The advisory exit speed is 30 mph.…

A: Solution: Given: Radius: R=250ft Speed V=30mph As per AASHTO DESIGN MANUAL FOR ALIGNMENTS: For…

Q: True or False? Pallet truck is a piece of material handling equipment that allows the operator to…

A: True:- A pallet truck can be defined as a device that can greatly facilitate moving and lifting…

Q: FAR/AMT Part 65 According to FAR Part 65, what are the privileges and limitations of the Airframe…

A: Airframe rating:It is issued to repair stations for the maintenance and the alterations on…

Q: Q7. PSI is: a) based on panel ratings b) not based on panel ratings c) determined as a surrogate for…

A: Answer 7 The present serviceability index (PSI) is based on the original AASHTO Road Test PSR. Hence…

Q: A 6 lane highway (3 lanes in each direction) has 11 ft wide lanes, 8 ft wide shoulders, 50 degree…

A: Given, Design speed = 60 mph Central deflection = 65o

Q: why can u get the 127?

Q: Answer question 3-9.Hint – Do not create a route which passes through the bridge (lower right side)…

A: In a solid waste collection process, truckrouting is an important aspect to minimizethe total…

Q: was claiming that he followed the posted design speed at 80 kph (running speed%-68 kph) and…

A: use ssd formula

Q: The 19-Mg truck drives onto the 278-Mg barge from the dock at 25 km/h and brakes to stop on the…

Q: ILLUSTRATIVE EXAMPLES 1. A grade of 4,2% grode intersech a grode of +3.0% at Station 11 + 488.00 of…

A: Highway planning includes the assessment of current and future traffic volumes on a street…

Q: HW2: OFFS on Multilane Highway O Four lane undivided multilane highway O Posted speed limit-D50mi/hr…

A: Given data- 4 Lane undivided highway. Posted speed limit = 50 mph Lane width = 11 ft Right shoulder…

Q: Describe about the importance of CFD in the Rail Industry

A: The engineer can use a variety of techniques, including numerical simulation, laboratory (wind…

Q: Which test is NOT introduced by Strategic Highway Research Program? O Viscosity at 135 C Rotational…

A: SHRP is a five-year program to improve the highway system and reduce the higher cost for highway…

Q: Question 3 2 pt It is a basic type of structure often used in buildings and are composed of beams…

A: Frames are frequently used in buildings are composed of beams and columns that are either pin or…

Q: Determine the area of the moment diagram of the structure

A: Moment equation isMx=-Mso diagram is shown below

Q: A driver hit a pedestrian resulting in minor injuries. He was claiming that he followed the posted…

A: Given data, Stopping sight distance SSD = 80 m Design speed V = 80 kmph Running speed Vr = 68 kmph…

Q: 19 - What is the most important purpose of using a reclining train? A) to prevent wear on the wheels…

A: The rails are inclined at 1:20, to minimize the rail spreading effect. They are tilted slightly…

Q: Q.30 For a certain rotary, the practical capacity was 2500 veh/hr, when weaving ratio was 0.45. Over…

Q: due to cost and right of way constarints rv is determined to be 890 ft. superlevation is 12% what…

A: Given; Radius(R) = 890 ft. superlevation(e) = 12% = 0.12

Q: Problem 5-2 Determine the values and draw the diagrams for shear force (/mech/sf.htm) and bending…

A: To find the shear force and bending moment diagram-

Q: main span ground anchoroge typical (main spon' 11 (0) (b) (c) (0) (e)

A: Suspension bridge Bridge in which span weight is supported by suspended cables. The load carrying…

Q: There are five (5) types of road classification in Malaysia. You shall generally describe the type…

A: Road development has been underway in Malaysia since before the country's independence. Before 1957,…

Q: In .... mode, cursor movement is constrained to the horizontal or vertical direction relative to the…

A: e)Ortho In Ortho mode, cursor movement is constrained to the horizontal or vertical direction…

Q: Draw an arrow diagram for the following activities. Show all necessary dummies, but do not include…

Q: For a peak hour volume of 840 vehicles, within which the peak 15-minute volume is 244 vehicles, the…

A: Peak hour volume ,V = 840 veh15 -minute volume , V15= 244 veh

Concept explainers

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.

Question

2:33
4G+ ull 39%
SITUATION 5 – 8: Shown in the figure is a
non-concurrent force system
Y
300 bs.
500 Ibs
1'
1'
A
200 Ibs
220 Ibs
B
X
380 Ibs.
150 Įbs
150 Įbs
5) Determine the magnitude of the resultant
force. *
523.119 Ibs
591.112 Ibs
O 529.113 lbs
531.219 Ibs
Other:
6) Find the moment of the resultant at point
O.
1969.298 Ibs*ft
1298.969 Ibs*ft

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

When investigating an accident, noting weather conditions would be part of which procedure? O Follow-up O Securing the scene Interviewing witnesses O Surveying the scene
Where does the Trucks are also commonly used?
QUESTION 1 The hourly passenger volume is expected to be 8,750. The transit center is being design with 6, 2.5 ft doors. What is the expected level of service of the doorways? O A O O CO Ов OO F
9:38 1 A 1bctnajaf.com Q P Flag question Select the correct answer using the following slab: 3m 6m B3 B1 3 B5 В4 Floor slab Select one: O a. Panel 1 is two-way, panel 3 is one- way, panel 2 is two way O b. Panel 1 is one-way, panel 2 is two- way, panel 3 is one way c. Panel 2 is two-way, panel 3 is two- way, panel 1 is one way d. Panel 3 is two-way, panel 2 is two- way, panel 1 is one way e. Panel 2 is two-way, panel 1 is two- way, panel 3 is one way Previous page Next page 6.4m 6.4m B6 B2
V. What is the expected travel speed on a freeway at 1300 pc/h/In and FFS of 75 mph? What is the expected travel speed on a multilane highway at 1400 pc/h/ln and FFS of 55 mph? VI.
25. Describe the importance of computational fluid dynamics (CFD) in the Railway Industry.
This a highway design course and the books ISBN:13-978-0-495-43853-3. It is just like example 5.4 please help quick. MY HW IS DUE IN THE NEXT HOUR.
13. The B767-322ER aircraft has 88 more seats than the B767-323ER aircraft. The B767-332ER has 32 fewer seats than the B767-323ER aircraft. If their total number of seats is 332, find the number of seats for B767-332ER aircraft. Express your answer in whole number.
Enumerate traffic signages of the following five in Regulatory Signs five in Informative Signs 10 in Warning Signs
(1). Determine the maximum allowable overall gross weight of the WB-109D Design Vehicle. (2). Determine the maximum allowable overall gross weight of the WB-40 Design Vehicle.
FOR ALL PROBLEMS, DETERMINE THE AFD, SFD, AND BMD MAKING SURE To SHOW AL WORK REQUIRED To OBTAIN EACH DIAGRAM. 2 kip B 20 204 200 lb. ft. 200 Ib. ft. ET 15' E
3. A pick up truck that is 5000kg is moving at 5m/s East and it collided with a 20000kg car moving at 30m/s in a direction 30degrees South of West. After collision, the two vehicles remained tangled together. With what speed and in what direction does the wreckage begin to move?