Suppose that a bus has 16 data lines and requires 4 cycles of 250 nsecs each to transfer data. The bandwidth of this bus would be 2 Megabytes/sec. If the cycle time of the bus was reduced to 125 nsecs and the number of cycles required for transfer is doubled, what would the bandwidth of the bus? -lect one: a.2 Megabytes/sec b.1 Megabytes/sec c.4 Megabytes/sec d.8 Megabytes/sec

Q: Why is a serial bus better than a parallel bus for data transfer? What are the drawbacks of serial…

A: A bus is a system that allows data to be transferred from one location to another within a computer…

Q: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: a. The size of an output frame in bits is as follows : Size of an output frame = Number of sources +…

Q: In terms of computational and memory overhead, do you like asynchronous or synchronous buses? a bus…

A: Buses:    Synchronous and asynchronous buses vary in terms of computational and memory overhead.…

Q: DMA transfers 8 bits in one CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.4%…

A: The Answer is

Q: is to be connected to a high- definition video card that is supporting a 1920x1080 true-color (3…

A: The data rate as, = (Number of frames per second) * (Number of pixels per frame) * (Number of bytes…

Q: A byte-oriented (8bit/timeslot) TDM communication link with a bandwidth of 300HZ – 4KHZ is used to…

A: answer is 32kbps

Q: Given that a bus has 64 data lines and requires 4 cycles of 125 nanoseconds each to transfer data.…

A: Given data, the system bus has 64-bit data lines means it can transfer 64bit of information in one…

Q: DMA transfers 8 bits in 1 CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.7%…

A: Given processor speed : 2Mhz 0.7% of processor cycles is used for DMA. We need to determine data…

Q: A flash memory of 16 Gbyte is used to store PCM voice data. Suppose that a CT voice signal is…

A: How many minutes of the voice signal can be stored (as PCM data) in this memory? For 12-bit, we…

Q: the pros and cons of using a serial bus to send information instead of a parallel bus

A: What are the pros and cons of using a serial bus to send information instead of a parallel bus?

Q: Given a system with 2 memory channels and 4 DRAM DIMMs (2 DIMMs per channel), each DIMM has: • 1…

A: Addressing in physical and virtual memory spaces refers to the mechanism by which a computer's…

Q: Consider a computer which uses virtual addressing with 32 bit addresses and a two level page table.…

A: The size of the pages in this virtual addressing scheme can be determined by looking at the number…

Q: Data Communication & Computer Network Suppose that Jon's and Jenny's computers are connected by an…

A: Here I uploaded handwritten solution for u Hope it helps u

Q: Consider a system in which bus cycles takes 500 ns. Transfer of bus control in either direction,…

A: Given Time for Bus cycles = 500 ns Transfer of bus control = 250 ns I/0 device data transfer rate =…

Q: Consider a 32-bit machine where four-level paging scheme is used. If the hit ratio to TLB is 98%,…

A: Introduction :Given ,4 level paging architecture hit rate of TLB = 98%TLB time = 20 ns main memory…

Q: What are the pros and cons of using a serial bus vs. a parallel bus to send data?

A: Introduction: A serial bus is a type of bus technology that transmits data one bit at a time over a…

Q: Consider a full-duplex 256 KbF The data frames carry a useful data frames have 320 bits of he What…

A: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay.The data…

Q: For a 512k x 32 memory system, how wide does the incoming address bus needed to be in order to…

A: Here is the explanation about the width of the address bus:

Q: A common bus in a computer connects 16 source registers (each register is 32 bits) and one memory…

A: Given: What is the minimum number of multiplexers required? _____ What is the minimum number of…

Q: 4. Assume that it takes 100 ns to access memory and when a page number is in TLB, to access a…

A: Answer : Effective memory access time = h (t + m) + (1-h) (t+m+m) h = hit ratio = 95 / 100  t =…

Q: Suppose the system is about to transfer the value inside register "A" to register "X", then, the…

A: Answer to the above question is in step2.

Q: DMA transfers 8 bits in 1 CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.6%…

A: According to the given question, the answer solved below is correct and with explanation.  It is…

Q: For a 512k x 32-bit memory system, what is the capacity in bytes? Give the exact number. Remember…

A: The above question is solved in step 2 :-

Q: Consider a system with a cell size of 128 bits that needs to be able to address 103 MB of memory.…

A: Data Given:- Cell size = 128 bits Memory size = 103 MB     Data to be finded out:- Number of address…

Q: which address lines are generating the selection line A1 A0?  A. None  B. Selection lines A1 A0…

A: Assembly level language is a low-level programming language, that's used to communicate directly…

Q: Please discuss two pros and cons of using a single bus as a shared communication protocol between…

A: A processor (CPU) is the logic circuitry that responds to and processes the basic instructions that…

Q: Q2: A gaming device has to transfer a high definition 1280 x 720 x 3 video frame @ 30 frames/sec.…

A: In the world of gaming, smooth and high-quality visuals are essential for an immersive experience.…

Q: For the sake of efficiency, do you favour synchronous or asynchronous buses, and why? A bus that…

A: Buses are the primary communication channels in computer architecture that transfer data between…

Q: 2. bus capacity Assume a bus is 16 bits wide. The data and address lines are multiplexed, meaning…

A: Given Data : Bus size = 16 bits Data to transfer = 15 MB Bus frequency = 300MHz

Q: Consider a computer system with DMA support. The DMA module is transferring one 8-bit character in…

A: Introduction :given , computer system with DMA support1 char(8 bits) take = 1 clock cyclefrequency =…

Q: Consider an I/O bus that can transfer 6 bytes of data in one bus cycle. Suppose that a designer is…

A: To determine the execution time of this loop, we may use the formula below. ET = CPI × IC × TET =…

Q: Assume a bus is 16 bits wide. The data and address lines are multiplexed, meaning that the bus must…

A: Solution:-

Q: One of the most significant things to explore when discussing data transmission is how the width or…

A: Introduction: According to the information given:- We have to define the data transmission and the…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A:

Q: Our system is using virtual memory and has 48-bit virtual address space and 32-bit physical address…

A: (a) To calculate the number of entries needed for a single-level page table, we need to consider the…

Q: Megabits per second) has 60GB/s (GigaByte p Megabits per second) has 600GB/s (GigaByte Megabits per…

A: Solution - In the given question, we have to find how many MB/s the USB3 has.

Q: Consider a CPU that operates with a data transfer rate of 30 Mbytes/s. The data is transferred…

A: CPU can be defined in such a way that it is used for carrying out instructions of a laptop…

Q: -bit ISA bus that takes six 8MHz clocks per transfer and compare it to a 32-bit PCI bus with a 66MHz…

A: Compute the peak I/O bandwidth of a 16-bit ISA bus that takes six 8MHz clocks per transfer and…

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data…

A: Given: Consider a full-duplex 256 Kbps satellite link with a 240-millisecond end-to-end delay. The…

Q: Suppose that a magnetic disk has an average seek time of 4 ms, a rotation rate of 5400 RPM, a…

A: Your question is about  finding avg. Amount of time to read a single sector  Let's see the solution…