Suppose a student performed a similar standardization titration experiment using the data in the table here. What is the exact concentration of the NaOH solution? The molar mass of benzoic acid is 122.12 g/mol. mass of NaOH (g) 0.400 volume of NaOH solution (mL) 200.00 mass of benzoic acid (g) 0.158 volume of benzoic acid solution 100.00 (mL) volume of NaOH dispensed (mL) 27.84 Select one: 0.0129 M 0.0465 M 0 1240 M

Suppose a student performed a similar standardization titration experiment using the data in the table here. What is the exact concentration of the NaOH solution? The molar mass of benzoic acid is 122.12 g/mol. mass of NaOH (g) 0.400 volume of NaOH solution (mL) 200.00 mass of benzoic acid (g) 0.158 volume of benzoic acid solution 100.00 (mL) volume of NaOH dispensed (mL) 27.84 Select one: 0.0129 M 0.0465 M 0 1240 M

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Consider the titration of 25.00 mL of Sprite with 0.050 M NaOH. Using the following data, determine the citric acid concentration in Sprite (g/L). Take the molar mass of citric acid to be 192.124 g/mol. Give your answer to one decimal place. initial volume (mL) final volume (mL) Buret reading (mL) 1.75 14.32
what is the volume of a NaOH solution added during a titration experiment is the initial buret reading was 12.50 mL and the final buret reading was 37.25 mL?
A chemist needs to determine the concentration of a sulfuric acid solution by titration with a standard sodium hydroxide solution. He has a 0.1886 M0.1886 M standard sodium hydroxide solution. He takes a 25.00 mL25.00 mL sample of the original acid solution and dilutes it to 250.0 mL.250.0 mL. Then, he takes a 10.00 mL10.00 mL sample of the dilute acid solution and titrates it with the standard solution. The endpoint was reached after the addition of 12.42 mL12.42 mL of the standard solution. What is the concentration of the original sulfuric acid solution?
4. A student did not read the directions to the experiment properly and mixed up where to put the NaOH and the HCl solutions. He put the HCl in the buret and the NaOH in the flask. He then added a drop of the phenolphthalein to the solution in the flask. Does the student need to empty out all of the solutions and start over again or can he go ahead and run the titration? Explain qalb ribidw qid edini olddud ris ogrel s znisimos tund entd nousu 5. How many liters of 3.4 M HI will be required to reach the equivalence point with 2.1 L of 2.0 M KOH? 9no vino to beateni nolusius to alsid sigulum ob of insttoqmi ti al VW S
A student needs to dilute a 0.40 M Pb(NO3)₂ solution to make 75.0 mL of 0.16 M Pb(NO3)2. Set up the calculation by placing the values with the correct units into the equation. Then, calculate the volume, in milliliters, of the 0.40 M Pb(NO3)₂ solution that is needed. 75.0 mL 75.0 L Answer Bank 0.40 M 0.16 mL 0.16 M 0.40 mL = mL
An aqueous solution of barium hydroxide is standardized by titration with a 0.180 M solution of hydrochloric acid.If 28.0 mL of base are required to neutralize 26.4 mL of the acid, what is the molarity of the barium hydroxide solution?
Table 1: Titration Data Volume of magnesium hydroxide solution in Erlenmeyer flask Concentration of magnesium hydroxide 0.135 mol/L solution in Erlenmeyer flask Initial volume of nitric acid solution in burette Final volume of nitric acid solution in burette 10.Use the data in Table 1 to answer the folowing (a) Write the balanced chemical equatio. (b) Calculate the molar concentration of nitric acid 20.00 mL (c) Calculate the pH of the acid. 1.06 mL 23.08 mL
An analytical chemist weighs out 0.185 g of an unknown monoprotic acid into a 250 mL volumetric flask and dilutes to the mark with distilled water. She then titrates this solution with 0.2000 M NAOH solution. When the titration reaches the equivalence point, the chemist finds she has added 9.5 mL of NaOH solution. Calculate the molar mass of the unknown acid. Be sure your answer has the correct number of significant digits. g x10 mol
A student is standardizing a sodium hydroxide solution. He used 23.22 mL of NaOH to neutralize 1.227 g of KHP (molar mass 204.22 g/mol). What is the concentration of NaOH in mol/L?
A student weighs out a 1.52 g sample of NH, Cl, transfers it to a 125 ml volumetric flask, adds enough water to dissolve it and then adds water to the 125 ml. tick mark What is the molarity of ammonium chloride in the resulting solution? Molarity [ M
Consider the titration of 25.00 mL of Sprite with 0.053 M NaOH. Using the following data, determine the citric acid concentration in Sprite (g/L). Take the molar mass of citric acid to be 192.124 g/mol. Give your answer to one decimal place. initial volume (mL) final volume (mL) Your Answer: Answer Buret reading (mL) 1.64 14.52
Before performing a titration of vinegar itself, you first had to standardize the solution used to analyze vinegar. i) State the identity of solution used to analyze vinegar (name the compound) and explain why the solution had to be standardized.