Suppose a 10-Mbps Ethernet hub (repeater) is replaced by a 10-Mbps switch, in an environment where all traffic is between a single server and N “clients." Because all traffic must still traverse the server-switch link, nominally there is no improvement in bandwidth. (a) Would you expect any improvement in bandwidth? If so, why? (b) What other advantages and drawbacks might a switch offer versus a hub?

Suppose a 10-Mbps Ethernet hub (repeater) is replaced by a 10-Mbps switch, in an environment where all traffic is between a single server and N “clients." Because all traffic must still traverse the server-switch link, nominally there is no improvement in bandwidth. (a) Would you expect any improvement in bandwidth? If so, why? (b) What other advantages and drawbacks might a switch offer versus a hub?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

In ADSL service, there is a single UTP pair running from the end office switch to the individual household. In cable modem service, the thick coaxial cable in the neighborhood is shared by many subscribers. Yet typically, cable modem service provides faster service to individual customers than ADSL. How can this be? explain simply
Compare the advantages and disadvantages of connectionless protocols vs connection-based systems.
If 10 devices are added to each network constructed with a star, mesh, ring, or bus topology, what modifications would be required to each topology, and which of these topologies requires the most and least changes?
.B If the Network layer is sending a message from A to D via B, it can be sure that a message sent by the Data Link layer from A to B will always correctly get to B, and a message sent from B to D will always correctly get to D. How then is it possible for the Network layer to be unable to correctly deliver a message from A to D?
. Suppose a 10-Mbps Ethernet hub (repeater) is replaced by a 10-Mbps switch, in an environment where all traffic is between a single server and N "clients." Because all traffic must still traverse the server-switch link, nominally there is no improvement in bandwidth. (a) Would you expect any improvement in bandwidth? If so, why? (b) What other advantages and drawbacks might a switch offer versus a hub?
The following network tools that produce a logical topology BUS even though computers have been connected to this tool with a physical topology STAR are .....1. Switch2. Hub3. Router4. Bridge
In the context of a network that makes use of virtual circuits, what does the phrase "connection status information" imply, and what does it refer to? The forwarding database of a switch in a VC network has to be updated at the rate of one connection per millisecond in order to keep up with the switch's creation and deletion of connections (on average).
An Ethernet MAC sublayer receives 1510 bytes of data from the upper layer. Can the data be encapsulated in one frame? If not, how many frames need to be sent? What is the size of the data in each frame?
The Open Systems Interconnection (OSI) Reference Model defines seven layers that describe standards from the physical wire all the way up to the application interfaces on computers. Each layer has a specific function, common among all devices, and a specific way of communicating with the layer above and the layer below in the stack. Answer the following questions: Why is it important to wireless networking to understand the layers of the OSI Reference Model? Fully address the questions in this discussion; provide valid rationale for your choices, where applicable; and respond to at least two other students’ views. use at least two scholarly articles.
Suppose you have a network arranged in a 3D mesh topology with size 30x40x50 on the x, y, and z axes respectively. Assuming a link bandwidth of 6 GB/s, what is the bisection bandwidth of this network? Assume units of GB/s.
Why do we need virtual LANs if several subnets can already be built on a single switch and users connected to various subnets are unable to interact with one another? Use an example from the topology to support your thesis.